温度

In this article,the laser speckle photography has been used for inspecting the thermal displacement s,which are generated in the weldments made from different metal materials in different temperature intervals.

本文用激光散斑照相法对不同金属材料焊接件在不同温度区间产生的热位移进行了实测，得到焊接部位的热位移随温度的升高而增大，其热应变及热应力亦随温度的升高而增大，且与理论中的分析相符。

In this article,the laser speckle photography has been used for inspecting the thermal displacements,which are generated in the weldments made from different metal materials in different temperature intervals.

本文用激光散斑照相法对不同金属材料焊接件在不同温度区间产生的热位移进行了实测，得到焊接部位的热位移随温度的升高而增大，其热应变及热应力亦随温度的升高而增大，且与理论中的分析相符。

After cooling for a period of time, the temperature distribution of the weldments shows that a lower temperature region exists at both ends, and a higher temperature region exists in the middle of the tube.

结果表明，在焊缝附近形成了一个&T&字形温度场；焊后冷却一段时间后，出现两端温度低、中间温度高的现象。

Default 0 Unit - Symbol tWB Equation (3.31) Function "Soil temperature response, double exponential" TempCoefC Temperature coefficient governing the trigging temperature.

默认值 0.8 单位-符号 tWA 方程式(3.31)作用&土壤温度响应，二重指数& TempCoefB 温度响应函数的系数，仅适用于温度响应为二重指数的情况。

S o the fires to make containers from the volcanic clay must be hotter, they toughs use form than those used for non-volcanic clay.

用火山粘土来制造容器的烧制温度必须比非火山粘土的烧制温度要高很多，其温度有可能要达到 1400 ℃。

In this paper the formula for power calculation of dynamically loadedjournal bearing proposed by the same authors a few year ago is improvedupon to extend to the case of the bearing with an oil groove or oil hole.

本文改进了作者早几年提出的动载荷轴承功率计算公式并把它推广到带油槽或油孔的轴承；从能量方程出发，考虑了包括热传导在内的诸因素，建立了温度平衡公式；提出了从直接计算带油槽或油孔的动载荷轴承全油膜压力分布出发来计算轴承的温度平衡及温度平衡后的流量、耗功、出口油温、平均油温和轴心轨迹的算法。

ResultsThe results showed that drying product had a distinct advantage over solarizing product in quality and price, and the former was 57.1％ higher than the latter in price.

烤房3段变温技术第1段烘干温度控制在35～40℃，烘8～9 h；第2段将温度提高到50～55℃左右，烘烤6～8 h；第3段温度升到60～70℃，烘烤5～6 h左右；烘干总时间不超过24 h。

The results indicated that BaCe0.8Ho0.2O(subscript 3-α) sinters are of single-phase structures of orthorhombic perovskite. In the temperature range of 600~1000℃, the nonstoichiometric materials (x=1.03 and 0.97) have higher conductivities in wet hydrogen and wet air and better performances of hydrogen-air fuel cells than the stoichiometric one (x=1). In this series, BaCe0.8Ho0.2O(subscript 3-α) has the highest conductivities 2.10×10^(-2Scm^(-1) in wet hydrogen, 3.46×10^(-2) Scm^(-1) in wet air, at 1000℃ and the maximum power output density 122 mWcm^(-2 at 1000℃.

结果表明，在600~1000℃温度范围内、湿润氢气和湿润空气气氛中，该系列材料的电导率随温度和钡离子含量的变化均与以该系列材料为固体电解质的氢－空气燃料电池性能随温度和钡离子含量变化的次序一致，即：非化学计量组成材料BaCe0.8Ho0.2O(下标 3-α)(x=1.03， 0.97)具有较化学计量组成材料BaCe0.8Ho0.2O(下标 3-α)(x=1)高的电导率和氢－空气燃料电池输出功率密度，其中BaCe0.8Ho0.2O(下标 3-α)有最高的电导率（1000℃时、在湿润的氢气气氛中：2.10×10^(-2)Scm^(-1)；在湿润的空气气氛中：3.46×l0^(-2)Scm^(-1)）和最大的氢－空气燃料电池输出功率密度（1000℃时：122mWcm^(-2)）。

The temperature probe of Figure 16.9.1 shall be positioned in the outlet box adjacent to the outlet box mounting tabs, as shown, by a mechanical means, to determine the temperature of the branch circuit conductors during the temperature test.

图16.9.1中的温度测试探头应当放在出线盒中靠安装插片旁，采用机械的方式，确定在作温度测试时支路导线的温度。

The suitable range of substrate temperature for diamond growth is also dependent on gas flow ratio of oxygen to acetylene.

不同气体流量比时，衬底温度的范围也不相同，当流量比接近于1时，衬底温度的范围最宽；流量比偏离1时，衬底温度的范围将迅速变窄。

Breath, muscle contraction of the buttocks; arch body, as far as possible to hold his head, right leg straight towards the ceiling (peg-leg knee in order to avoid muscle tension).

呼气，收缩臀部肌肉；拱起身体，尽量抬起头来，右腿伸直朝向天花板（膝微屈，以避免肌肉紧张）。

The cost of moving grain food products was unchanged from May, but year over year are up 8%.

粮食产品的运输费用与5月份相比没有变化，但却比去年同期高8％。