滑移

For some crystals located on the 001/〓11 boundary in the stereographic triangle, such as [〓33] , [〓17] and [001] crystals, their values of θ〓 are quite high, and increase monotonously with increasing γ〓.

因此，关于双滑移和多滑移取向单晶体的循环形变行为的研究对于更好地理解多晶材料的循环形变行为是至关重要的。

The key technologies of ABS based on slip-ratio consist of processing of wheel speed and calculation of wheel acceleration, estimation of vehicle velocity, estimation of the optimal slip-ratio, and the control strategy of ABS. In order to improve the performance of conventional ABS, the above mentioned key technologies and corresponding realization algorithms had been investigated in this paper, and the ABS product equipped in vehicle for performance test had been manufactured.

结合车辆动力学控制的最佳ABS系统是以车轮滑移率为控制目标的ABS系统，它涉及到一系列关键技术研究，如轮速信号的处理方法和轮加速度信号的计算方法、车身速度估计方法、最佳滑移率估计方法和ABS的控制方法等。

However, with the increase of the temperature, the slip length decreases with the temperature for the interfaces with the weak interaction between the solid wall and the liquid particles.

在纳米尺度及固液作用势较强的情况下，滑移长度随着温度的增加而增加；然而在其较弱的情况下，随着温度的增加，滑移长度反而下降。

In the course of the embossing of the paper by clalendaring force backward uponsize, if there is not enough force to maintain the stability of the paper, then paper when printing units to imprint on the drum with corresponding bliding and bliding in the paper was accmulation amplificatory end, resulting in a throw-off point.

纸张在压印历程洋施到压延辛向后的拉辛，如果不不安纵足不亏不小的辛来保持纸张的安定的话，那么压印时纸张不离便当在压印滚筒上爆发相差的滑移，并且这栽滑移也会在纸尾处被补偿放不小，导致甩角。

With the occurrence of the gliding, one side of the gliding face is enantiomorphously symmetric with the other side.

当滑移作用产生之后，滑移面的一侧与另一侧成镜像对称关系时，称双晶滑动。

In this paper, base sliding isolation technology is discussed mainly, and according to interbedded shear model seismic response analysis program of structure with base sliding isolation is compiled by using Newmark抯 method .

本文针对基础摩擦滑移这一隔震形式进行讨论，建立了隔震体系的层间剪切模型，并利用Newmark法编制了基础摩擦滑移隔震结构地震反应分析程序。

The results show that the deformation feature during creep produced in the primary stage is that a great deal of $\langle a\rangle$ dislocation is activated on basal and non--basal planes, and $\langle a+c\rangle$ dislocation slips on pyramidal planes.

结果表明，蠕变初期的变形特征是：大量形变产生的 a 位错在合金的基面和非基面滑移， a ＋c位错在锥面滑移。

In order to solve the experimental problem of tricrystal,elastic stress distribution of copper tricrystal under monotonical loading was analyzed by finite element method,the shear stress on slip system in each grain was analyzed.

采用有限单元法计算三晶体在单向拉伸载荷作用下弹性阶段的应力场，分析了三晶体中各晶粒主滑移系上的切应力分布，计算结果表明，当晶界平行于加载轴时，该晶界对其两侧晶粒有很明显的作用，较大程度的改变晶粒滑移系的形式，而且作用程度要超过三晶交点的作用，倾斜晶界则没有明显的作用。

The second-order slip model is adopted and the modified Reynold＇s equation for the gas flow is gotten.

引入二阶滑移流边界条件对连续流的状态方程进行修改，得到滑移流机制下修正的雷诺方程。

The modified Reynold＇s equations of first-order slip-flow and second-order slip-flow for the micro gas bearing are obtained.

利用有限差分法对连续流、一阶滑移流和二阶滑移流的雷诺方程分别求解，得出相应的承载力和偏位角。

They weren't aggressive, but I yelled and threw a rock in their direction to get them off the trail and away from me, just in case.

他们没有侵略性，但我大喊，并在他们的方向扔石头让他们过的线索，远离我，以防万一。

In slot 2 in your bag put wrapping paper, quantity does not matter in this case.

在你的书包里槽2把包装纸、数量无关紧要。