滴度

With the increasing of the concentration of alkali, the content of insolubility of the product reduces initially but increases later, the DS of product increases initially then reduces later. The product has good solubility and high DS at 10% content of alkali. The insoluble product reduces at initially and then keeps stability later with the time of basification extending. With the increasing of the content of water in system, theinsolubility of the product reduces initially and then increases later.

随着碱浓度的增加，产物中水不溶物含量先降低后增加，取代度先上升后下降，在10％时，水溶性最好，取代度最高；延长碱化时间，产物中水不溶物含量下降，之后趋于稳定；提高反应体系中水的含量，产物中水不溶物含量先降低后增加，在7％时，水溶性最好，延长分散时间，产物中水不溶物含量下降，取代度提高；醚化剂以少量多次的方式滴加，产物水溶性好。

When the sodium lauryl sulfate and p-octyl polyethylene glycol phenyl ether is used and its level in 3% and 6: 4 ratio, the polymerization process has the lowest coagulum and the highest monomer conversion. Higher reaction temperature and more level hydroxyl value lead to more coagulum, the latter also lead to larger particle size. The acid value has larger influence on viscosity and coagulum, there exist a best range. The emulsion particle size is larger for its hydrophilicity, most of its particles are connected together.

在含较高亲水单体的乳液聚合体系中，难以制得稳定的预乳化液，不能采用工业生产中常用的预乳化工艺，而只能采用混合单体直接滴加的方法；由于单体混合物的亲水亲油值较高，用阴离子型乳化剂十二烷基硫酸钠和非离子型乳化剂聚乙二醇辛基苯基醚混合，用量为单体总量的3％，且比例在6：4时，乳液聚合时具有最低的凝聚物含量和最高的单体转化率；乳液聚合反应温度升高，可以提高单体转化率，增加反应速度，但凝聚率相应提高；随着羟基单体含量的增加，聚合过程中凝聚率增加，聚合物乳胶粒平均直径增加；羧基单体有一个最佳的用量（2.6％），过高或过低凝聚率均提高；羧基含量对乳液的粘度有较大的影响，当羧基含量较低时，羧基含量增加，乳液粘度增加明显；含羟基乳液粒子由于含亲水基团较多，使得乳胶粒径增大，乳胶粒子大多数互相凝聚在一起，处于凝聚态。

In the design of drip irrigation system, reasonable dripper discharge should be chosen and irrigation water should be supplied in order to make soil reach the designed moisture uniformity; the moisture uniformity of soil along the drip irrigation pipe should be controlled mainly.

文中提出了应用于工程设计中的滴头流量设计模式应满足的要求。在滴灌系统设计中，要使土壤达到设计的湿润均匀度就应选择合理的滴头流量，并设计出合理的灌水量，而且应主要控制沿滴灌管方向的土壤湿润均匀性。

On Fahrenheit's scale, the melting point of ice is at 32 degrees and the boiling point of water is at 212 degrees.

按华氏温度标准，熔点在32度、沸点在212度。（这里还是说的是温度的测量标准---尽管温度计上的确是有刻度表滴。

Figure out the chemical reaction equation of Quinidine Sulfate with perchloric acid and the equivalent relationship.

写出高氯酸滴定硫酸奎尼丁的滴定反应式并计算滴定度？

Methods According to Evaluation and Expression of Uncertainty in Measurement (JJF1059-1999), analysis of measure uncertainty of the chemical oxygen demand determined by acidic potassium permanganate titrate prescribed in Sanitary Standards for Drinking Water (2001) was conducted.

根据JJF 1059-1999《测量不确定度评定与表示》对《生活饮用水卫生规范》(2001)中耗氧量的酸性高锰酸钾滴定法的测量不确定度进行分析评定。结果水中耗氧量测定的A类相对标准不确定度为0.584%，B类不确定度为0.781%。

The uncertainty of Cr content that determined by ammonium persulfate oxidation titrimetry in stainless steel was studied by adopting the current international method.

采用国际通用的方法研究了过硫酸铵氧化滴定法测定不锈钢中铬量的不确定度，分析了不确定度的主要来源，评定了不确定度分量及总不确定度。

The effects of the method repeatability, sample mass, standard titrate solution and enviroment temperature on the uncertainty of PTA acid value determined with titrimetry were assessed and discussed.

摘要对滴定法测定精对苯二甲酸酸值的过程中的方法重复性、样品质量、标准滴定溶液、环境温度等方面对不确定度影响进行了评定讨论。

CS/Gel HPN gel was made and its forming mechanism was characterized by infra-red spectrum and x-ray diffraction. Turthermore, DSC, conductivity titration and turgidity titration were employed to estimate the interaction mechanism between there two biopolymers as well as the properties of HPNs

制备壳聚糖/明胶杂混聚合物网络凝胶，用红外光谱、X射线衍射等测试手段表征了HPN的形成机理，并采用DSC、电导滴定、浊度滴定等方法进一步对两种生物高分子的相互作用机理及HPN的性能做了探讨，结果表明

Results The new method is appropriate for the solution with lower concentration of Cl -, compared with the fluorescein and potassium chromate indicator method.

为此 ，我们进行了利用内置浊度传感器检测溶液的浑浊程度来判断滴定终点，测定 Cl-含量的方法研究(以下称散射光度滴定法)。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。