溶剂

By the furnace body, the stainless steel crucible, electrically operated toward the multiple swinging material frame, stainless steel fast Leng Bao, the heating unit and control the warm cabinet to be composed automatically, may use the different resolver, carries on components quenching, the temperingheating, the isothermal quench to cool, the liquid thermochemical treatment and so on many kinds of crafts, the furnace body becomes by the section and the steel plate welding, the stove surface uses δ=14mm the board to make, the nitre salt furnace lining uses the ultra light quality high strength 0.6g/cm3micro bead refractory brick, clamps the stratification aluminum silicate textile fiber, the furnace lining and the furnace shell fills the heat preservation inflation heat preservation powder, the entire structure for the standard energy conservation furnace lining, the nitre salt stove's heating element

由炉体、不锈钢坩锅、电动往复式摆动料架、不锈钢速冷包、电热元件和自动控温柜组成，可以使用不同溶剂，进行零件淬火、回火加热、等温淬火冷却，液体化学热处理等多种工艺，炉体由型钢和钢板焊接而成，炉面采用δ=14mm板制成，硝盐炉衬采用超轻质高强度0.6g/cm3微珠耐火砖，夹层置硅酸铝纤维，炉衬与炉壳间填充保温膨胀保温粉，整个结构为标准型节能炉衬，硝盐炉的发热元件采用较粗直径0Cr25Al5高温电阻丝绕成螺旋状按照

There are no complete or public fabrication processes of SLS polymer powders. In this paper, according to the fabrication methods of polymer powders and the data analysis, the feasible fabrication processes and methods of cryogen and solvent are reached. The reasonable combination of process parameters is important to get the better quality.

目前SLS高分子粉料的制备工艺处于行业保密状态，没有完整、公开的工艺流程可供参考，本文根据高分子粉末的制备方法，通过资料分析，总结出了低温粉碎法和溶剂沉淀法两种可行的SLS高分子粉料的制备方法和工艺流程。

Cryptomeria japonnica was liquefied in polyethylene glycol/glycerol co-solvent with H2SO4 and HCl as a catalyst.

本研究以聚乙二醇／丙三醇为混合溶剂，硫酸及盐酸为催化剂，对柳杉木材Cryptomeria japonnica D。

Tanshinone deposited on the surface of the carrier in crystal form, and the size was obviously reduced.

采用溶剂沉积法提高丹参酮的体外溶出度是可行的。

In the process of MgO preparation, the amount of solvent, reaction temperature and the amount of citric acid have varying effects on gel time and crystallite size.

在制备纳米MgO过程中，溶剂用量、反应温度和柠檬酸用量对凝胶时间和晶粒都有不同程度的影响。

The epoxidation of propylene to propylene oxide, using cumene hydroperoxide as oxidant, molybdenum-glycol complex as catalyst and ethanol as solvent, has been investigated.

研究了以钼－醇配合物为催化剂，过氧化氢异丙苯为环氧化剂，乙醇为溶剂的丙烯一步氧化制环氧丙烷的反应。

The results indicate that the surface of cuprum foil cleaned by conventional method has a little oil and is easy to be oxidized in the atmosphere.

实验结果表明，常规有机溶剂清洗的铜箔，表面有微量的油污残留，暴露在空气中易氧化，经Ar等离子体清洗的铜箔，表面洁净、暴露在空气中不易氧化，Ar等离子体清洗10～20 min，表面性质最佳，清洗彻底，润湿角明显减小

The aggregates and relevant fluorescence spectra of three cyanine with higher sensitizing efficiency in different solvents andin different concentrations were studied.

本文着重研究了三只增感效率较高的菁染料在不同溶剂和不同浓度下的聚集态和荧光光谱。

Acetone is mainly used as solvent, and for production of acetone cyanohydrin, MMA and bisphenol A secondly.

丙酮主要用做溶剂，其次是生产丙酮氰醇、MMA和双酚A.2004年我国丙酮的产能为30.1万t/a，主要生产厂家有上海高桥石化、燕山石化、吉林化学工业公司和哈尔滨华宇股份有限公司。

In 2004,the global production capacity of acetone was 5 179 kt,it was mainly used as solvent,or to produce bisphenol A and acetone cyanohydrin .

2004年全球丙酮产能为517.9万t，主要用途是作为溶剂生产双酚A和丙酮氰醇，预计2006年将出现过剩的局面；2004年我国丙酮产能为31.3万t，进口量为25.43万t，预计2007年国内需求量将达到60万~70万t，近几年生产无法满足市场需求，但未来市场不容乐观。

But we don't care about Battlegrounds.

但我们并不在乎沙场中的显露。

Ah! don't mention it, the butcher's shop is a horror.

啊！不用提了。提到肉，真是糟透了。