溶剂

Excellent capability for preventing causticity, passing such test as acid,alkali,impregnant,high temperature.

优良的耐环境性能，经过耐酸、耐碱、耐溶剂、温度循环、高温等环境测试，膜层无明显变化。

This research's goal is develops one kind of high performance the emulsion cellulose nitrate lustre-coating agent, while maintains the resolver superiority enhances the emulsion stability.

本研究的目的是研制一种高性能的乳液型硝化纤维光亮剂，在保持溶剂型优势的同时提高乳液型的稳定性。

Based on the nitrogen content measured vial Kjeldahl nitrogen detection equipment,the substituted degree of cellulose nitrate by nitric acid was calculated to be 2.75 per glucose unit.

分别把NanoG、RNG和ONG加入到硝酸纤维素的丙酮溶液中，经过超声波震荡处理，挥发溶剂后得到三种纳米石墨导电复合膜。

Because the traditional resolver cellulose nitrate lustre-coating agent it does not bear the aging, the resistance to cold to be bad, shortcomings and so on hygienic performance difference receive the impact, but emulsion cellulose nitrate lustre-coating agent, although the comparison environmental protection and the hygienic performance are high, but because became the membrane glossiness to be bad and the emulsion long-term laying aside does not stabilize has limited its application.

传统的溶剂型硝化纤维光亮剂因其不耐老化、耐寒性差、卫生性能差等缺点而收到冲击，而乳液型硝化纤维光亮剂虽然比较环保且卫生性能较高，但因成膜光泽性较差和乳液长期放置不稳定而限制了其应用。

The results showed that phosphating followed by coating acrylic acid can improve the adhesive strength. Increasing water temperature and the concentrations of cellulose nitrate in the buffer layer, decreasing the concentrations of R-2 resin and solvent can reduce the elongation.

结果表明，铝材表面经过磷化处理后，用丙烯酸金属涂料涂覆，可提高水转印后粘接性，转印时水温升高，过渡层配方中硝化棉增多，随R-2树脂减少，以及溶剂的减少都会使伸长率下降。

And then the functionalized carbon nanotube, partial platinum salt and all transition metal M salt are stirred and reflow for certain time, added with rest platinum salt to continue to reflow, cooled, washed centrifugally, dried and carried out heating treatment in a hydrogen atmosphere, thus obtaining the anchoring platinum catalyst of the transition metal on the carbon nanotube.

然后将功能化的碳纳米管与部分铂盐和全部过渡金属M盐在多元醇溶剂中搅拌回流一定时间后，加入剩余的铂盐继续回流，冷却，离心洗涤，烘干，最后在氢气气氛中热处理，得到碳纳米管上过渡金属锚定铂催化剂。

Acetone has been in common use as a solvent and as an extracting regent, in industry for several decades. It is easy to evaporate in air. When the concentration of acetone in air is higher than 10,000 ppm, people may experience such symptoms as cephalalgia, nausea and so on.

由於丙酮是工业上广泛应用的溶剂，它极易挥发，且当人体曝露在高浓度的丙酮下，会有头痛、困倦及呕吐等症状，所以丙酮感测器可应用於工业的环境检测。

Solvent extraction using crown compounds as extractants is one of the most important separation methods of cesium.

用冠醚化合物作为萃取剂从酸性废液中溶剂萃铯，是目前众多分离手段中最重要的方法之一。

CFCs are used in air conditioning, foam insulation and solvents.

含氯氟烃主要用于空调，泡沫保温材料和溶剂。

The results indicate that improving temperature to reflux, using low polarity solvent as dispersion medium and proper molar ratio of tetrabutyl titanate to stearic acid can bring out good modification. The function of tetrabutyl titanate is to react with the surface hydroxyl groups and adsorbed H2O on the powder particles to produce new binding sites such as M—O—Ti—OC4H9and M—O—Ti—OH, which can easily react with the carboxylic acid. As temperature increases from room temperature to reflux temperature, the reactions between RCOO- and Ti change from coordinate bonds to covalent bonds, which makes the carbon chains of stearic acids more strongly bound with the powder particles surface.

研究结果表明，提高处理温度、适当增加复合改性剂中硬脂酸的量并选用极性弱的有机溶剂可达到比较理想的改性效果；钛酸四丁酯的作用是与粉体粒子表面的羟基以及吸附水反应产生偶联点，如M—O—Ti—OH，这些偶联点易于与羧酸反应；在低温时RCOO-与偶联点的Ti之间以配合物的形式发生作用，在回流温度下处理时，主要发生酯化反应，使硬脂酸更牢固地嫁接到粉体粒子表面，改性效果更好。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。