温

Which are from USA for testing the product's temperature;The inductors of anneal、temper are all used multiturn closed coil,the NDT equipment for inspecting weld joint are multicenter digital robotcized ultrasonic testing technology and magnetic particle equipments,and we use full closed、full automatic annoit machinery with environment protecting,and all our main equipments are controlled by computers,so that we can monitor technologic parameter real time.

公司引进美国MTI公司320BX型摩擦焊机，采用世界领先水平的惯性摩擦焊接方法进行焊接；焊缝热处理设备采用中频热处理，以及采用美国雷泰测温仪进行红外测温；退火、回火感应器采用多匝绕制封闭线圈；焊缝无损检测采用多通道数字自动化复合探伤以及磁粉探伤设备；钻杆表面涂油采用封闭、环保、全自动涂油机等等，保证了电脑监控关键设备、实时监测工艺参数，产品质量稳定可靠，深受客户的欢迎。

Similar to 3 above, clean your nostrils at least once every day withwarm salt water. Not everybody may be good at Jala Neti or Sutra Neti

以上三点之外，每天用温盐水清洗鼻孔至少一次，不是每个人都会用专业的清洗鼻腔的办法，但吸口气用力将鼻内物质喷出，最后以棉花棒沾温盐水清洁鼻孔

As for the mesh screen type, its volume multiplied by 100% its porosity was the desirable filling amount. Having considered the forgoing findings, the researchers add up the amounts of the above two types as the filling amount of the composite micro structure, with the filling fluid being acetone. In fabricating the heat spreader, a copper pipe is added to serve the filling purpose. What is more, because the manufacturing process is not carried out in a totally clean environment, there is some noncondensible gas left, which will have a negative effect on the performance of the heat spreader. Consequently, the copper pipe has to be reserved so that the exhaust gases can be evacuated after the filling is done.

Kempers 文中可知，沟槽结构之填充量以微结构体积之80%为最佳，网格结构则是以网格体积乘上孔隙率(porosity，φ)之100%为最佳，故本研究便以两者之加总做为复合式微结构之填充量，填充液为丙酮；在均温基板之制造程序中，会加装一铜管做充填之用，且而由于制造过程并非于一完全干净之环境下完成，故板内会有一些不利于均温基板作用之非凝结性气体noncondensible gas (NCG残留，因此铜管需保留一定的长度，以方便充填完成后将废气排出之用。

There were many adults and nymphae of psocids when the temperature over 15℃ and almost nil under 5～2℃.

在粮温15℃以上时，可以检测到较多的书虱成虫，当粮温降到5~2℃左右时，检测到的书虱密度几乎为0。

In this research project, 60 scapulohumeral periarthritis patients were divided into 2 groups: thermoacupuncture group and acupuncture group.

本研究将临床60例肩周炎患者分为温针组和针刺组，通过对两组病例治疗前后的肩关节运动功能、疼痛评定、肩关节活动度以及临床疗效的观察，以对温针治疗肩周炎的临床疗效作出客观的评价。

This paper presents a temperature testing technique based on fiber-optic transmission and the principle of optical fiber, the coupling between the optical fiber and photoelectrical probe, linear solution of temperature sensitive components.

提出了一种基于光纤传输的温度测试技术，重点介绍了光纤测温原理、光纤耦合和温敏元件的线性处理技术，并分析了表面发射方式的光纤耦合传输特性。

A single-stage and high power pulse tube cooler working between 20~40 K has been designed and constructed in order to precool the second stage of a 4 K separate two-stage pulse tube cooler.

为了满足液氦温区分离型二级脉管制冷机第二级预冷的需要，设计制作了1台20～40K温区单级大功率脉管制冷机。

On the 8th and 9th day of pregnance, the mice received one time of general irradiation of 60Co and γray respectively, the dosage of irradiation was 1.0 Gy;on the 10th day ,the mice were put in hotboxes keeping their rectal temperature at 37±0.5℃, 41±0.5℃ and 42±℃0.5℃ persisting for 3,4 and 5 mins, respectively.

在鼠妊娠第8d，第9d分别接受60Co及γ-射线全身照射各1次，照射剂量1.0Gy；第10d各置温箱中，分别使其肛温保持在37±0.5℃，41±0.5℃，42±0.5℃，并持续3，4，5min。

Prestrain plastic Pan diaphragmless power need to control the temperature to ensure gum gum temperature stable, not aging.

预熔胶锅的电源需配备调压器以控制胶温，保证胶温稳定、不老化。

Temperature and humidity control play important roles in greenhouse environmental control. Engineering calculations of ventilation, cooling, heating, humidification and dehumidification processes can be best described by using psychrometric chart.

温与湿控制是温室环境控制重点，所有涉及空气中任何热性质的计算譬如通风、温、加温与加湿、除湿等，均需用到湿气图。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。