烧结的

The challenges of these material are screen printing and sintering process. Many long fine patterned lines should be printed on a large piece of glass and sustain a smooth, continuous and uniform line pattern; on the other hand, the sintering process is rapidly increasing sintering temperature to a peak in a short time, then cooling the glass substrate to low temperature under a short time shock.

汽车钢化玻璃除霜加热线，是采用在玻璃基板上印刷银浆，在玻璃的钢化热处理过程中完成银导体膜的烧结附着，由于烧结时间短(总时间250sec)和温度骤变条件相当苛刻，要求导电细线无脱落断线，在功率满足要求的情况下，与外蓄电池连接的电极的焊接及附着强度也有具体要求，另外耐候性及耐擦洗等后步要求也较苛刻。

Investigation of the ballistic propagation of acoustic wave through two almost same sintered samples with face - centered cubic lattices indicates that there is a band gap range respectively in two order quasi - homogeneous media.

研究超声波经过两个烧结样品的行为。两个烧结样品为有序的面心立方结构，它们的结构几乎相同。研究表明：在两个有序的准均匀的介质中分别有一个禁带区域。

To provide methods for the study of laser rapid prototyping system based on polar coordinates, especially it apply to featheredge spheroid parts; The make-up of SLS rapid prototyping system based on polar coor.

本文基于激光变长线快速成型系统和激光点扫描快速成型系统的特征，激光选区烧结成型工艺因其适用于中小型零件，且选用材料广泛，对其研究具有现实意义；为基于极坐标系的激光快速成型系统的研究提供了素材，特别是对于薄壁回转体零件具有较强的针对性；详实地讨论了基于极坐标的激光选区烧结系统的组成。

In order to improve sintering raw mix size composition, increasing sinter TFe content and reducing solid fuel consumption,the industrial sintering test with all burnt lime to replace the limestone in BaoGang Iron Making Plant was conducted, and anticipative effect was gaine

为了改善烧结混合料的粒度组成、提高烧结矿TFe含量、降低固体燃耗，包钢炼铁厂进行了用全生石灰取代石灰石的工业试验。本文介绍了湘钢二烧使用生石灰的情况以及生石灰配消系统的改造情况，并提出了进一步完善的措

In order to accurately determine the forming temperature and time of the sintered wick and to offer methods for the fixation and extraction of the mandrel as well as the infilling of copper powders, this paper analyzes the forming mechanism of copper powders in the wick and investigates the manufactu-ring process of the capillary structure of the sintered wick in the micro heat pipe.

文中分析了铜粉颗粒在吸液芯中的成型机理，探讨了烧结式微热管吸液芯毛细结构的制造工艺，解决了吸液芯成型温度与成型时间的确定，以及烧结时芯棒的固定、抽出与铜粉颗粒的填充等相关问题。

That if the process can produce much liquid phase during the sintering, and which can become into completely-crystal needle-shap or aborization or bar-shap calcium ferrite instead of glass in the cooling process; if the magnetite is interweaved by the caking into the melting corrosion structure, the granular structure or the eutectic structure instead of exiling in the massive isolation; if the mount of the poreis is little, and uniformitly distributing; if the grain is little; if the organizational structure is symmetrical, all of which can improve the quality of the sintering.

另外还归纳出有利于强度提高的工艺参数和操作制度。分析工业试验和水钢现行生产的矿物组成、结构表明，水钢烧结矿以他形晶磁铁矿为主，铁酸钙为主要的粘结相，多形成熔蚀结构、粒状结构和共晶结构，强度较高；而在台车边缘和表层，由于存在较严重边缘效应和点火温度较低，使该区域的烧结矿组织结构疏松，局部呈蜂窝状或薄壁大孔状，铁酸钙较少而硅酸二钙和玻璃质较多，形成骸晶状结构和磁铁矿连晶，强度较低，致使返矿升高。

Borides are promising candidates for wear resistant materials. But poor sinterability and extreme brittleness of borides retarded their application. Reaction boronizing sintering method has solved this problem.

硼化物是一种优良的耐磨材料，但由于其较差的烧结性能和极大的脆性限制了这种材料的应用，反应硼化烧结法很好地解决了这一问题。

It was found that the stability of the melt was seriously affected by the diameter, the density and the homogeneity of the feed rod. The dense and uniform feed rods with pure phase were prepared by complete mixing and repeated sintering at a suitable temperature.

在适当温度下多次预烧结和反复混料，并通过最后的烧结可获得纯相、均匀和致密的原料棒；原料棒直径一般控制在10 mm以内； 3～5 mm/h的生长速度适合晶体生长；生长结束时缓慢降温和退火处理可抑制YFeO3晶体的开裂。

Through research, we find that the granularity of ore-crushing of low-silica sinter has a noticeable fractal characteristic, and fractal dimension is the efficient way of quantitive characterization on the distribution of the granularity of ore-crushing.

研究发现，低硅烧结矿破碎的粒度组成具有良好的分形特征，分形维数是定量表征烧结矿的粒度分布的有效方法。

Sintering technique is an effective means to realize harmless treatment of bottom sludge that is pollutive to water bodies. This invention can realize efficient utilization of sintered bottom sludge, and can obtain zeolite with high added value.

烧结技术是实现水体污染底泥无害化的有效手段，而本发明解决了将无害化后的烧结底泥进行资源化有效利用的问题，并可获得有用的高附加值沸石。

Breath, muscle contraction of the buttocks; arch body, as far as possible to hold his head, right leg straight towards the ceiling (peg-leg knee in order to avoid muscle tension).

呼气，收缩臀部肌肉；拱起身体，尽量抬起头来，右腿伸直朝向天花板（膝微屈，以避免肌肉紧张）。

The cost of moving grain food products was unchanged from May, but year over year are up 8%.

粮食产品的运输费用与5月份相比没有变化，但却比去年同期高8％。