深冲

In a decision that is both dramatically and cinematically inspired, Travis watches their meeting from the rooftop of a nearby garage, and then drives away.

他冲国火焰奔向他深爱的两个亲人……但他们已经不见了。他的胳膊烧着了，他冲到外面，滚倒在泥地上，然后他跑开了，再也没有看一眼那火，只顾跑，直跑到日出时分。

Sedimentation anyslys of soil under the action of deadweight; 2 Sedimentation anyslys of structure in using; 3 Endogen force anyslys of structure in using; 4 Soil remolding type anyslys; 5 Homogenous flush works anyslys; 6 Anyslys of the structure sedimentation effects of different flushing amount at the same place; 7 Anyslys of the structure sedimentation effects of different flushing places; 8 Anyslys of the structure sedimentation effects of different horizontal flushing places; 9 Anyslys of the structure sedimentation effects of different vertical flushing places; Getting the different between the endogen force of common structure and that of slant structure.

对掏土纠偏过程做了以下9个方面的分析：1、土体在自重作用下的沉降分析； 2、建筑物在使用阶段的沉降分析； 3、建筑物在使用阶段的内力分析； 4、土体受扰动类型分析； 5、均匀冲水施工过程分析； 6、同一个地方冲水量大小不同对建筑物沉降影响分析； 7、不同沉井冲水对建筑物沉降影响分析； 8、进深不同的土层冲水对建筑物沉降影响分析； 9、不同埋深土体冲水对建筑物沉降影响分析。

Changes of erosion and accumulation of the seabed before and after the project The general characteristics of the pattern of erosion and accumulation of the seabed near the scheduled project both before and after the scheduled project are as the following: accumulation occurs at the areas lower than–10 isobath; some suspended sediment is deposited near the coast due to the relatively small tidal current with a monthly accumulation rate of 2-6 mm; while a slight erosion occurs in the areas deeper than–10 isobath with a monthly accumulation rate of .2 mm.

5工程前后海底冲淤变化工程前后海底冲淤相同的地方是：大致沿-10m等深线向近岸呈淤积状态，近岸由于潮流流速小，一些悬沙落淤，月淤积量在近岸附近约2-6mm；而-10m等深线以深基本上呈轻微冲刷状态，月冲刷量一般在0.2mm以下。

J31 Series Straight Side Presses Fixed is my company's traditional products, product stability and durability, with a loaded feature of moduli space, operation, maintenance is simple, suitable for punching, blanking, bending, stretching, correction, cold stamping and other techniques, both deep drawing, strong punching, extrusion and other functions.

J31系列闭式固定台压力机是我公司生产的传统型产品，产品稳定耐用，具有装模空间大特点，操作、维修简便，适用于冲裁、落料、弯曲、拉伸、校正、冷冲压等工艺，兼备深拉伸、强冲裁、挤压等功能。

It tells particularly the debris flow"s the encironment and the development characteristic by numbers . And according to its character , selecting the latest research results at present , the anthor calculates the debris flow"s the moving , dynamical characteristics and the scale , such as , the velocity of flow , the wallop , the peak value flux , and the total flux . And the anthor calculates density in different design frequency by the empirical formula method . In the text, the author uses the modle of evaluating a single gully to evaluate the risk of the debris flow . First , the author calculates the hazard degree in different design frequency , and forecasts the risk range of debris flow in Shenjia gully based on the maximum pile thickness and the total solid amount of a denbris flow . Then , on the basis of the risk range in different design frequency , the author carries out the damageability and risk assessment . The basic purpose of risk management is reducing risk or transferring risk , reducing the loss of life and property . The text constructs the system of risk management of debris flow in Shenjia gully , basis on the condition of Shenjia gully .

