热化

The transformation of C-Si-Mn TRIP steel during continuous cooling in two static conditions was studied by dilatometry.

利用热膨胀法研究了C-Si-Mn系TRIP钢在两种静态条件下连续冷却转变时的相变规律，分析了冷却速度、奥氏体化工艺对组织的影响。

The transformation of C-Si-Mn TRIP steel during continuous cooling in two static conditions was studied by dilatometry. The effects of cooling rate and austenitizing process on the microstructure were analyzed.

利用热膨胀法研究了C-Si-Mn系TRIP钢在两种静态条件下连续冷却转变时的相变规律，分析了冷却速度、奥氏体化工艺对组织的影响。

The heat transfer experiments were conducted on dropwise condensation of steam on the surfaces with gradient surface energy.

对空气中水滴在水平梯度表面能材料表面上的运动现象和表面倾角为0°、30°、60°和90°情况下，梯度表面能材料表面上的水蒸气滴状凝结换热进行了可视化实验，研究了凝结液滴的长大、聚并、运动和脱落现象。

Because of the high diffusivity and solubility of oxygen in Ti〓Al, once the oxidation layer loss its protection, oxygen can easily enter into the alloy and thus considerable oxygen contaminated region is formed, which would embrittle Ti〓Al alloys and seriously decrease their thermal stability and high temperature properties.

氧在Ti〓Al基合金中具有较高的固溶度，当表层氧化膜缺乏保护性时，氧得以在合金基体表面部分形成厚度可观的氧污染层，使本身塑性就较差的Ti〓Al基合金脆化，从而严重影响Ti〓Al基合金的热稳定性和高温力学性能。

The treatment group was given Qizhengxiaotong Emplastrum(0.75 g/kg),and the model group and blank group were given normal saline solution(0.5 mL/each)externally for 5 days on 10th day after the establishment of ...

末次给药后测量各组小鼠的痛行为，包括机械性痛觉超敏和热刺激痛觉过敏；将小鼠股骨进行X线摄片，影像学评估骨破坏；用免疫组化法检测各组局灶皮肤组织肿瘤坏死因子α、内皮素-1(ET-1)、白介素-1β(IL-1β)水平及脊髓后角P物质受体、c-fos及GFAP阳性反应神经元的表达。

Using ethyne as source gas, CNTs were successfully synthesized by CVD method. By comparing different synthesis technics, the influences of parameter to the grow of CNTs, such as catalysts, growth time, reaction temperature and ratio of all kinds of carrier gases were investigated. The results showed that the influence of carrier gas, reaction temperature, and the growth time on synthesis of CNTs was significant. In conclusion, a better condition for carbon nanotube growth was obtained. Through analyzing Raman Spectrum of samples, GM and SWNTs' characteristic peak-RBM was indicated.

采用乙炔为碳源、氢气和氩气为载气，利用气相催化热解法在AAO模板上成功的制备出了纳米碳管，用TEM，SEM，EDS，Raman等表征方法研究了生长温度、裂解时间、载气含量和不同催化剂对碳纳米管的石墨化程度、产物形态的影响，指出了单壁碳纳米管的特征振动模式—径向呼吸振动模以及拉伸振动模式G模，缺陷导致的D模，并采用蒸金后的样品进行了场发射的测试，得到了F-N曲线，与理论符合较好。

This β-eucryptite phase begins to dissolve at 1320℃ or above where the tielite (Al2TiO5) is apparently unstable and decomposed to corundum (Al2O3) and rutile (TiO2). Thirdly, in this dissertation, the influence of composition, crystallization temperature, and time on CTE were investigated detailedly.

然后，对制得微晶玻璃材料的热膨胀性能及力学性能与材料组成的关系，成核剂对玻璃析晶性能和膨胀系数的影响，以及晶化温度和时间的关系进行了分析。

The results of DSC show that drastic exothermal reactions take place during the course of heating, which indicates that some new phases are formed.

运用热分析方法研究了一定量的钛粉、碳化硼粉与碳粉的混合粉末在加热过程中的反应情况。

Compared with homo-polymimdes and copolymimdes,PAIs can evidently improve mechanical properties while maintaining excellent solubility,high Tg and thermal stability of fluorenyl cardo polyimides.

与均聚PI，共聚PI相比，PAI在维持芴基Cardo型PI优异的溶解性，高的玻璃化转变温度及热稳定性的同时，明显改善(来源：A60d626BC论文网www.abclunwen.com)力学性能。

Magma source original from remelting of the Dabie gneissic complex-magma intrusion and condensation stage under the extension system-potassic alternation and initial magmatic hydrothermal mineralization stage-meteoric water adding into the middle and latter mineralizing stages.

大别片麻杂岩重熔形成岩浆源—伸展体制下岩浆侵入冷凝阶段—钾化及初始岩浆热液成矿阶段—大气降水加入的中后期成矿阶段。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。