温度

By regression of experimental data, therules of the linkage between these factors, which will provide a theoretical basis for designing BBP with different scales.3 Using thermal analysis technology and dynamic thermogravimetry, the paper studies combustion kinetic characteristics of 3 types of agricultural crops at different rate of temperature rise, and thus, achieved dynamic parameters of these fuels at different rate of temperature, established dynamic model of straw combustion, which reflects the dynamic process in the fast combustion area.4 Characteristics of straw briquette combustion was experimented, focusing on the impact of straw type, temperature, air supply, and density, diameter, and weight of briquette on the combustion speed, and the following conclusions were drawn:(1) combustion of straw briquette fuel is static permeation diffusion combustion;(2) temperature has a larger impact on the speed of straw briquette combustion than air supply; the higher the combustion temperature is, the faster volatilizable component separates out, and the less steady the combustion is;(3) density of briquette fuel has impact on the speed of volatilizable component separation and therefore the combustion speed;(4) increase of diameter and weight of briquette fuel increases the average combustion speed in the initial stage, and that in the later stages is comparatively steady;(5) the proportion of volatilizable component in straw briquette fuel is high, therefore, the temperature control during combustion under the rational ventilation condition is essential to ensure its safe combustion.5 Using the above-mentioned results of experiments and theoretical analysis, and based on thought of hydraulic driven and bi-direction compression, the hydraulic system and compression parts of the HBP BBP are re-designed in terms of industrialization.

利用热分析技术，采用动态热重实验法，对我国的三大农作物秸秆在不同升温速率下的燃烧动力学特性进行了较系统的研究。得到了各原料在不同升温速率下的动力学参数；建立了秸秆燃烧的动力学模型，该模型反映了秸秆迅速燃烧区的动力学过程。 4 对秸秆成型燃料的燃烧特性进行了试验研究。着重研究了秸秆河南农业大学博士学位论文巫的种类、温度、空气供给量、成型燃料密度、直径、质量对成型燃料燃烧速度的影响并得出如下主要结论：①秸秆成型燃料的燃烧方式属于静态渗透式扩散燃烧。②秸秆成型燃料燃烧速度受温度的影响大于通风量燃烧速度的影响：燃烧温度越高，挥发分析出速度越快，燃烧平稳性愈差。③成型燃料密度影响成型燃料挥发分的析出速度，影响燃烧速度。④成型燃料直径和质量的增加，使得燃烧初期的平均燃烧速度增大，中后期的平均燃烧速度相对平稳。⑤秸秆成型燃料含挥发分比例高，因此合理配风下的控温燃烧是保证其完全燃烧的关键。 5运用已取得的试验和理论分析结果，以液压驱动、双向成型为基础，从产业化的角度对HBP型成型机进行了液压系统和成型部件的改进设计；同时采用了二级预压机构，使该成型机的生产率达到 500kg.hd；单位能耗 60kwh。上'左右，磨损件修复周期 300小时左右，基本解决了影响生物质固化技术在国内推广的技术难题。

Bimetal thermometers could be used to measure temperature of ranging from 80℃ to 500℃ on industrial local side instrument.

双金属温度计用于生产过程中温度范围在-80℃~+500℃介质温度的测量。一般为现场介质温度测量的现场检测仪表。

And the axial and horizontal section temperature distributions of simulation were compared with the results of the experiments. They were almost identical except some difference near the heating tubes. The results of the simulation were used to compute the local heat transfer film coefficients on the out surface of vertical tubes at different height.

利用计算流体力学软件CFX-4对层流状态下PBT桨搅拌槽中甘油的温度场进行了数值模拟，并将所计算的轴向、水平剖面温度分布与实验所测量的结果进行了对比，发现虽然在列管附近二者存在着一些差别，但模拟结果基本可以反映槽内温度场的分布情况。

Charcoal is usually the carbon content of less than 75%, we pine, for example, when the temperature reached charring 380 ℃, the carbon content of 76%, the temperature reached 500 ℃, the carbon content amounted to 85% when the temperature reached 600 ~ 700 ℃, the carbon content amounted to 92%.

通常木炭的含碳量小于75%，我们以松木为例，当炭化温度达到380℃，其含碳量为76%，温度达到500℃时，含碳量达85%，当温度达到600～700℃时，含碳量达92%。

The simulation results showed that a nanoclusters coalesces with other ones to a greater degree and the temperature changes greater with the decreasing cluster size at constant initial temperature.