本文从地形地貌、地层岩性、地质构造、气象水文等方面系统地阐述了深家沟泥石流的发育环境及发育特征；分别从形成区、流通区、堆积区对深家沟流域特征进行描述；依据泥石流沟自身特点，选用现阶段最新的研究成果，推算了不同设计频率下的深家沟泥石流流速、峰值流量、总流量、冲击力等动力特征和规模数据；并且根据经验公式法来确定深家沟不同设计频率下的泥石流容重；本文采用单沟泥石流风险评价模型对深家沟泥石流进行风险评价，首先对不同的设计频率下的深家沟泥石流进行危险度评价，根据最大堆积厚度与一次泥石流冲出量来预测不同频率下的泥石流危险范围，然后，根据预测的评估范围，评价对应范围内的易损度，最后作出风险评价；城镇泥石流风险管理的根本目的是降低风险或转移风险，减少生命财产的损失，本论文根据泸定深家沟泥石流的具体情况，构建了深家沟泥石流风险管理体系。

The general feature of deformation caused by the collision between two continents also reveals that, during the collision process, apart from a foreland basin and high mountains being formed, there is another compressive depression with an asymmetric structure developed on the side of the obducted plate, which is much easier to be formed when the dip angle of the collisional fracture zone is between 15° and 30° and is the deepest with a dip angle of 30°. This implies that the compressive depression is controlled by both subduction and obduction between two continents.

从大陆与大陆碰挂变形构造特征看，除发育前陆盆地－山脉系统外，在仰冲陆块一侧靠近造山带后缘还发育呈不对称结构的挤压性凹陷，当两个大陆板块碰撞断裂带倾角在15~30°时，该类型凹陷更容易形成，其中以30°倾角对应的凹陷最深，反映其形成可能是大陆碰撞过程中陆块之间相对俯冲和仰冲运动的综合结果。

The rocks were probably situated in the followup obduction of split upper crust cover of the Yangtze Plate onto the North China Plate in or after the subduction of the Yangtze Plates continental materials towards the North China Plate,or were placed by southward thrusting when ultrahighpressure metamorphic rocks underpinned.

通过露头的构造地质分析，推断本套地层是在扬子板块陆壳物质向华北板块下深俯冲过程期间或其后扬子板块陆壳上部盖层继续向华北板块仰冲就位的，在超高压变质岩折返时经历了由北向南的逆冲。

The press process of blanking,drawing, perforating, flaring, trimming are adopted. In this paper, the process suitability of part is analysed. The process parameters, such as blank layout and press force are calculated. The general construction of mold and main parts are designed. The compound die of blanking,drawing,perforating and the simple press tool of flaring,trimming and detail drawings of main parts are drawn.

设计中分析了工件的冲压工艺性，对毛坯排样、冲压力、刃口尺寸等进行了计算，并且对模具相对应的凸模和凹模进行了强度校核，以及模具总体结构、主要零部件的选择与设计，绘制了落料、拉深、冲孔复合模和翻边、切边的单工序模具装配图和模具的主要零件图。

Fidelity Precision tungsten steel main products: tungsten steel punch, tungsten steel liner sets, forming punch, flat thimble, precision rod, tungsten steel book strip, inserts, tungsten carbide drawing die, shrink tube mold, Jian Kou mold, fire nozzle, tungsten steel knife, tungsten steel blank, tungsten steel box, and other precision parts.

富达精密钨钢主要产品：钨钢冲头、钨钢衬套、成型冲头、扁顶针、精密圆棒、钨钢簿长条、镶件、钨钢拉深模、缩管模、剪口模、射咀、钨钢刀、钨钢毛坯、钨钢方块等精密配件。

The result shows that the erosion presents as incision when the riverbed is relative narrow and deep; To the low-water branching reach with strong boundary conditions where the riverbed is wide and shallow, the scour and deposit variation characteristics mainly presents as erosion and deposition adjustment of river island, height deviation of thalweg in the inlets and the adjustment of split ratio after impoundment To the low-water branching reach where the riverbed is wide and shallow and the lateral boundary conditions are weak, the scour and deposit variation characteristics is not restricted to the adjustment of split ratio, and the pattern of the braided reach may even be changed.

结果表明：当河段相对窄深时，河段冲刷主要为下切；当河段为相对宽浅的低水分汊河段且河岸约束较强时，蓄水以后的冲淤变化主要体现为江心洲滩的冲淤调整、汊道深泓高程差的冲淤调整，并引起主支汊分流比的调整；当河段为较为宽浅的低水分汊河段且河岸约束相对较弱时，则冲刷调整不仅限于分流比的调整，甚至会导致大的分汊格局的调整。

This brought fixed cost, but it also is meant at the same time use a source to won't make you singlehanded assume a problem.

这带来了一定的成本，但它同时也意味着使用开源不会让你独力承担问题。

He gained a small fortune in real estate.

他在房地产上发了一笔小财。