涂层材料

The group has established technological innovation center, performance testing center, unconventionality testing center, micro-computer analysis center.

先后设立了技术创新中心，性能检测中心，非常规检测中心、微电脑调漆分析中心；同时与厦门大学联合成立了"厦门大学—鑫展旺涂层材料研发中心"、"厦门大学成果转化中心"、"厦门大学研究生实习基地"。

This paper discusses the performance and the application of the zirconia thermal barrier coating.

文中介绍了氧化锆基热障涂层材料的性能及应用。

Diffluent sericin can be used as coating material for health-care fabrics in finishing, nutritious additives to cosmetics and antioxidants for oil and fatty foods, thus enjoying broad development prospects.

易溶 性丝胶可应用于保健纺织物后整理涂层材料、化妆品美容营养添加剂以及油类食品的抗氧化剂，具有广阔的开发前景。

The results showed that the resistant property to high temperature will be increased as the content of hollow glass-bead increased, flame-retardant effect was evident as the content of fire retardant A was above 20%, tetrachloromethane was the best one as single solvent, and the amount of plasticizing agent was usually at the range of 5%~8

结果表明，随着中空玻璃微珠含量的增加，涂层材料的耐温性能有所提高；阻燃剂A的含量在20%以上时，阻燃效果非常明显；四氯化碳是单一溶剂的最佳选择；增塑剂用量一般控制在5%~8%。

The main wear patterns of coated tool at early age of tool wear are coating drop-off and tool tip breakage.

在工艺优化方面，进行了铣削方式、刀具涂层材料、刀具角度、刀具悬伸量以及切削参数的优选。

RESULTS: The surface feature of each sample showed globular granule with caky structure and air pore. The crystal structure of group A, B, C mainly showed characteristic absorption band of Ca102(PO4)6 which degraded while antimicrobial content increased. Except Ca102(PO4)6 and CaZr (PO4)2, Na6CaP2O9 also appeared in group D.

结果：4组涂层材料镜下表面形貌相似，均为球状颗粒中夹杂&饼状&结构及气孔；A、B、C组晶相主要呈现羟基磷灰石主要成分Ca102(PO4)6的特征峰，且随抗菌剂含量上升，峰值降低。D组除主要呈现Ca102(PO4)6的特征峰外，还出现CaZr(PO4)2、Na6CaP2O9等新相。

Through performing all kinds of anti-corrosion and anti- abrasion experiments,the ways of surface oxidation process and anti-corrosion coat materials of air propeller are selected in this article according to self-protection property of the air propeller used on certain ship.

根据空气螺旋桨在某船上的自身防护特点，通过耐腐蚀、耐磨蚀等各种实验，对空气螺旋桨桨叶表面氧化处理工艺和表面防腐涂层材料进行了筛选。

Effect of various parameters on the melting degree and deposition efficiency of feedstock has been investigated.

研究了各种工艺参数对涂层材料熔化程度和沉积效率的影响。

Therefore, Compared with the traditional oxygen-acetylene flame spray technology, the advantages of RFSS lied in simultaneous synteesis and deposition of expensive coating materials from an in-situ reaction of cheap raw materials.

在到达工件表面时，反应已基本结束。因此，与传统热喷涂相比，反应火焰喷涂的优势在于，利用廉价原料一步合成、沉积比较昂贵的涂层材料。

The project for passenger cars with engine piston aluminum alloy, alloy components through optimal design, rare earth - Modification of phosphorus salt air and bottom melting slabs, metal-cast aluminum piston at the end of riser feeding process, heat treatment process parameters of choice , Nano-Detroit surface coating materials, such as key technology research and development with a density of small, light weight, thermal conductivity, and coefficient of thermal expansion of small, high temperature and have sufficient strength, wear and corrosion resistance , Aluminum piston size and good stability, its integrated technical indicators have reached the leading domestic level.

项目介绍（简介、技术特点、应用范围、市场前景、效益分析及对投资者要求。500字以内）本项目针对乘用车发动机用铝合金活塞，通过合金成分优化设计、稀土－磷盐复合变质处理与炉底透气砖熔炼技术、铝活塞金属型铸造底冒口补缩工艺、热处理工艺参数的选择、纳米级活塞表面涂层材料等关键技术的研究，开发出具有密度小、质量轻、热传导性好、热膨胀系数小，并具有足够的高温强度、耐磨和耐蚀性能、尺寸稳定性好的铝合金活塞，其综合技术指标达到国内领先水平。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。