温度系数
- 与 温度系数 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
Higher temperature gradient, larger heat transfer coefficient and proper heat dissipation from the bottom of crucible are necessary for Bridgman method and also important for optimization of growth technique.
5较大的温度梯度,较大的换热系数和适量的底部冷却是坩埚下降法晶体生长的必备条件,也是工艺优化的重要方向。
-
The cementation factor m or the factor a in Archie's equation are affected by temperature too.
胶结指数m或阿尔奇公式中的比例系数a同样受温度影响。
-
The maximum values of vertical turbulent diffusion coefficient of momentum, temperature and turbulent kinetic energy appear at noon.
在中午前后,动量、温度和湍流动能的垂直扩散系数达到了最大值。
-
The effect of vitriol excess coefficient, reaction temperature and reaction time on the leaching ratio has been studied.
其次是硫酸浸取,研究了硫酸过量系数、酸浸温度和酸浸时间对铁的浸出率的影响。
-
Following optimal operation conditions are found through orthogonal tests: the excess coefficient of added precipitator 1.2~1.3, the pH value at the reaction end 3~4, the reaction time 30min and the reaction temperature 50℃.
通过正交实验,找出了从提取草酸的优化操作工艺条件:沉淀剂的加入过量系数为1.2~1.3,反应终点pH值3~4,反应时间30min,反应温度50℃。
-
The experiment results showed that:in acid pickling process, when reaction temperature is 100℃, the leaching time is 2.5h, mixing speed is 400r/min, the sulfuric acid density of solution is 45% and excess coefficient of sulfuric acid is 1.5, recovery rate of iron from hematite is 82.3%.
实验表明:在酸浸过程中,当反应的温度为100℃,浸出时间为2.5h,搅拌转速为400r/min,溶液硫酸浓度为45%,硫酸过量系数为1.5时,对铁矿中铁回收率可达82.3%。
-
After taking those factors, such as stable combustion and reducing pollutant emissions into account, the following operation parameters are recommended: combustion temperature between 850℃ and 860℃, excess air coefficient of 1.35, secondary air fraction 40% and mass mixing ratio 30%.
综合考虑稳定燃烧和降低污染物排放等因素,得出一系列最佳燃烧参数。燃烧温度应该控制在850~860℃,过剩空气系数应该控制在1.35左右,二次风率应该控制在40%左右,质量掺混比应该控制在30%左右。
-
The waste combustion in the waste bed and the impacts of the waste burning efficiency are complex. In order to solve this problem, the method of numerical simulation has been adopted to simulate waste combustion, and calculate the mass loss rate, moisture evaporation, volatile release, char burning rate. Used the total flow rate of primary air between 50~1 000 Nm3/min to calculate the mass loss, excess air coefficient of waste bed, components of the gas. Calculated results show that the burning efficiency is higher when the total flow rate of primary air is at 517.47~632.09 Nm3/min .
针对垃圾焚烧炉床层内垃圾燃烧过程复杂性及影响垃圾燃烧效率因素多的问题,运用数值仿真方法对某垃圾焚烧炉床层垃圾燃烧进行了模拟,获得了垃圾质量流失速率、水分蒸发速率、挥发分释放速率、焦炭燃烧速率和烟气的温度;并在50~1 000 Nm3/min范围内改变一次风流量,获得了床层质量流失比值、过剩空气系数和烟气中各组分的质量百分比含量。
-
The paper calculates the viscosity coefficient of two-phase solution that contains gas and liquid with the statistical mechanics and dynamics method.
采用统计力学模型对气液两相流体的粘滞系数进行了研究。认为这种模型比一般的液体理论方法直观和简洁,能更好地分析和计算两相流的粘度与其温度、流压及含气率的关系。
-
The results show that the partition coefficient increases with the increase of the temperature and decrease with the pressure.
结果表明,分配系数随着系统压力的降低和系统温度的升高而增大。
- 推荐网络例句
-
Do you know, i need you to come back
你知道吗,我需要你回来
-
Yang yinshu、Wang xiangsheng、Li decang,The first discovery of haemaphysalis conicinna.
1〕 杨银书,王祥生,李德昌。安徽省首次发现嗜群血蜱。
-
Chapter Three: Type classification of DE structure in Sino-Tibetan languages.
第三章汉藏语&的&字结构的类型划分。