滑

Main job is to guarantee the scraping interaction and equipment on both sides of the friction surface or can obtain higher precision and accuracy, precision and shape accuracy, precision and contact transmission because of good lubrication, manual and repeatedly is worthy, large amounts of wind, time-consuming, scraping the time needed for different devices vary, such as boring slider and slide block wind profiling, between the match before measuring clearance between the original value, and then according to the technical requirement to measure the value of time and scraping scraping, then apply DanFen red on the slider, manual let slip on the slide seat back and forth, they do straight-line movement between full contact and friction, reoccupy scraper scraping friction creates the contact point, so repeatedly, until the technical requirements for the match, single within 2 days, must blow to the boring if all the time to work with wind, a half month is required.

刮削过程。刮削工作主要是为了保证设备相互接触并摩擦的两面间能获得较高的尺寸精度、形状精度、位置精度、接触精度、传动精度和良好的润滑，因是手工操作且需反复配刮，故工作量大，耗时较长，设备不同，刮削所需时间也各不相同，例如镗床上滑座与下滑座间的配刮，刮削前先测量出二者之间原有的间隙值，然后根据工艺要求测算出需刮削值及每次的刮削量，再将红丹粉涂于上滑座之上，手工让上滑座在下滑座上来回做直线运动，使它们之间充分接触和摩擦，再用刮刀刮削摩擦产生出的接触点，如此反复多次，直至技术要求范围之内，单此项配刮需2天左右，若对于整个镗床所有配刮工作的时间总和，则需半个月左右。

Combined the geological analysis with analogue modeling experiments,the evolution of the Yinggehai basin could be divided into four main stages:(1) Before 42Ma,controlled by the southeastward extension of the Beibu Gulf basin on the northern continental margin,the Yinggehai basin experienced dextral pull-apart.Bounded by NS-trending Yingxi fault,the transtensional areas mainly are the northwest part and along the eastern boundary of the basin.(2) From 42 to 21Ma,the development of the main rift body in Yinggehai basin was mainly controlled by the southward slip and clockwise rotation of the Indochina block along the Red River fault zone,and the sedimentation was strengthened due to the sinistral transtension.In the east,the subsidence is deepened due to the dextral transtension.(3) From 21 to 10.4Ma,the sinistral movement of the Indochina block slowed down to still.From 21 to 15.5Ma,the northwest part of the basin began to inverse locally because of post-rift thermal subsidence of the whole basin.(4) From 10.4Ma to present,the basin was affected by the dextral movement of the South China block along the Red River fault zone and thermal accident in a new phase at 5Ma.

结合地质分析和物理模拟实验，莺歌海盆地的演化大致可以分为以下4个主要阶段：早期(42 Ma以前)主要受到南海北部陆缘裂解造成的右旋转换伸展作用的影响，但影响范围较小，主要为莺歌海盆地西北部和东部边界。42～21 Ma期间，主要受控于印支地块左行走滑和顺时针旋转作用的影响，莺歌海盆地在此期间发育了主体裂陷体系，东侧受到右旋转换伸展应力场的叠加影响而导致沉降加强；21～10.4 Ma期间，受印支地块逐渐减弱直至停止的左行走滑作用的影响，盆地西北部在21～15.5 Ma期间发生局部反转褶皱，但盆地整体进入以热沉降为主的时期；10.4 Ma以后，盆地受华南地块沿红河断裂右旋走滑作用和5 Ma以后新一期热事件的影响。

Based on technical processing of high-resolution SPOT images and aerophotos, detailed mapping of offset landforms in combination with field examination and displacement measurement, and dating of offset geomorphic surfaces by using carbon fourteen (14C), cosmogenic nuclides (10Be 26Al) and thermoluminescence methods, the Holocene sinistral slip rates on different segments of the Altyn Tagh Fault are obtained. The slip rates reach 17.5 mm/a on the central and western segments west of Aksay Town, 11 mm/a on the Subei—Shibaocheng segment, 4.8 mm/a on the Sulehe segment and only 2.2 mm/a on the Kuantanshan segment, a easternmost segment of the ATF. The sudden change points for loss of sinistral slip rates are located at the Subei, Shibaocheng and Sulehe triple junctions where NW-trending active thrust faults splay from the ATF and propagate southeastward.

