滑移

According to experimental data, the ultimate bond stress and bonding-slipping constitutive relation are presented based on the thickness of protection layer and effective bond length.

根据试验数据回归出基于相对保护层厚度和相对有效粘结长度的极限粘结应力计算公式和粘结应力与滑移的本构关系式。

The relationship between load, bond length and slip was derived. The distance of transverse crack has been taken into account.

推导了实用的荷载、试件长度以及加载端滑移三者间的关系表达式。

In the bounding surface masonry model, the sliding yield surface is considered as isotropic hardening and rotating hardening bounding surface, and the masonry model is expanded from monotonic loading to complex loading.

把滑移屈服面看作为等向硬化和旋转硬化的边界面，从而合理地把砌块体模型从单调荷载推广到复杂荷载情况。。。

In polycrystal, triple junction is an important grain defect which plays an important part in the deformation behavior and fracture. However, it is still less known. In this paper, zero-tension-zero test under stress control on tricrystal which grew from pure copper of 99. 999% by the Bridgman method was carried out, and the appearance of surface slip line was also obtained.

在多晶体中，三晶交线是一种重要的晶体缺陷，对多晶体的变形行为和断裂起着重要的影响，但是人们对它的了解和重视程度又是很不够的，本文首先对由99.999％的纯铜随机生长的三晶体进行了拉-零循环加载实验，得到了表面滑移线形貌，实验中采用应力控制。

In a word, the top bunt slippage method is a particular way in practical process of steel box girder installation.

通过未用项推滑移安装方法，对钢结构桥梁进行了成功的安装，达到了预期的目的，同时降低施工造价。

Thirdly, Through the introduction of the Burckhardt road model 、Gim tire model、bus brake model and Time-domain model of road roughness ,ABS system with a fuzzy controller based on the slip rate deviation and deviation rate of change was designed. The ABS system on account of impacts of air suspension and road roughness were analyzed, and its result showed that air suspension system and braking system need joint control.

第三，通过引入了描述单轮特性的Burckhardt的路面模型、Gim轮胎模型、客车制动器模型和时域路面不平度模型，并在此基础上设计了基于滑移率偏差和偏差变化率的ABS模糊控制器，对计及空气悬架和路面不平度影响的ABS进行了分析，进而说明了空气悬架系统与制动系统进行联合控制的必要性。

Through field test, the modal shape and modal frequency of the cantilever retaining wall system are tested and computed. Then based on the superposition method model the health diagnose method for the local damage and the two typical failure modes for slippage, capsizal are studied.

通过现场试验，对悬臂挡墙系统模态振型、频率进行了测试与计算，并基于集中质量参数法对墙体结构局部损伤及倾覆和滑移两种典型破坏模式下健康诊断方法进行了研究。

With the exploration of the adhesive work between fluid and pipe-wall, the drag reduction mechanism for the pope flow of Casson fluid is brought to light.

分析了流体与固体管壁之间的粘附功，揭示了卡森流体管内流动时的减阻机理，认为流体在流动过程中滑移的产生是减阻的本质。

But magnesium alloy has a hexagonal close-packed crystal structure with limited number of operative slip systems at room temperature, so magnesium alloys are normally low formability near the room temperature, and limits the expansion of magnesium alloy applications.

但是由于镁合金是密排六方结构，可开动的滑移系比面心立方和体心立方金属的少，使得镁合金的室温塑性较低，降低了成形能力，限制了变形镁合金的推广应用。

Further study of this paper has shown that reason for"camel peak"phenomenon in the adhesion-creep test curves is difference between sliding-and static coefficient of friction and discussed the analytic formulae for line contact as well as one direction slip and special correction Lemk's method for point contact when their change is considered as stage jump function.

通过进一步的理论研究指出造成轮/轨粘着率与弹性滑移率实验曲线呈"驼峰"状的原因是滑动区和粘着区的动、静摩擦系数变化，给出了当它们为阶跃变化时线接触条件下的解析解和对点接触情况的独特的"修正"Lemke算法。

Plunder melds and run with this jewel!

掠夺melds和运行与此宝石！

My dream is to be a crazy growing tree and extend at the edge between the city and the forest.

此刻，也许正是在通往天国的路上，我体验着这白色的晕旋。