烧结的

The bonding phase of self-fluxing sinter used before was composed predominately of cuspidine and hyaline, mechanical strength of which as well as their bonding strength with respect to magnetite are rather weak.

自熔性烧结矿的胶结相主要由枪晶石和玻璃体所组成，两者的机械强度都较低，对磁铁矿的相对胶结强度也较小。

When nano-structured TiC and TiN powders accounted for 20wt％ of all the amount of TiC and TiN, the vacuum sintering could densify the cermets completely.

试验结果表明：当纳米TiC、TiN的含量分别为TiC、TiN总量的20％时，真空烧结即可使其达到接近100％的致密度。

The addition of SiCN powder to Sialon increases the glutinosity of glass formed during sintering process by additives and SiO2 film on the surface of Si3N4, and lowers the sintering densities of the samples.

SiCN／Sialon复合材料复介电常数的实部和虚部均随纳米SiCN含量的升高而增大，但是低于预期值，其原因是由于长时间高温烧结时，纳米SiCN结构发生变化，其复介电常数的实部和虚部大幅度下降造成。

In the paper,we introduced main contents and characteristics in the improving design of the 1 # ignitor for ring sintering machine,questions which should be paid attention to in the course of construction,and the effects in the production.

简要介绍了泰钢 1号环式烧结机点火保温炉改造设计的主要内容及特点，施工过程中应注意的问题以及改造后的效

In a series of test campaigns conducted from 2005-2006 in a demonstration plant installed at the sinter plant of the Austrian steel producer Voesalpine Stahl (figure 6), the technical and economical advantages of the Meros process could be verified.

2005到2006年间，在澳大利亚林芝钢厂烧结车间建造的实验厂进行了一些列的实验（如图6），Meros系统的技术和经济优势都得到了验证。

In the first step of the Meros process adsorbents such as specially prepared lignite coke or activated carbon powders as well as desulphurization agents ( sodium bicarbonate or hydrated lime) are injected into the sinter offgas stream at a high injection velocity- exceeding 30m/s- in the counter-current flow direction.

Meros处理系统的第一步就是将吸附剂，诸如特别准备的褐煤焦或者活性碳粉末以及脱硫剂以超过每秒30米的注射速度以逆流方向加入烧结尾气气流中。

ABSTRACT PZT thin films with a composition near the morphotropic phase boundary ﹝ w/w=52/48﹞ were prepared by the sol-gel process, and atomic force microscopy and spectroscopic ellipsometry were utilized to trace the sintering processes.

摘 要 用溶胶-凝胶技术制备了组成在准同型相界点﹝m/m=52/48﹞附近的钙钛矿相PZT薄膜，并运用原子力显微分析与椭偏法测试相结合的方法跟踪了薄膜的烧结过程。

The effects of BN content on the thermal conductivity, hardness and microstructure of AlN-BN composite ceramics prepared by ceramic injection molding and pressureless sintering, as well as the rheological characteristics of the mixtures were discussed.

采用粉末注射成形和无压烧结相结合的工艺制备AlN-BN复相陶瓷，讨论了AlN-BN混合料的流变性能以及BN含量对复相陶瓷热导率、硬度以及显微组织的影响。

In present work, Al〓O〓/Ti Ceramics with several weight percent Ti were made by pre-sintering and pressureless sintering at flow of Ar with Al〓O〓/Ti covered powder.

但是，金属氧化物的使用可能会降低材料的机械性能，以过快的升温速度烧结又有可能导致产品不均匀受热。

The aims of this paper is to obtain Y-TZP materials via low temperature sintering with certain amount of additives added, then prolongate the application area of these materials.

本工作的目的是通过在Y-TZP粉料中加入一定含量的添加剂，低温烧结制备性能较好的Y-TZP陶瓷，拓展其应用范围。

On the other hand, the more important thing is because the urban housing is a kind of heterogeneity products.

另一方面，更重要的是由于城市住房是一种异质性产品。

Climate histogram is the fall that collects place measure calm value, cent serves as cross axle for a few equal interval, the area that the frequency that the value appears according to place is accumulated and becomes will be determined inside each interval, discharge the graph that rise with post, also be called histogram.

气候直方图是将所收集的降水量测定值，分为几个相等的区间作为横轴，并将各区间内所测定值依所出现的次数累积而成的面积，用柱子排起来的图形，也叫做柱状图。