溴化的
- 与 溴化的 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
In my work, mesoporous lamellar zincum sulfide is synthesized by hydrothermal techniques, with CTAB as templates and Zinc acetate and sulfourea as precursors. The best reactive condition is as follows: the ratio of reactive components is CTAB:Zinc acetate:sulfourea:water=1:3:10:1388; the volume of pH is 4.4; the best hydrothermal parameter is 100℃ for 48h.
以十六烷基三甲基溴化铵为模板剂合成层状介孔硫化锌的最佳反应条件为CTAB:Zn2:(NH2)CS:H2O=1:3:10:1388,pH值范围为3.8-5.8, 100℃下水热48h,此时得到的样品呈现一套层状介孔结构,相应的晶面间距为33.0 A,16.7 A,11.1 A。
-
It was based on the enhancement of the intensity of RLS by the synergistical action of phloxine B,fsDNA and cetyltimethylammonium bromide.
研究了阴离子染料荧光桃红 B对鱼精脱氧核糖核酸和阳离子表面活性剂溴化十六烷基三甲铵的共振光散射光谱有协同增强作用,建立了一种定量测定fsDNA的灵敏度高、操作简便的共振光散射方法。
-
Highly toxi c solvents benzene,tetrachloromethane,methanol were replaced by toluene,1,2-di c hloroethane,ethanol in the course of reaction and purification.
甲基 2 ,1,3 苯并噻二唑的溴化改在低毒性的 1,2 二氯乙烷中进行,革除了高毒性的四氯化碳。
-
At the same time, the intensity ratio of the ICT fluorescence to the LE fluorescence, I〓/I〓, shows a "bell"-shaped variation with increasing CTAB concentration The intensity ratio was found to level off after the CMC of CTAB Together with the data from UV-Vis absorption spectroscopy, electric conductance measurements and the control experiments with tetramethylammonium bromide, it was concluded that the"bell"-shaped variation in the intensity ratio before CMC is due to the formation of premicelle aggregates consisting of ICT fluorophore and CTAB.
此时,ICT荧光强度与LE荧光强度之比,I〓/I〓随CTAB浓度增大而呈&钟形&变化。当CTAB浓度高于CMC时,I〓/I〓为一常数。根据紫外-可见吸收光谱,电导以及四甲基溴化铵对照实验的结果可知,当CTAB浓度低于其CMC时,I〓/I〓的&钟形&变化是由于长链对二烷基氨基苯甲酸与CTAB组成的胶束前簇集体形成所致。
-
Results showed that the synergistic action of brominated epoxy 10% and Sb2O3 3% could improve the limiting oxygen index from 18 to 30 and gave good mechanical performance to PU coatings.
结果表明当溴化环氧用量为10%,在3%的Sb2O3协同作用下,可将聚氨酯涂料的极限氧指数从18提高到30,同时能保证聚氨酯涂料优良的物理机械性能。
-
The cationic surfactant cetyltrimethyl ammonium bromide was used to modify the surface of the supported nano bimetal alloy.
将十六烷基三甲基溴化铵用于负载型纳米二元合金的表面改性,改性后的材料对TCE的还原脱氯性能提高。
-
It was based on the reaction between thiamine and hexacyanoferrate in sodium hydroxide medium to give CL signal,which was enhanced by cetyltrimethyl ammonium bromide.
基于在N aOH碱性中,铁氰化钾可以直接氧化维生素B1产生化学发光,而十六烷基三甲基溴化铵的存在可以大大增强这一化学发光强度,结合流动注射分析技术,在研究并优化化学发光条件的基础上,建立了测定维生素B1的化学发光分析方法。
-
A novel polymerizable amphiphilic compound with self-assembly ability, 4-2-(acryloyloxy ethoxy benzyl tri-ethyl ammonium bromide, was designed and synthesized. It exhibits good water solubility, strong self-association ability and response to extra-stimulation.
设计并合成了一种新型具有自组装功能的可聚合两亲化合物4-2-(丙烯酰氧基乙氧基苯亚甲基三乙基溴化铵,它易溶于水,具有很强的自缔合能力和对外界刺激的响应性。
-
Thus,it is considered as an ideal heat-transport and cold-storage medium.
四丁基溴化铵包络化合物浆是在常压下由TBAB水溶液被冷却到0~12℃时生成的,是一种理想的冷量输送和蓄冷媒体,以固液两相悬浊液的形式存在。
-
In the medium of H2SO4 with KBr as the catalyst, the color of Cresol Red oxidized by iodate can be faded, and the degree of color fading is proportional to the concentration of iodine and the linear range of determination is 20 μg/25 mL~50 μg/25 mL.
在硫酸介质中、在溴化钾催化条件下,碘酸根对甲酚红有褪色作用,且褪色的程度与碘酸根的量有关,碘定量测定的线性范围为20μg/25mL~50μg/25mL,检出限为6.57×10-1μg/25mL,回收率为98.1%~104.2%。
- 推荐网络例句
-
By the time of its fall, most of the prisoners were writers who had written against the corruptions of the government.
到它被攻陷的时候,里面多数的犯人是写了反对政府贪污文章的作家。
-
The most obvious variation to ovum morphological character was that the color was changed from light green to sepiaceous in embryonic development, and all the ovums were almost hatched after 96h.
在胚胎发育过程中卵的形态特征最明显的变化是颜色从淡绿到深褐色,卵在发育96h后卵基本全部孵化。
-
There was a conflict between plebs and patricians in ancient Rome in 494BC.
在公元前494年,罗马发生了一次平民反对贵族的斗争。