温度曲线

The results showed that for a higher temperature a shorter simulation time was needed in order that the linear area in mean square displacement curves could be observed while for a lower temperature a longer simulation time was needed.

结果表明：在较高的温度下，较短的模拟时间内就能观察到均方位移曲线的线性区；而在较低的温度下，需更长的模拟时间。

There will be lots of observational data in the field experiments, the temperature data in the other bores at the same elevation of the leakage passage is selected and curve fitted under the logarithmic equation model. As a result, the radius of the leakage passage can be calculated.

而现场测试试验中有大量温度观测数据，提取与渗漏通道同一高程其它钻孔的温度值，并将这些实验数据在对数函数理论模型下进行曲线拟合，从而可以计算出渗漏通道半径。

The effect of the temperature on the voltammetric curves and on the electrode potential at a carbon fiber microelectrode were studied.

研究了温度对碳纤维微电极伏安曲线的影响及电极电位与温度的关系。

In order to use electron beam in brazing of precise structures and thermo-sensitive materials,accommodating every kinds of curve brazing seams,a vacuum electron beam brazing temperature closed loop control system was developed using PID controller,electron beam scanning track editing and on-line adjusting technologies,real-time acquisition and handling of brazing temperature.

为了将电子束应用于精密构件及热敏感性材料钎焊，以适应复杂形状曲线钎焊缝的要求，采用电子束扫描轨迹编辑及在线调节、钎焊温度实时采集及PID控制器构建真空电子束钎焊温度闭环控制系统。

A kinetics model for martensitic transformation is established based on the fact that the partial derivative of martensitic fraction with respect to temperature is in linear relationship with the partial derivative of free energy difference with respect to temperature.

基于马氏体体积分数对温度偏微分与自由能差对温度偏微分呈线性关系的事实，通过对实验曲线的模拟，提出一种新的马氏体相变动力学公式。

Molecular dynamics simulations of NPT (constant pressure and constant temperature) dynamics are carried out to obtain specific volume as a function of temperature for polyethylene , polypropylene , poly-isobutylene , polyoxymethylene , and polydimethylsiloxane .

用NPT分子动力学模拟来获得聚乙烯、聚丙烯、聚异丁烯、聚甲醛和聚二甲基硅氧烷在不同温度下的特征体积。体积玻璃化转变温度通过对模拟得到的V-T作图的曲线的拐点决定。

The model of programmed crystallization of SPM was proposed based on the moment transformation of the population considering the agglomeration. The optimal temperature-time curves in a batch crystallizer which maximized the terminal mean size and mean weight size can be determined from the application of the Pontryagin Maximum Principle. The calculated crystallization results heating under optimal temperature were compared with ones under linear or natural heating temperature.

根据第四章所得到的螺旋霉素晶体二次成核和晶体生长和布朗扩散引起的聚集动力学，利用第六章所描述的晶体尺寸分布的各阶矩对时间的一阶导数所构成的自封闭的一阶常微分方程组，采用庞得里亚金极大值原理，以温度为控制变量，在满足某些约束条件下，以最大平均尺寸和最大晶体重量平均尺寸为性能指标，计算出了螺旋霉素间歇结晶的最优温度—时间曲线，并同线性加热和自然方式进行了比较。

The result shows: at different temperatures the outcomings obtained in determining dissociation constants with such two theories can be seen effective, but the doubly reciprocal curves of quenching equation are not conformed to quenching curves based on dynamic and static quenching mechanism as those of fluorescence enhancement.

通过荧光和紫外方法研究盐酸左氧氟沙星、氟罗沙星、加替沙星和沃氟沙星四种喹诺酮类药物与人血清白蛋白的作用，在不同温度下对荧光加强和猝灭理论公式的等价性和精细差异进行了比较，结果表明：在不同温度下两种理论公式尽管在求取解离常数上所得结果都可视为有效，但猝灭方程的双倒数图反而不及荧光加强方程的双倒数图与体现动态、静态猝灭机理的猝灭曲线一致。

Based on the order number 10, the quadratic sum of residual error is 533%, the extrapolating result is wrong. But with the order number 9, the quadratic sum of residual error is 0.673%, the result is right

对於表面特定温度为θ(0， t)的曲线，测得其0.0129cm处的温度变化规律反推，选取阶数为10时，剩余误差平方和为533%，外推结果错误，选取阶数为9时，剩余误差平方和为0.673%，外推结果正确。

The result shows the temperature of separation point gets lower and lower as the smolder reaction propagates. And the rules of curve slope of separation temperature of the different heat fluxes in steady reaction zone are quite similar.

结果表明：沿着反应进行的方向，分离点的温度越来越低，不同热流条件下的温度分离曲线斜率在实验稳定发展段的变化规律表现得很相似。

And if officials on the take are not parroting the opinions of these companies, what can we suppose the money they receive is for?

如果受贿的官员不鹦鹉学舌般地复述这些公司的看法，那他们所接受的钱又能用于什么目的呢？

Love them, and love you too, Pitcher.

爱他们，也爱你，投手。