在高分辨率SPOT卫星数字影像和大比例尺航片处理、断错地貌制图、野外核实与位移测量基础上，利用宇宙成因核素（10Be、26Al）、碳十四（14C）和热释光等多种测年手段，厘定了各断错地貌面的形成年龄，得到了阿尔金断裂带不同段落全新世左旋走滑速率：阿克赛以西的中、西段左旋走滑速率可达17.5 mm/a，肃北—石包城段为11 mm/a左右，疏勒河口段减少到4.8mm/a左右，东端宽滩山段仅约2.2 mm/a，左旋走滑速率突变点位于阿尔金断裂带中东段存在分支活动逆断层向南东扩展的肃北、石包城和疏勒河等三联点上。

In order to promote the development of speed roller skating smoothly and orderly in our country, and improve the competitive level of our country, we should study the affecting factors for the development of speed roller skating of our country.

为了更好地推动速度轮滑运动在我国稳步而有序地发展，提高我国速度轮滑的竞技水平。有必要对影响我国速度轮滑运动发展的因素及对策进行研究。

Combining theory with experiment, as well as referring to the research results about the sideslip from the former correlative fruits, to the wheel location parameters, especially the quantitative relation between the wheel camber angle, the wheel toe-in and the measure of the sideslip have been further researched.

根据上述理论分析，提出了在侧滑检测中给汽车施加纵向力的方法，即模拟汽车实际行驶时车身所受到的空气阻力，目的是侧滑检测中汽车通过侧滑台时提高汽车的驱动力，以使汽车的车轮定位参数更接近于汽车实际行驶时的状态。

The dynamic measuring method of alignment parameters based on the Satisfaction Criterion Model is presented in this paper. Using the quadratic regression crosscut combination method to organize the experiment, the mapping relationship between side force of slippage and camber angle and toe-in of the testing vehicles is obtained by regressing the experiment data. In this experiment, side force and slippage are testing objects, camber and toe-in value are testing factors.

本文提出了基于满意准则数学模型的车轮定位参数智能化动态测量方法，运用二次回归正交组合设计方法组织和安排试验，以车轮外倾角和前束值作为试验因素，侧向力和侧滑量作为试验目标，通过对试验数据的回归处理得到了试验车辆的侧滑量或侧滑量同车轮外倾角以及前束值之间的映射关系。

A comparison is conducted to evaluate the performance of the optical mouse, the touch pad and the track point.

结果显示虚拟追踪球手套滑鼠的移动效能虽然不及一般桌上型的光学滑鼠，但在与同为行动装置的触碰板以及轨迹杆比较，虚拟追踪球手套滑鼠却以将近高出一倍的移动效率远远超过触碰板以及轨迹杆。

It is discovered that vane slot back pressure has great influence on vane behavior.

研究发现，滑片背部的滑槽背压对滑片的行为有重要的影响。

But in actual experimental process, the viscous force of friction has influenc in the varying degree to the measurement result when the initial velocity of the slide block is different.

在气垫导轨上做碰撞实验，最大限度地减少了摩擦阻力的影响，但在实际的实验过程中，仍发现滑块的初速度不同时，粘滞性摩擦阻力对测量结果有不同程度的影响，为此在气垫导轨上增加了电子发射装置，较好地控制滑块的初速度和测量滑块的加速度，从而减小粘滞性摩擦阻力对测量结果的影响。

When you water-ski, you usually have two different skis, one for each foot. This little boy is practicing on a training-ski. No wonder! He's only 22 months old!

滑水时，通常有两个不同的滑水板，一脚一个，这个小男孩是在训练用的滑水板上练习，难怪，他只有二十二个月大。

The absorption and distribution of chromium were studied in ryeusing nutrient culture technique and pot experiment.

采用不同浓度K2CrO4(0，0.4，0.8和1.2 mmol/L)的Hoagland营养液处理黑麦幼苗，测定铬在黑麦体内的亚细胞分布、铬化学形态及不同部位的积累。

By analyzing theory foundation of mathematical morphology in the digital image processing, researching morphology arithmetic of the binary Image, discussing two basic forms for the least structure element: dilation and erosion.

通过分析数学形态学在图像中的理论基础，研究二值图像的形态分析算法，探讨最小结构元素的两种基本形态：膨胀和腐蚀；分析了数学形态学复杂算法的基本原理，把数学形态学的部分并行处理理念引入到家实际应用中。