烧结的

The influences of forming solid solution, generating new compound and addition of flux on sinterability, phase-structure and microwave dielectric properties of zinc titanate were analyzed.

对钛酸锌介电陶瓷的改性研究进行了综述，分析了形成固溶体、生成新的化合物和添加助熔剂对钛酸锌陶瓷的烧结性、相结构和微波介电性能的影响。

The results showed that the composite batcher drip nozzle consisting of ceramics drip nozzle and plug had high strength, excellent toughness, abrasion resistance and corrosion resistance, and long service life. It was not easy to fracture while replacing. The new batcher drip nozzle could increase the productivity of production line and decrease the production cost of metal grains when it was used to cast metal grains.

结果表明，由烧结陶瓷加工而成的滴嘴本体及与滴嘴本体配合的塞子两部分构成的组合式定量器滴嘴，强度高，韧性、耐磨性和耐蚀性好，使用寿命长，更换时不断裂，可提高铸造金属颗粒生产线的作业率，降低金属颗粒加工成本。

Calcining method is an efficient approach to improve the quality of bone ash. In this paper, the effects of the calcining temperature on its crystal structure and morphology, the calcination-modification on slurry fluidity and sintering process of bone china bulk were investigated through infrared spectroscopy, differential thermal analysis, X-ray diffractometer and scanning electron microscopy.

对骨胶厂提供的骨灰进行煅烧处理，通过红外、热分析、X射线衍射和扫描电镜等表征手段系统地研究了煅烧温度对骨灰的显微形貌和结构变化的影响规律，以及骨灰煅烧改性对坯体浆料流动性和坯体烧结工艺的影响规律。

The results show that there are two types of pore in the sintered alloy, i.e., one is coarsen pores with diameter more than 30μm, the other is thin pores with diameters less than 10μm. These two types of pore evolve from two voids in green compacts respectively.

研究结果表明：合金中的孔隙主要有2种类型，即粒径为30μm左右的大孔隙和粒径在10μm以下的小孔隙，这2种孔隙分别由生坯中的2种主要间隙在烧结过程中演变而成。

But when used, its powdering, forming and ceramic working should be strictly controlled, so that magnet with high residual magnetism and high coercive force could be made to meet the need for magnetic performance of starters.

在生产中必须严格控制制粉、型及烧结工艺，才能制造出高的磁通密度高的磁场强度的磁体，从而满足摩托车起动电机的电磁特性。

From Australia's superb hot molding and powder metallurgy technology and strict quality control to avoid the domestic general caused by hot-pressing sintering diamond serious carbonation, damage a common problem, with a diamond drill bit than electroplating package insert firmly with the steel body connected to a reliable and never out of the superiority of teeth.

来自澳大利亚精湛的热成型和粉末冶金技术以及严格的质量控制，避免了国内一般热压烧结造成金刚石严重碳化，损害的通病，又比电镀钻头具有金刚石包镶牢固，与钢体联接可靠，永不掉齿的优越性。

The whole sintering process of SHS converter fettling materials can be divided into three steps. The first step is the decomposition reaction of carbonates and sodium nitrate, which is an endothermic reaction. The second step is the SHS reaction, i. e. thermite reaction, the metal of Al reacts with CO〓, O〓, NO〓, Fe〓O〓 to form Al〓O〓. The speed of thermite reaction is very quick, and accompanied with large amount of heat emission and temperature rise. The third step is the reaction of spinels formation. The Al〓O〓 produced by SHS reacts with MgO to form spinels.

整个SHS补炉料的烧结过程分三步进行：第一步为碳酸盐、硝酸钠的分解反应，属于吸热反应；第二步为SHS反应即铝热反应，金属铝粉与CO〓、O〓、NO〓、Fe〓O〓等反应生成Al〓O〓，反应速度很快，并伴随有巨大的放热和温度升高；第三步为合成尖晶石的反应，SHS反应产物Al〓O〓与MgO反应生成尖晶石。

The process of the high energy ball milling,the process of the flan press and the process of the liquid phase sinter was studied. And the influence of those processes to the property of the Mo-Cu alloy was concluded.

本文从工艺上主要研究了Mo-Cu复合粉末的高能球磨工艺、Mo-Cu粉末生坯的压制工艺、液相烧结工艺以及不同的工艺条件对材料性能的影响。

Enough high special surface ares of the powders and a appropriate content of volatiles (from 10% to 15% in weight) in the powders and the essential conditions to cause the powders possessing the excellent self-binding and self-sintering properties.

并认为：足够高的表面积和适当的挥发份含量是生焦粉有良好自粘结和自烧结性能的必要条件。

The composite membranes with different ratio of Al〓O〓 to SiO〓 are composed of amorphous matter or amorphous matter and γ-Al〓O〓 when sintered at 600℃. The composite membrane with mullite composition go thrsought the following phase transition as the temperature rising from 200℃ to 1100℃: amorphous matter and boehmite (200℃)→amorphous matter and γ-Al〓O〓(4001000℃)→mullite and α-Al〓O〓.

经热处理后不同化学组成的复合陶瓷膜由无定形态或者无定形态和γ-Al〓O〓组成，具有莫来石化学成分的复合膜随着烧结温度的升高，其组成分别为无定形态和勃姆石（200℃）、无定形态和γ-Al〓O〓（400-1000℃），并在1100℃时析出莫来石和α-Al〓O〓。

Lugalbanda was a god and shepherd king of Uruk where he was worshipped for over a thousand years.

Lugalbanda 是神和被崇拜了一千年多 Uruk古埃及喜克索王朝国王。

I am coming just now,' and went on perfuming himself with Hunut, then he came and sat.

我来只是现在，'歼灭战perfuming自己与胡努特，那麼，他来到和SAT 。