烧结的

This article introduces the microporous three-dimensional small-opening structure sintered by powder material, discusses the hydraulics characteristic of the narrow passage in the microporous material and the bubble chamber theory and expounds the general 1/3～1/7 empiric rule.

介绍了由粉末状材料烧结而成的微孔管三维孔隙结构，研究了PE烧结管三维孔隙之间的关系，并探讨了微孔管介质内细孔道的水力学特性和泡室理论，对通用的1／3～1／7经验规则进行了解释。

In order to obtain the best synthesis temperature of cordierite by the method of direct sintering, samples were synthesized with pressed raw blocks respectively at controlled temperatures of 1310℃,1350℃ and 1400℃.

为了研究采用直接烧结法合成堇青石的最佳合成温度，对压成的生料块分别在最高合成温度为1300℃，1350℃，1400℃下进行合成，通过对比不同合成温度下得到的样品X射线衍射图，确定出采用直接烧结法合成堇青石的最佳合成温度。

By using dipping enameling on a low carbon steel,effects of firing temperatures and time on structure and properties were studied,the hardness of the enamel coating was measured,and the relationship between hardness and firing temperature and time and the effect of crystal nucleus addition were also investigated.

采用浸搪法制备搪瓷基板，研究了不同烧结温度和时间对钢铁基板搪瓷制备工艺、组织和性能的影响，测定了搪瓷层的硬度，并分析了搪瓷层硬度与烧结温度和时间的关系，以及晶核添加剂对搪瓷层硬度的影响。

Through the research, we found that the appropriate readjustment India ore and the Yangchun ore allocated proportion, uses the iron material match level 4 to carry on sinter under the unchanged iron material and craft condition, produces the much calcium ferrite and fayalite, obtains the melting corrosion structure and the granular structure as primarily sinter which may enhance the strength.

凡在烧结时能产生较多的液相，冷却时不是形成结晶较差的玻璃质，而是形成充分结晶的针状或树枝状、棒状铁酸钙；磁铁矿不是以块状孤立存在，而是被粘结相交织固结成熔蚀结构、粒状结构或共晶结构；气孔较少，且分布均匀；粒度较细；组织结构均匀的烧结矿均能提高质量。

A series of porous metallic matrix with various porosity and good shapes were manufactured through adjusting the partitioning among Ni-Cr filler, high temperature solid grains and foamer by loose powder sintering. The elastic modulus of the matrix was measured.

以松装烧结方法为基础，通过调整Ni-Cr合金钎料、高温固相颗粒和造孔剂的配比，采用合适的烧结工艺，制备出具有不同孔隙率、形貌较好的多孔金属胎体试样，并测量了胎体试样的弹性模量。

Squeezing and preparing a plate underframe and a upper holdfast with support legs respectively, pre-sintering and final finishing the underframe and upper holdfast respectively, then welding the underframe and the upper holdfast of upper holdfast into one unit, finally heat treating the welded one unit product under the temperature of 150-650DEG C.

分别挤压制成一个平板形底架和一个带有支撑腿的上支架，将底架和上支架分别预烧结、精整，然后，再将底架和上支架的支撑腿烧结焊成一体，最后在150～650℃的温度下将焊接为一体的产品进行热处理。

Following were the main substances of this research: Rules of import-iron oresagglomeration, import-iron ores include Brazil CVRD iron ore、Indias high qualitymine、Brazil iron fine powder、Irani iron fine powder and Mauritania fine powder.Rules of rich iron ores of Tiangang agglomeration, it includes Laiyuan iron ore andQian'an iron ore.

本文主要研究内容包括：进口富矿粉的烧结成矿规律，进口粉主要包括巴西CVRD 粉、印度高品位粉、巴西铁精粉、伊朗粉和毛里塔尼亚粉；地方精粉主要包括涞源精粉和迁安精粉；在上述研究的基础上，进行合理烧结配矿的研究，从而得出合理的配矿方案和工艺参数。

It is found that, compared with the vacuum sintering, the magnet sintering at argon protection has lower density, magnetic-energy product and remanence, but coerciveforces are higher. The magnet has more and bigger pores, and there obviously exist loose microstructure, the Nd-rich phases are clearly distributed along the grain boundaries mainly in the shape of lumpish and lamelliform.

研究发现，与真空烧结相比，采用Ar保护烧结时磁体的密度、磁能积和剩磁相对较低，矫顽力较高，磁体中形成的孔洞较多，孔径较大，并有明显的显微缩松存在，富Nd相的数量明显较多，且主要呈块状和片状沿晶界分布。

Law of agglomeration of aggrandizement of Ying Yifu mine is the aggrandizement that the aggrandizement that our country mixes the technical reformation of couplet law factory to should be directional; to do obeisance to ear law course with new-style and shunt-wound law should do obeisance to ear law dissolve to give new technology to be course of law of directional; agglomeration with double flowstone ash direction.

我国混联法厂的技术改造应以新型并联法为方向；拜耳法过程的强化应以双流石灰拜耳法溶出新工艺为方向；烧结法过程的强化应以富矿强化烧结法为方向。

The HA sinter with optimal strength and porosity could be obtained when HA was mixed with 1 of fold sucrose which was used as filler while binder and 1 of fold salt as filler, pressed under 5-45 kgf/cm2 force, dissolved the sucrose at 220°C, and then sintered under 1345°C for 10h.

目前得到，使用砂糖及食盐当作填充剂，以HA比砂糖比食盐为1比1比1，5-45 kgf/cm2的压力压制成形，再以220°C下加热使砂糖溶解，并且在1345°C烧结10小时的烧结物的强度以及孔隙度为最佳。

I am accused of being overreligious," she said in her quiet, frank manner,"but that does not prevent me thinking the children very cruel who obstinately commit such suicide.""

客人们在卡罗利娜·埃凯家里，举止就文雅一些，因为卡罗利娜的母亲治家很严厉。

Designed by French fashion house Herm è s, this elegant uniform was manufactured in our home, Hong Kong, and was the first without a hat.

由著名品牌 Herm è s 设计，这件高贵的制服是香港本土制造，是我们第一套不配帽子的制服。