湿的

Aqua, Simmondsia Chinensis Seed Oil, Dimethicone, Glyceryl Stearate, Butyrospermum Parkii Fruit, Cyclomethicone, Aloe Barbadensis Leaf Extract, Allantoin, Sodium Hyaluronate, Panthenol, Camellia Oleifera Leaf Extract, Chamomilla Recutita Extract, Glycerin, Ceteth-20, Carbomer, Phenoxyethanol, Propylparaben, Methylparaben.

只强调保湿，镇定的效果，保湿方面有霍霍芭油+乳木果油滋润，水相有甘油，透明质酸，vb5加强湿润的效果，尿囊素，洋甘菊镇定，绿茶抗氧化。有一定量硅助推，只用了gs，c-20做乳化剂，有一点致痘，除了很油的皮肤来说，其他皮肤都适合。

This experiment uses lime carbonate, kaolin clay and starch as filler, uses sorbitol, ethanediol and chitosan as hygroscopic agent, under without foaming and foaming systems conditions, study filler and hygroscopic agent affect on tear strength, tensile strength, moisture coefficient and gas permeability of this film, and research mechanics of ventilation and moisture-penetrability of experiment preparing PE film by SEM.

本实验以碳酸钙、高岭土和淀粉为填料，山梨醇、乙二醇和壳聚糖为吸湿剂，分别在无发泡体系和有发泡体系的PE薄膜中，研究填料和吸湿剂对聚乙烯微孔薄膜的撕裂强度、拉伸强度、透湿系数和透气性能的影响。

Air dryer is a mechanical equipment which can make the moisture(generally means water or other evaporable liquid) in material change into vapor and evaporate by heating, so that the solid material can reach the required humidity ratio.

空气干燥器是通过加热使物料中的湿分(一般指水分或其他可挥发性液体成分)汽化逸出，以获得规定湿含量的固体物料的机械设备。

In present thesis, the mixed-mode interlarninar fracture characters of composite laminate T300/5405 on hygrothermal conditions were investigated using new mixed- mode flexure specimens.

本文采用混合型挠曲试件，对T300/5405单向板在湿热条件下的混合型层间断裂特性进行了试验研究，测试了湿热环境下试件的临界能量释放率，得到了相应的混合型层间失效判据。

It has been found that at room temperature, moisture absorption had little effect on the mixed-mode interlaminar fracture toughness of T300/5405, but at high temperature, the fracture toughness of laminate increased as the moisture content increase.

研究的结果表明：室温时，吸湿量对材料的断裂韧性影响不明显；高温时，吸湿会使得T300/5405的层间韧性增加。

In this paper,characteristics of generating hydrogen from methane wet air catalytic reforming reaction on the premixed chamber wall with Ni katalyst was done with numerical simulatio.

0，对甲烷/湿空气在壁面涂有含稀土的镍基催化剂的微细预混腔中催化重整产氢特性进行了数利用碳氢燃料和湿空气中水蒸气预混催化重整产氢来强化燃烧，以实现微尺度下燃料的持续稳定高效燃烧。

Humidity sensor has been produced using a high adsorption of monoclinic ZrO_2-based nano-materials in the experiment.

实验采用了高吸附性的单斜晶型的ZrO_2纳米材料制作了湿敏元件并测试了元件的湿敏特性。

The wet-heat inactivation of endo- myrosinase s in intact rapeseeds, stability of glucosinolates during heat treatment and the optimal conditions for enzymatic hydrolysis were investigated.

同时对菜籽内源硫苷酶的湿热灭活条件及硫苷的湿热稳定性进行了研究，并优化了酶解的工艺条件。

The results show that the vertical sintering speed changes notably with the proceeding of sintering process. After ignition and thermal retardation the bed permeability deteriorates and the sintering speed decreases notably because of the progress of physical chemistry reaction, formation and broaden of combustion zone, and formation of overwet zone. In about 25 min, the over wet zone vanishes, so the bed permeability meliorates and the speed arises rapidly.

结果表明：垂直烧结速度并非固定不变，而是随着烧结过程的逐步进行发生显著变化；点火保温后，随烧结物理化学反应的进行，燃烧带逐渐形成并变宽且产生过湿现象，导致料层的透气性显著变差，烧结速度显著下降，直至约25 min后过湿层完全消失，透气性变好，烧结速度迅速上升。

Lady you got wet in the corner of the courtyard And your dress oozes and oozes Pitter patter pitter patter I thought of my dark Kali...

女人，你在庭院的墙角哭泣你的裙子湿了又湿劈劈啪啪，劈劈啪啪我想，那是我黑暗的 Kali。。。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。