点过程

In allusion to dynamic nonlinear large-scale industrial processes, to bring up gained the method of decentralized identification for the strong consistency estimates of the divisible steady-state models, it is used that property of polynomial can infinitely approach to the nonlinear function and in optimization processes use step signals as input signals, the divisible steady-state models of dynamic nonlinear large-scale industrial processes, and the cognizable conditions are obtained.

针对动态非线性大工业过程，提出了得到其可分稳态模型强一致性估计的分散辨识方法；利用多项式对非线性函数的无限逼近的性质和优化过程中设定点的阶跃信号作输入激励信号，获得了动态非线性大工业过程的可分稳态模型和可辨识的条件。

In the aspect of the force analysis between cycloid disk and pin wheel, a kind of force analysis method of the mesh with initial clearance is put forward in allusion to the teeth profile of the equidistant and radial-moving combining modification, which is more accord with the actual engineering.

该方法主要是从整个传动过程中动态地考虑摆线轮与针齿齿面的受力情况，依据摆线轮与针齿的实际最先接触点的分布区间不同，对不同的等距与移距组合修形方式分别给出了动态受力分析方法，并且在整个传动过程中进行了优化搜寻，从而得出了整个传动过程中的接触力动态变化规律，相对以前的受力分析方法，计算的精度和准确性得到了提高。

Theobserved strain is 10~2 times as local point strain at the same observed stress.This indicates that macroscopical symmetrical rock is quasi-brittle materialwith microcosmic heterogeneousness and its macroscopical mechanicalbehavior is the results of reciprocity and magnification between microcosmiccharacteristic, not simple sum.(4) The degree of irregularity of strain increases with the number of cycle.But degree of irregularity of transverse strain fluctuates larger at the samecycle. Moreover degree of irregularity of transverse strain is larger than that ofaxial strain. This shows that deformation and failure of rock is process ofevolvement of small crack. Small crack evolves from even and out-of-orderstatus to heterogeneous and ordinal status.(5) Ultrasonic speed decreases with the number of cycle. The decreasecourse is such: Firstly, ultrasonic speed fluctuates in a steady scope in somecycles; And then ultrasonic speed quickly decreases to a certain more smallvalue; Afterwards in succedent cycles, ultrasonic speed fluctuates about thevalue. That is to say, ultrasonic speed fluctuates and decreases at intervals ofcycles. In deformation process of rock, quantitative change and qualitativechange of its small crack evolvement carry through crosswise.(6) Strength and modulus of rock decrease with exponential function asscale of specimens increases.

同一表观应力下，局部点应变与表观应变相差可达2个数量级，表明宏观上均匀的岩石是具有细观特征的准脆性材料，其宏观力学行为是细观特征相互作用、放大的综合结果，而不是简单的叠加；(4)岩样轴向应变不均匀程度和横向应变不均匀程度随循环次数的增加渐进增大，但是在同一个循环内，横向应变离散系数随应力的变化波动较大，且同一循环级别下，横向应变不均匀程度大于轴向应变不均匀程度，表明岩石内部微裂纹的演化是岩石变形破坏的本质特征，这一演化表现为微裂纹从均匀无序分布逐渐向非均匀有序发展；(5)随循环次数的增加，所有岩样内部超声波速会出现衰减，衰减过程表现为在某几次循环内超声波速在某一相对范围内波动，然后急剧减小到某一较小值，在随后的循环内，超声波速又会保持在这一较小值附近波动，即超声波速表现为波动和急剧减小间隔形式衰减，表明从宏观看来平稳的岩石变形过程，内部结构演化过程(微裂纹发展及其相互作用)却表现为均匀量变和突发质变不断交叉进行的现象；(6)岩石强度和弹性模量随尺度增大呈指数函数规律减小。

All the LOH on 〓 and 〓 was observed in invasive ductal carcino- ma, carcinoma simplex, medulary carcinoma and scirrhous carcino- ma, no deletions at these sites were observed in any invasive lobular carcinoma and others. These results imply an etiological difference.P53 gene is a hot point gene in the occurrence and development of breast, cancer. PCR-SSCP analysis was performed to detect P53 gene point mutation in the region between exon 5 and 8, 5 of 12 (41. 6%) stage I breast cancer patients contain mutation of P53, 3 of 5 patients were accompanied by 〓 deletion. These results suggested that point mutation and allelic loss of P53 gene are two vi- tal genetic events in earlier stage of breast tumorigenesis.

我们还发现，〓和〓位点LOH均分布在乳腺浸润性导管癌、单纯癌、髓样癌及硬癌中，在浸润性小叶癌和某些特殊类型乳腺癌中全部为LOH阴性，上述位点LOH可能与某些组织学类型乳腺癌的发生有关。P53基因是乳腺癌形成过程中的一个热点基因，本研究对12例Ⅰ期乳腺癌组织标本中P53基因热点区域第5、6、7、8外显子点突变进行了测定，发现41.6％（5／12）的病人有P53基因一个或多个点突变，其中3例同时伴有〓位点LOH，表明P53基因点突变和等位基因缺失是发生在乳腺癌形成早期的一个重要遗传学事件。

The theoretical framework of the CCS-based steganographic scheme is given, in which pixels are divided into groups and secret data are embedded into each group. The proposed scheme guaranties that the pixel value changes at most one in the embedding process.

建立了基于完全覆盖集的隐写方法的理论框架，使用将像素点分组的方式对每组像素点来嵌入信息，同时保证了在嵌入过程中每点像素值最多改变1。

All gambling games have specified beginnings, middles, and endings, based 45 on a sequence of events that determine the outcome of the game.

根据游戏的过程及结果，所有的赌博都有具体的开始点，中间点和结束点。

So the course for searching the occluded features is mainly based on the reliable features.

文中分析了辅助计算点的测量误差所带来的搜索定位困难，信用度因子的引入可以弱化不精确辅助点对搜索结果的影响，使搜索过程主要依赖可靠的点进行。

But the conveying chain wheel with smaller radius allows smooth transportation of small PCB.

无铅焊点冷却时，不具有象铅锡合金一样的固液共晶点，而是一个温度区间，运输过程中产生的震荡会影响焊点的良好结晶，半径较小的运输传动链轮使得小型 PCB 平稳传送，无振荡。

This method selects two parameters, energy and variance, as the characteristic parameter of trolley track, and successfully in extracts the feature frequency belt of trolley track vibration. Furthermore, this technology is applied to practical engineering programs and has good veracity and reliability.2. According to the research of this thesis on the trolley tracks\' present data, the status classification of trolley track with normal distribution is presented. This method divides trolley tracks\' situations into five parts and perfects the classifying method of trolley tracks\' mechanical situation.

具体工作如下；1、将小波包分析方法运用到岸桥小车轨道振动信号的分析中，选取能(来源：A65BC0f论c0文网www.abclunwen.com)量与方差作为轨道的振动特征参数，有效提取出铰点部位与非铰点部位的振动特征频段。2、将正态分布原理引入到岸桥小车轨道铰点机械性能状态的划分之中，并用最大熵概率分布加以验证，准确地反映了实际情况，并定义了正态分布诊断准则的状态分级评价的原则和临界点，方便和简化了状态判断的决策过程。

Local mode centroids were calculated by mean-shift iterative process.

通过meanshift迭代过程，计算点模型中点对应的局部模式点，即模态点。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。