结果表明：相同初始温度条件下，随着团簇尺寸的变小，并合程度升高，并合过程中温度上升幅度变大；对同尺寸团簇，随着初始温度的升高，并合程度提高，处于液态的团簇并合程度明显高于处于固态的团簇的并合程度。

The calling and copulation behaviour of Ancylis sativa Liu had a dielperiodicity.The female moths began to calling at the first day and increasedto 100% at the second day,then the percentage of calling decreasedgradually from the third day to the fifth day,only 16.7% of females showingcalling behaviour at the sixth day.The effect of environmentaltemperature on calling behaviour of Ancylis sativa Liu was studied duringadult life at 16℃,21℃,26℃ and 31℃.The result showed differenttemperature during adult life affected significantly the calling behaviour ofvirgin females.There was considerable variability in the calling patternsamong the different temperature groups,the higher the temperature was,thelater females called,the shorter the calling behaviour lasted.The copulationbehaviour of Ancylis sativa Liu can be divided into following squence:female calling,male responsing,male approaching female,hairpencil displayingand copulating.

枣粘虫求偶和交配行为研究结果表明，在光周期为14L：10D、温度为21℃下，越冬代枣粘虫雌蛾的求偶高峰期为黑暗期6.0-8.0小时，求偶活动以羽化后1-3天表现强烈，第二天求偶百分率高达100％，第4天开始，求偶百分率下降，到第6天仅为16.7％；环境温度对枣粘虫雌蛾的求偶活动有明显的影响，随着温度的下降，求偶高峰期明显提前，求偶高峰期的持续时间变长，在21、26、31℃下，求偶百分率接近或达到100％，在16℃下，仅为43％；枣粘虫的交配行为可分为雌蛾求偶、雄蛾反应、雄蛾接近雌蛾、打开味刷及交配成功等阶段；交配活动也以羽化后前3天表现强烈；第1、2代在黑暗周期中的交配高峰期比越冬代推后1-2.5小时；越冬代枣粘虫的交尾持续时间多为3-4小时，第1、2代比越冬代短；越冬代交尾前期多为2-3天，第1、2代多为1-2天，少数羽化当天便可交尾；雌雄成虫均有多次交尾习性，雄蛾最高交尾6次，平均3.3次，雌蛾最多交尾3次，平均1.5次，在田间自然条件下，大多数越冬代雌雄成虫只交尾1次，第1、2代交尾次数有所增高，第1、2代成虫交配率明显高于越冬代。

Orthogonal experiment was adopted to analyze the effects of vacuum casting processing parameters such as mould temperature,resin temperature,vacuum deaerating time and curing temperature etc.

采用正交实验方法进行实验，研究了微齿轮真空铸型过程中模具温度、树脂温度、真空脱泡时间和固化温度对微齿轮外形尺寸的影响作用。

Theresults indicated that the initial desorption rate of As was higher than As, but thefinal desorption percentage of As was two times higher than As; that in therange of pH(6.5-8.5), the desorption of As was the lowest（pH=6.5）,and thepercentage increased with the pH value increasing or deescalating, but for the As,thepercentage increased with the increase of pH; that the supersonic accelerated desoptionof arsenic and the final percentage was lower than non-supersonic; that on the conditionof UV-light ,in a word, it took negative effect to desorption The"reproduced process"has been used in the procedure of regeneration.

实验结果表明，初始阶段，三价砷的脱附率高于五价砷，但最终脱附率三价砷低于五价砷；三价砷、五价砷在不同温度下的脱附实验表明三价砷的最佳脱附温度低于五价砷的最佳脱附温度；在pH=5.5-8.5时，随着pH的增大，五价砷的脱附率具有先减小再增大的趋势，在pH为6.5时脱附率降至最小；在pH=5.5-8.5时，三价砷的脱附率随pH的增大而增大；不论是三价砷还是五价砷的脱附过程，超声波条件都会促进脱附速率(来源：ecABC论a4文网www.abclunwen.com)的增加，并且最终的脱附率要高于无超声波条件下的脱附率；紫外光照条件下，随着光照时间的增加，两种价态砷的脱附率会达到一个较高的值，再降低。总体而言，紫外光照的存在不利于脱附的进行。

What's more, the begavior of the metals at excessively high temperature also differs from that at normal temperatures and can produce a condition in which the metal deforms slowly and continuously at a constant stress.

另外，在过高的温度下金属的反应也不同于正常温度，过高的温度会引起金属的缓慢变形和金属承受持续的恒定压力。

When it shows the current temperature, and it can show the temperature of the defrosting temperature sensor.

在显示当前温度时按住下键，就会显示化霜温度探头上的温度。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。