温度
- 与 温度 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
Plots of molar volume verses temperature are linear for all samples in the stable liquid region, but there is an increase in the slope〓 with decreasing temperature in the supercooled liquid region, analogous to that observed for C〓 in similar alkali titanosilicate liquids.
将摩尔体积对温度作图,在稳定的液体区内两者为线性关系,随着温度的降低到达过冷液相区,摩尔体积对温度的斜率升高,类似于在相近的碱硅酸盐熔体中观察到的热容的异常现象(Richet and Bottinga,1985;Lange and Navrotsky,1993;Tangeman and Lange,1998)。
-
Studies on the trinitration of toluene showed that, the trinitration temperatures were high enough to intensify oxidation, and the two thermal hazard evaluation methods mentioned above couldn\'t evaluate the situation well. Results were found from the reaction calorimeter experiments that lower reaction temperature and decelerating dosing rate could prevent thermal accumulation and decrease thermal hazard efficiently.
在对三段硝化反应进行热危险性评估时发现,三段硝化反应的温度很高,氧化副反应随温度升高而加剧,风险矩阵法和失控情景分析方法难以准确评估该情况下的热失控危险,但实验结果表明降低反应温度,减缓加料速率能有效地防止热积累,减小反应过程中的热危险性。
-
For thermal properties, Tg values of the 6 series of polyimides containing triphenylamine in the main chain (265-324℃) were lower than 6' series of polyimides containing triphenylamine in the side chain (309-319℃). Besides, for 10% weight loss of two series of polyimides in nitrogen atmosphere showed excellent thermal stability.
热性质方面,6系列的聚醯亚胺玻璃转移温度介於265-324℃,而6'系列的聚醯亚胺玻璃转移温度介於309-319℃,两者的10%热烈解温度显示出良好的热稳定性。
-
Contraposing the 105g piezoresistance acceleration micro sensor of temperature compensation problem,this paper deduce the formula of temperature compensation from the ultimata of temperature compensation.
针对测试105g压阻式加速度微传感器的温度补偿问题,本文从温度补偿的基本原理出发,通过推理和演绎,得出温度补偿公式。
-
Significant interactions between pH and salinity, as well as pH and temperature were found during the germination respectively, otherwise the relationship between salinity and temperature was relatively unapparent.
结果表明, VPJ33的最优培养条件为:pH 8.41、温度34.1℃和盐度2.47%;菌体生长过程中, pH和盐度以及pH和温度对VPJ33生长的交互作用显著,盐度和温度对VPJ33生长的交互作用不显著。
-
At the corner near the punch the severe deformation is observed where equivalent strain and temperature are higher than other areas. Simulation results also show that the container should be heated to avoid the underfilling defect. The conclusions of simulation agree with the experiment results well.
数值模拟结果再现了反挤压试验中的未充满现象,发现影响未充满现象的主要因素是挤压筒的温度,结果表明,在进行挤压试验时应将挤压筒的温度加热到等于试样或低于试样50℃的温度左右,这样可以避免在挤压时出现未充满的缺陷。
-
When the undrawn films were annealed atthose temperatures, the morphologies in the lamellar crystals had change. WAXDand iR studies shown that the crystallinities incrcand, dimensions in (002) and(020) normals increased while that in (200) fold had slight decreases. The rela-tionship between the orientation of the drawn UHMWPE gel-films and the struc-ture changes and the optimum drawing temperature had been disscussed.
通过IR及X-ray衍射等方法研究发现,拉伸前用不同温度退火处理后,凝胶膜的片晶微结构产生明显变化,在对应于超高拉伸温度范围内,其结晶度增加,微晶的c和b轴方向尺寸变大,而a轴方向的尺寸减小,从理论上对这一变化过程作了考察,并讨论了超高拉伸取向性与这些结构变化的关系以及可超拉伸取向性的最佳温度范围。
-
The generations occurred undulatingly and overlap with each other.
豆野螟在自然变温条件下卵的发育起点温度和有效积温分别为10.84℃和53.17日度,幼虫的发育起点温度和有效积温分别为7.84℃和214.90日度,蛹的发育起点温度和有效积温分别为9.48℃和124.41日度。
-
There are two defferent design of hardware: optical fiber temperature sensor is used for middle-voltage Metal-clad switchgear, which data is transferred by optical fiber; another one is 1-Wire Digital Thermometer, it is used for lower-voltage Metal-clad switchgear, and the data is transferred by unwired.
硬件方面设计了两种不同的温度传感系统:中压开关柜过热故障监测采用光纤式温度传感器,同时采用光纤传输数据;低压开关柜采用单总线数字式温度传感器,数据采用无线传输。
-
As the temperature of rat aorta was raised, the vasoconstrictive force and vasoconstrictive speed increased, and the effects of norepinephrine on vasculature were raised. The results suggest that the constant X1 for vasoconstrictive force is a factor sensitive to temperature.
认为NE引起的血管收缩张力的大小,显然也处于温度的影响之下;随着温度的升高,血管收缩张力变大,收缩速率变快,NE对血管的作用效力增强;且张力因子X1是温度敏感因子。
- 推荐网络例句
-
However, as the name(read-only memory)implies, CD disks cannot be written onorchanged in any way.
然而,正如其名字所指出的那样,CD盘不能写,也不能用任何方式改变其内容。
-
Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.
镀锌钢托盘多用于出口,替代木托盘,免薰蒸,符合欧盟、北美各国对出口货物包装材料的法令要求;喷涂钢托盘适用于重载上货架之用,托盘表面根据需要制作成平板状、波纹状及间隔形式,满足不同的使用要求。
-
A single payment file can be uploaded from an ERP system to effect all pan-China RMB payments and overseas payments in all currencies.
付款指令文件可从您的 ERP 系统上传到我们的电子银行系统来只是国内及对海外各种币种付款。