点阵

These integrated solutions deliver high quality light without pixilation, closely replicating the beam quality of traditional light sources.

这些集成解决方案能提供高质量的非点阵化照明，光束质量与传统光源相近。

For instance,while attending Studies of Crystals,I found that the crystal lattice structures of rutile were too difficult to analyze in a plane figure.

例如，在上"晶体研究"这门课时，我发现金红石的结晶点阵结构在平面图中很难分析。

By testing, image lattice point is confirmed as 288×312. The circuit of high sa mpling and buffer storage is used to carry out sampling of 5 M/s.

经试验，确定所采集的图像点阵为288×312点，并采用高速采样缓冲存储电路，由硬件实现5 M/s的高速采样。

At the same time, the mark pin is vibrated up and down at the frequency of more than 200 per second by compressing air and make charaters and figures by continuous point lattice on the workpiece.

计算机控制步进电机使打印针按预定的字符或图形的轨迹移动，同时压缩空气使打印针以每秒200次以上的频率上下振动，在工件上打出由连续点阵构成的字符和图形。

The main products for high-brightness red, green, blue, yellow, colorful lights, three colors, piranha, white light-emitting diodes; traffic lights, outdoor displays; infrared launch receiver diode; cap components; SMD Series LED components; digital tube and lattice; point light source, backlight source; colored high-power 0.5W, 1W, 3W, 5W, etc..

主要生产的产品为高亮度红、绿、蓝、黄、七彩灯、三色、食人鱼、白色发光二极管；交通信号灯，户外显示屏；红外线发射、接收二极管；套子组件；SMD系列发光元件；数码管及点阵；点光源、背光源；各色大功率0.5W、1W、3W、5W等。

The line-tracking system and obstacle-avoiding system use the infrared photoelectric sensors to realize intelligent walking. The LED display system which through control the input and output of 74HC595's data, shows the prearrange face at 24×24LED matrix. Then, simulate the brow change by changing picture to get the function of changing faces.

机器人运动过程中，采用PWM技术和开环系统控制无刷直流电机的运行，实现机器人的行走控制；机器人的寻线及避障系统采用红外光电传感器，实现机器人的智能行走；LED显示系统中，通过编写程序实现对74HC595的数据输入输出控制，在24×24LED点阵上显示预置的面部表情，通过画面切换模拟人物表情变化，实现变脸功能。

According to the theory results,the two orthogonal polarized states of the fundamental mode become non-degenerate in this fiber and modal fields are quasi rectangular with appearing strongly linear polarization.And,the birefringence of the fiber was found to be due to the asymmetry of cladding structure.If the rate η between lognitudinal and transverse holes-spacing is reduced,the birefringence will increase strongly.

结果发现，矩形点阵微结构聚合物光纤基模两个正交偏振态不再简并，模场呈现类矩形且具有较强的线偏振特性；该光纤模式双折射产生于包层孔结构分布的不对称性，减小包层纵向孔间隔和横向孔间隔之比η值，双折射明显增强，适当调节η，可在更宽频带范围内实现高双折射单模运行。

So that you and members of the different color business card printing machine, you need to use raster image processor for an explanation, and generates pixels image, and then by the RIp-printing-printing header control network and in fact, CTS system RIp and imagesetter RIp works, and do the same, and they are using a software RIp.

这样就和一般彩色制卡机不同，需要使用光栅图像处理器来对页面进行解释，并生成点阵图像，然后由RIp控制喷印头喷印网点，实际上，CTS系统的RIp和激光照排机的RIp的工作原理及完成的工作差不多，并且也都是使用软件RIp。

The rectangular grid, or matrix, of tiny

点阵 由小"单元"组成的矩形网格或矩阵，在这些小"单元"

I was wondering, but I don't know if this would be a RAM eater, what if you exported the character sequence into photoshop, then applied the gaussian blur there, reimport into TBS but instead of leaving them as bitmaps, vectorize them, and see what comes out?

我不知道，但我不知道这将是一个吃内存，如果你的字符序列出口到软件，然后采用高斯模糊那里，再进口到TBS的，但不是让他们的点阵图， vectorize ，并看出来？

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。