添加物

The results showed that when the catalyst amount was 4 g/L,the molar ratio of L-ascorbic acid to malic acid was 1:3,and the reaction temperature was 55 ℃,the highest L-ascorbyl malate yield of 69.30% could be obtained.

结果表明：添加固定化酶量4g/L，底物配位物质的量比1：3，温度55℃，L-抗坏血酸苹果酸酯的得率最高为69.30%。

Several types of surfactants were adopted to organic solvent mediae in order to investigate the characteristics of cellulose hydrolysis use the carboxymethyl cellulose as substrate.

通过在有机相体系中添加几种不同属性类型的表面活性剂，在此体系中以羧甲基纤维素为底物，研究纤维素酶降解特性。

In this paper,Sn doped ZnO crystals were synthesized by hydrothermal method with 3M KOH as mineralizer.

采用水热法，在ZnO中添加SnCl2.2H2O作前驱物，3M KOH作矿化剂，温度430℃，填充度35%，反应24h，合成了掺杂Sn的ZnO 晶体。

It turned out reproduction rete of chrysanthemum was raised,the regular,non-plant diseases and insect pests could be offered to the market. Shoot tip were used as explants to study the effects of different sterilization methods, illumination intensity and concentrations of 6-BA and NAA on shoot propagation. Rooting with perlite, vermiculite and river sand instead of agar was studied. In the process of preliminary multiplication, the effect of using 0.1% HgCl_2 in sterilization of explants was better than using saturated bleaching solution. The highest multiplication rate was found under whole illumination. MS media with 6-BA from 0.2 mg·L~(-1) to 5 mg·L~(-1) and NAA from 0.05 mg·L~(-1) to 2 mg·L~(-1) were tested and as a result, the highest differentiation rate and the multiplication rate was reached with 0.2 mg·L~(-1) 6-BA, 0.05 mg·L~(-1) NAA.

本实验以菊花的茎尖为外植体，研究了不同灭菌方法，光照强度，全光照、半光照和弱光处理以及不同6-BA和NAA浓度及配比对于试管苗增殖的影响，并研究了珍珠岩、蛭石和河砂等琼脂替代物对于菊花生根的影响，结果表明：在初代培养物建立的过程中采用0.1％升汞进行表面灭菌的效果好于饱和漂白粉的灭菌效果；在全光照条件下外植体的增殖倍数最高；在试管苗增殖培养的过程中，以MS为基本培养基，并在培养基中添加0.2～5mg·L~(-1)6-BA和0.05～2mg·L~(-1)NAA，其中0.2mg·L~(-1)6-BA和0.05mg·L~(-1)NAA最适于外植体的分化和增殖，其分化率为100％，增殖倍数为12。

Finally, the grafting polymerization of textile materials initiated by microwave low temperature plasma was conducted. Knitted cotton fabric was grafted by AMPS first, then knitted cotton and terylene/cotton fabrics were grafted with AMPS/NIPA dualistic monomers respectively. By means of grafting polymerization, the P dualisticintelligent hydrogel was added to textile.The influences of the factors on add-on, such as treatment time and power of plasma, concentrations of crosslinking agent and total monomers, proportion of AMPS, polymerizing temperature and time etc, was studied fully. The optimal conditions of grafting polymerization initiated by microwave low temperature plasma were determined by orthogonal design, variance analysis and mathematical statistics method so as to analyze the main influencing factors. Then swelling/deswelling kinetics, temperature-sensitivity and pH-sensitivity of grafted textile were studied. The performance indexes of hydrostatic pressure, moisture permeability and bursting strength of the knitted cotton and terylene/cotton fabrics before and after grafting were compared and evaluated synthetically.

