烧结的

In this project, the new building wall material is made with manganese residue after electrolytic dioxide manganese.

本项目是利用电解二氧化锰产生的锰渣加入一定量的粘土等材料混合、搅拌、压制成型经烧结形成的新型墙体材料。

And metallography analysis system was adopted to test the crystalline phase content.

用直接压痕法测量烧结样品的断裂韧性，运用金相图像分析系统进行晶相含量的测定，重点研究粉体粒度和晶相含量对长石瓷断裂韧性的影响。

The results showed the specimens by vacuum sintering had a typical Widmannstatten microstructure, which possessed coarser prior β-grains and secondary platelet α+β-phase, but the alloy had a more microporosity and a lower tensile strength and ductility. After HIP treatment, prior β-grains and secondary platelet α+β-phase became fine and uniform, and the alloy possessed a less microporosity and a higher tensile strength and ductility.

结果表明：真空烧结Ti-6Al-4V合金具有典型的魏氏体组织，其初始的β晶粒粗大，β晶粒内为次生片状α和薄β相片，空隙较多，合金的强度和塑性较低；合金经热等静压处理后，组织明显细化且均匀，空隙很少或几乎没有，从而强度和塑性都有所提高。

The veracity of the mixing ratio affects the quality of the sinter mine. It will also have effects on the process of smelt in the blast furnace.

配料的准确性是决定烧结矿质量最重要的因素，并进而影响高炉炼铁的进行。

The results showed that for 2Y-TZP materials, because of low stabilizer content and small critical transformation size, more tetragonal zirconia could change into monoclinal, better effect of transformation toughening operated, hence higher fracture toughness was obtained.

晶粒尺寸、稳定剂含量对氧化锆陶瓷相变增韧效果具有重要的影响。2Y-TZP材料由于稳定剂含量低，临界相变尺寸也小，在低温烧结条件得到细晶粒情况下，断裂过程中有更多的晶粒达到或超过临界相变尺寸，因而具有更高的断裂韧性。

It was found that the thickness of the film can improved with adding some mucilage glue.

增粘剂的加入可提高一次涂膜的厚度，低温烧结可在金电极上得到表面光亮的二氧化硅玻璃薄膜，绝缘性能良好。

Densification process as well as formation mechanism of mullite was studied and discussed, and special attention was paid to the effect of mullite seeding on the reactionsintering mechanisms.

研究了反应烧结过程中致密化和莫来石的形成机制，重点讨论了莫来石晶种的引入对莫来石形成机制的影响。

The results show that the crystalline phase of support is consist of corundum and mullite and the microstructure of support can be adjusted by using different sintering additive.

结果表明支撑体的微观结构可通过采用不同的烧结添加剂控制，构成支撑体的晶相为刚玉相和莫来石相。

The calcination of the catalysts at high temperature may easily result in theformation of tetrahedral structure Mo species before sulfidation,and decrease theamount of octahedral coordination Mo species.The sinter and loss of the activecomponents would take place during the calcination at overhigh temperature. Meanwhile,the active component could react with support,thus made the activecomponents entered into support bulk phase.

7催化剂在硫化前进行高温焙烧，容易形成四面体结构的钼物种，而八面体配位钼物种减少，且过高的焙烧温度易使活性组分发生烧结，同时可能发生活性组分的流失或与载体发生反应进入载体体相。

The raw material of this product adopts building waste and ceramic waste, by adding a series of additives to promote its performance. Through twice charging, pressing, sintering in high temperature, the color penetrable bricks are made.

本产品原料采用建筑工程时产生的建筑废料和陶瓷生产时产生的陶瓷废料，通过添加一系列改善性能的添加剂，经二次布料，高温烧结后制成彩色透水砖。

I am accused of being overreligious," she said in her quiet, frank manner,"but that does not prevent me thinking the children very cruel who obstinately commit such suicide.""

客人们在卡罗利娜·埃凯家里，举止就文雅一些，因为卡罗利娜的母亲治家很严厉。

Designed by French fashion house Herm è s, this elegant uniform was manufactured in our home, Hong Kong, and was the first without a hat.

由著名品牌 Herm è s 设计，这件高贵的制服是香港本土制造，是我们第一套不配帽子的制服。