烧结的

This design is mainly on sintering flue gas emissions of sulfur dioxide total control of the main purpose is to design suitable to China's national conditions of the technologically advanced and economically reasonable sintering and other industrial boiler flue gas desulphurization new technology and new equipment.

摘要本设计主要是对烧结烟气排放二氧化硫总量控制方法的研究，主要目的是设计出适合我国国情的技术上先进、经济上合理的烧结和其他工业锅炉烟气脱硫新工艺和新设备。

Nb2O5 cathodes with different density were prepared by sintered and influence of density of the cathodes on electrondeoxidation was researched.

对不同密度的 Nb2O5粉末烧结阴极的制取以及烧结阴极密度对电脱氧 Nb2O5的影响进行了研究。

When preset heating rate is 2000℃/s and pretreated compact of NdFeB alloys is sintered at 1000℃for 8min, densified magnet is obtained.

当预设升温速度为2000℃／s时，经过预处理的NdFeB合金压坯在1000℃×8min的电场烧结后，即可得到较致密的烧结磁体。

The results indicated that chemical composition and physical properties of sinters meet the requirements of production, the cost of sinters was decreased by 14.7 RMB/t.

结果表明：优化配料后的烧结矿化学成分和物理性能均满足生产的要求，在稳定各项指标的前提下，每吨烧结矿原料成本降低14.7元。

The selection of the sintering parameters has effect on the mechanical properties of the sintering materials to some extent.

烧结参数的选择对烧结材料的力学性能有一定的影响。

The results show that the performance of sintering part changes along with hydrogen content in the sintering atmosphere.

结果表明：烧结件的性能随烧结气氛中氢的含量的变化而变化。

The different sintering temperatures and holding times on sintered compact density were also studied.

研究了不同的烧结温度与不同的保温时间对烧结密度的影响。

This kind of setting's whole name is the high minus pressmen contact air-sealing technology for wind boxes of the charge and discharge end of sinter machine.

烧结机风箱外高负接触头尾密封装置是由燕山大学在结合国内外烧结机多种机头机尾密封装置的基础上，经过多年的研究取得的专利技术，目前已在国内十几个大型钢铁企业中应用几十套。

The hybrid pelletized sinter process can greatly decrease energy consumption and adapt to the agglomeration of iron ore fines. The hybrid pelletized sinter has the macrostructure and the physical properties similar to sinter and the good metallurgical properties similar to pellet.

混合球团烧结工艺可以大幅度地降低能耗并能适应细磨铁精矿的造块、成品块矿具有烧结矿的宏观结构和物理性能，同时保持了球团矿良好的各项冶金性能。

The results shows that the flow characteristics of SiC-AlN granulated powder is obviously promoted after spray drying and a suitable particles grade match. With the increasing of pressure, the density of green body increases by the style of ladder at the pressure range of 4080 MPa, 80160 MPa and 160220 MPa, the green body is uniform and densification without hard pelleted particles above 160 MPa. The pressureless sintering SiC-AlN multiphase ceramic possesses superior sintering properties and mechanical properties. It is due to the rampart formation of AlN to SiC grain growth and the reaction of SiC and AlN to form 2H solid solution. It results in the grain fining, crack expansion producing bypass and deflection, fracture section producing tearing-open and pulling-out effects, which cooperatively improves the strength and fracture toughness of the multiphase ceramics.

结果表明：喷雾造粒后，复合粉体的流动特性显著提高，粒度级配合理；随着压强增加，坯体密度在40~80、80~160和160~220 MPa范围内呈现阶梯式增长，160 MPa以上成形后素坯均匀致密，无硬球颗粒存在；无压烧结SiC-AlN复相陶瓷具有优越的烧结性能和力学性能，这是由于AlN对SiC晶粒形成生长势垒，并反应生成2H型固溶体，从而细化晶粒，导致裂纹扩展产生了绕道与偏转效应，呈现晶粒撕裂与拨出现象，协同改善了复相陶瓷的强度及断裂韧性。

On the other hand, the more important thing is because the urban housing is a kind of heterogeneity products.

另一方面，更重要的是由于城市住房是一种异质性产品。

Climate histogram is the fall that collects place measure calm value, cent serves as cross axle for a few equal interval, the area that the frequency that the value appears according to place is accumulated and becomes will be determined inside each interval, discharge the graph that rise with post, also be called histogram.

气候直方图是将所收集的降水量测定值，分为几个相等的区间作为横轴，并将各区间内所测定值依所出现的次数累积而成的面积，用柱子排起来的图形，也叫做柱状图。