此后用微波低温等离子体引发纺织材料的接枝聚合反应，分别研究了棉针织物接枝AMPS和棉、涤棉混纺针织物接枝AMPS/NIPA二元单体，使智能凝胶以接枝的方式添加到纺织材料上；详细探讨了微波低温等离子体处理功率和时间、总单体浓度、AMPS单体浓度、交联剂浓度及聚合反应温度和时间等因素对增重率的影响，通过正交设计、方差分析及数理统计对各影响因子进行分析，确定了微波低温等离子体引发接枝聚合的最佳工艺条件；对接枝纺织材料的失水-吸水动力学、温度敏感性、pH敏感性等进行了研究；对接枝前后棉、涤棉混纺针织物的静水压、透湿性和顶破强力等服用性能指标进行了对比和综合评价。

The results show that constitutional phases in the 〓 alloy is the same as that in the 〓 alloy, but phase composition and transformation temperatures of two alloys are quite different. The Ms temperature of the 〓 alloy is lower than-180℃. In order to enable the alloy to be used for making pipe couplings, it is necessary to control Al addition and to increase Ti addition in the alloy. In the 〓 alloy, there exist three constitutional phases: TiNi matrix phase with B19′structure,β-Ta phase and NiTa〓 phase. Transformation temperatures, M〓, Ms, As and A〓, of the alloy are 55℃, 66℃, 94℃ and 109℃, respectively.

结果表明，〓合金显微组织的相组成物与〓合金一样，但相成分明显不同，相变温度相差较大，其Ms温度低于-180℃，要想使该系合金用于制作记忆合金管接头，必须控制铝的添加量并提高合金中的钛含量使合金的Ms温度控制在-80℃～-100℃之间；〓合金是由具有B19'结构的TiNi基体相、β—Ta固溶体和NiTa〓化合物三相组成的，其相变温度M〓、Ms、As和A〓分别为：55℃、66℃、94℃和109℃。

The results showed that the optimum enzymatic conditions were: choosing papain, with substrate concentration 16%, enzyme concentration 4000U/g, hydrolysis time 6h, and the optimum conditions for the enzymatic hydrolysate of porcine blood to synthesize nitrosyl heme-polypeptide were: NaNO2 added 1.6%, pH5.00 and reaction time to 12min at 55℃.

试验表明，以选用木瓜蛋白酶效果较好，最佳酶解条件为：底物浓度16%，加酶量4000U/g，水解时间6h；酶解液合成色素最佳参数为：pH5.00，反应时间12min ，反应温度为55℃，NaNO2 的添加量为1.6%。

The nano-β-FeOOH for precursor of γ-Fe2O3 was synthesized by microemulsion method, then the β-FeOOH was calcined by mixing with additive polyoxyethylene nonyl phenyl ether (NP-4) in the molar ratio of β-FeOOH/NP-4 as 4, 5 and 100 respectively.

采用微乳法合成出氧化铁的前驱体－纳米β-FeOOH，分别以β-FeOOH与添加剂壬基酚聚氧乙烯醚(NP-4)以物质量的比为4， 5， 100添加NP-4，混合锻烧。

The effect of supplementing ammonium sulfate, peptone and yeast extract on the rljGH production was further investigated.

进一步考察了在诱导阶段添加硫酸铵、蛋白胨和酵母抽提物的影响。

These ingredients includes epidermal growth factor, hepatocyte growth factor, dimethyl sulfoxide, phenobarbital sodium and all trans-retinoic acid. We isolate and culture primary 10-weeks-old human fetal hepatocytes, observe hepatocytes form and its function markers. Inoculate hepatocytes with HBV Dane particles to observe if HBV susceptibility of fetal hepatocytes can be induced in vitro. To detect HBV covalently closed circular DNA within hepatocytes, we improve the existent PCR method.

基于上述假设，我们设计了10种培养条件，在自行设计的无血清培养基中添加不同的细胞分化诱导物，包括表皮生长因子、肝细胞生长因子、二甲基亚砜、苯巴比妥钠、全反式维甲酸等，分离孕10周龄人胎肝细胞进行原代培养，观测肝细胞形态及功能指标变化，并定时给予HBV感染，观察能否在体外诱导胎肝细胞出现HBV易感性；为检测肝细胞内HBV共价闭合环状DNA(covalently closed circular DNA，cccDNA)，我们改进了现有的PCR检测法。

Neither the killing of Mr Zarqawi nor any breakthrough on the political front will stop the insurgency and the fratricidal murders in their tracks.

在对危险的南部地区访问时，他斥责什叶派民兵领导人对中央集权的挑衅行为。

In fact,I've got him on the satellite mobile right now.

实际上 我们已接通卫星可视电话了