炉

The analytic results obtained from the PCT evaluations revealed that the most limiting accident was the case with a break at the Main Steamline Outside Containment. Its PCT was 1289.15 ℉, which is much below the upper temperature limit of 2200℉ set by the nuclear regulatory authority. The most limiting accident for the minimum water level measured outside the core shroud is the case with a break at the High Pressure Core Flooder Line, the minimum water level drops to 18.4 ft. For this case, even though the water level has dropped to 11.6 ft below the top of the active fuel, the reactor core was still completely covered by the two-phase water.

分析结果显示，对燃料护套最高温度而言，最严重之事故为围阻体外主蒸汽管路破口，其燃料护套最高温度为1289.15 ℉，此温度远在法规10CFR50.46所定之限值 2200 ℉以下；对反应炉最低水位而言，则最严重之事故为高压注水系统管路破口，反应炉降水区最低水位降至18.4 ft，约在有效燃料顶部以下11.6 ft，然而炉心内部仍为双相饱和流体所完全覆盖。

This paper calculated the fast neutron flux of some places in different HFETR cores, such as the 13 ion chamber and L12 fuel rod in the 1 core, the 12 ion chamber and the 1QS ion chamber in the 68-Ⅱ core. Comparison of the calculated and the experimental results was made. It showed that the result was accurate.

用MCNP4C程序分别计算了高通量工程试验堆首炉13电离室和L12元件、第53-Ⅰ炉13电离室和7电离室、第68-Ⅱ炉12电离室和1QS的快中子注量率并与实验测量值比较，计算结果是可靠的。

The main products are: all kinds of industrial furnace regenerator with cordierite, mullite, high alumina, corundum honeycomb, and various materials and specifications of the regenerator the ball, and with regenerator tile block; all kinds of industrial furnace series×, corundum brick, clay brick, lightweight insulation materials, heat insulation brick light weight, low-iron mullite brick, silica brick, magnesia brick, aluminum MgO-C Bricks, magnesia-chrome brick, chrome Corundum bricks, a steel trough brick slipway and a variety of refractory materials such as sizing the outlet; all kinds of industrial furnaces with wear-resistant castables, low cement castable high-strength, impermeable material, gravity feed can be plastic, refractory clay, such as amorphous material; a variety of wear-resistant ceramic materials: ceramic lining, grinding balls, ceramic pipes, ceramic cylinder liner, piston, valves and other ceramics.

主要产品有：各种工业炉蓄热室用堇青石质、莫来石质、高铝质、刚玉质蜂窝体以及各种材质和规格的蓄热球，并配有蓄热体挡板砖；各种工业炉用系列高铝砖、刚玉砖、粘土砖、轻质保温材料、轻质隔热砖、低铁莫来石砖、硅砖、镁砖、铝镁碳砖、镁铬砖、铬刚玉砖、出钢槽滑道砖以及各种定径水口等耐火材料；各种工业炉用耐磨浇注料、低水泥高强浇注料、防渗料、自流料、可塑料、耐火泥等不定形材料；各种材质的耐磨陶瓷制品：陶瓷衬板、研磨球、陶瓷管道、陶瓷缸套、柱塞、陶瓷阀门等。

With an accoupation of 136,000 square meters, the investment amounted to 320 million yuan, it is built to have EF、ESR、Forging Hammer、Hot Rolling Mill、Deep Machining and Heat Treatment Shop and Technical Center with the focus of reasearch development, process technology and quality test.

厂区占地13.6万平方米，建有20t电弧炉、5t感应炉、25t炉外精炼、25t真空脱气、1~6t电渣炉、7吨电液锤及热处理以及聚研究开发、工艺技术、质量检测于一体的技术中心。

The control system based on the model can realize the induration temperature control in shaft furnace by the indirectly measurement .

叙述了影响球团竖炉焙烧温度的基本因素，建立了竖炉焙烧温度的仿真模型，并在此仿真模型的基础上，建立了控制系统的控制方案，用智能控制方法实现了非直接测量的球团竖炉焙烧温度控

The calculation indicates that converter heat insulation layer thickness of asbestos board is about 30 mm.

对重钢50t转炉进行了炉壳温度场分析，计算表明：转炉隔热层石棉板的厚度为30mm时，炉壳温度就能控制在360℃以内，低于炉壳材质的蠕变温度。

Major equipment has seven tons of hot air cupola 1, 3-ton cupola 2; 1 ton-frequency furnace 1; 10 tons lane 2, 5 tons lane 3; Q378C blast cleaning machine 1; S1120, S118, S111 type mixer and the resin sand Mixer 1; ZNVSR-vibration system to eliminate stress 1; drying kiln and the annealing furnace 1, and other wood-based and aircraft plus 16 sets of equipment, and the other physical and chemical room with a professional .

主要设备有7吨热风冲天炉一座，3吨冲天炉2座；1吨工频炉1座；10吨行车2台，5吨行车3台；Q378C抛丸清理机1台；S1120、S118、S111型混砂机和树脂砂混砂机各1台；ZNVSR-振动消除应力系统1台；烘干窑和退火炉各1台，其他木型和机加设备16台套，另设有专业理化室。

Which can get higher recovery ratio when the temperature of melting furnace was 833K,the temperature of liquation hearth was 703K,the temperature of evaporator furnace was 1373K and the temperature of condenser was 373K;With this method to dispose the hot-dip galvanizing dregs,when the recovery ratio was more than 70% that could get more profit

当熔化炉的温度为833K，熔析炉的温度为703K；蒸发炉的温度为1373K；冷凝器的温度为373K可以得到较高的回收率；发现采用该法处理热浸镀锌渣，当回收率在70%以上时有较大的利润空间

In this article, according to the meterage of the temperature of the materiel in the downstream potting process calciner, a new cognition was brought about temperature distribution of the materiel in calciner.

本文通过对顺流式罐式煅烧炉炉内物料温度的实测考察，对炉内物料温度的分布有了新的认识。

The obturation of vacuum in the crystal grower is one of the most important factors to judge the equipment capability.

单晶炉炉室真空密闭性能是衡量单晶炉设备性能好坏的重要因素。

Neither the killing of Mr Zarqawi nor any breakthrough on the political front will stop the insurgency and the fratricidal murders in their tracks.

在对危险的南部地区访问时，他斥责什叶派民兵领导人对中央集权的挑衅行为。

In fact,I've got him on the satellite mobile right now.

实际上 我们已接通卫星可视电话了