涂层

The erosion and thermal shock of coating is tested, the result indicated that the abscission rate of coating which load active agents is less than 5%.

考察了改性后载体涂层的冲蚀和抗热冲击性能，负载活性组分后的涂层脱落率均小于5％。

It is shown by the results of the test in the low temperature condition, that the efficiency of the flat-plate solar collector is mainly depended on the absorptance of the collector coating.

国外太阳能集热器的产品，不少已采用选择性涂层，这种涂层对波长0.3一2.5微米的太阳辐射能的吸收率a甚高，而对波长2.5一40微米的热辐射，其发射率只却很低。

In this paper,a summarization has been made to the research developments of adhesive force between organic coating and metal substrate,and the effects of different pretreatments to metal surface.

本文介绍了有机涂层/金属基体附着力理论的研究进展，探讨了金属表面预处理对涂层附着力的重要影响，并介绍了目前国内外金属表面预处理方法的最新研究动态。

The top bus bars is adjacent the top edge of the coating and the bottom bus bar is adjacent the bottom edge of the coating with both bus bars outside of the vision area.

所述顶母线毗邻所述涂层的顶边，所述底母线毗邻所述涂层的底边，两个母线均位于所述视区之外。

The perfect coating agents were prepared by use of the Mini-tab DOE anlysis experiment with the ratio of nano-tuber PANIs and the hydrochloric PANIs,the dosage of CNT adulterant,the dosage of bonds and the dosage to fabric.

利用对整理剂用量的单因数工艺实验，对涂层织物的表面比电阻和微波屏蔽性能进行了分析，优化涂层织物的最低表面比电阻使之达到16Ω，整理后织物的导电性大大提高。

Three methods,the electrophoresis aggradation,brushed coating and water cooking method were presented to deposit MoS2 coatings in the material surfaces,and the deposited mechanisms were analyzed.

选用电泳沉积法、刷涂法和水煮法3种方法在材料表面制备了二硫化钼涂层，并探讨了3种方法形成涂层的机制。

UV curable coating was used as the dispersion system. The effect of PMMA microspheres, PMMA/TiO2 nano-composite particles and dulling agent on the antiglare property, the viscosity, the mechanical property, as well as the chemicals resistance of the film was studied in this paper. The result showed that the film had better comprehensive property when 0.5% PMMA microspheres, 0.5% PMMA/TiO2 nano-composite particles and 0.75% dulling agent were doped.

紫外光固化体系成膜速度快、涂层透明性好、力学性能优良，本文采用此体系固化成膜，考察了PMMA微球、PMMA/TiO2纳米复合粒子和消光剂对薄膜防眩光性能、涂料黏度、涂膜力学性能以及耐化学药品性能的影响，确定了防眩光涂膜材料涂层的粒子配方：0.5%PMMA微球、0.5%PMMA/TiO2纳米复合粒子和0.75%消光剂。

Such as angle grinder, wire brush, needle beam pneumatic rust, and wind knock rust hammers, gear-type rotary rust, etc., are semi-mechanized equipment, tools, light, mobility, and to more thoroughly to rust , old coatings, the coating can be played on the shelf hair treatment, significantly more efficient than manual derusting increased up to 1 ~ 2m2 / h, but can not remove the oxide skin, the smaller surface roughness and can not achieve high-quality surface to deal with quality, ergonomic handle lower than the jet.

如角向磨光机、钢丝刷、风动针束除锈器、风动敲锈锤、齿型旋转除锈器等，属于半机械化设备，工具轻巧、机动性大，能较彻底去除锈、旧涂层等，能对货架涂层进行打毛处理，效率比手工除锈大大提高，可达1~2m2/h，但不能除去氧化皮，表面粗糙度较小，不能达到优质的表面处理质量，工效较喷射处理低。

Corrosion resistance and adhesive force to coating of works could increase strongly by seal treatment to bluing works in silane coupling agent.

用该封闭剂对发蓝工件进行封闭处理后，能明显提高工件的抗蚀性和对涂层的附着力，解决了因皂化和铬酸盐钝化而带来的涂层附着力较差和环境污染等问题。

Addition of electrical conductive fiber to the radar absorbing coating of carbonyl iron powder has been studied.

本文研究了在羰基铁粉吸波涂层中添加导电纤维对涂层的电磁参数和反射率的影响规律。

The labia have now been sutured together almost completely.The drains and the Foley catheter come out at the top.

此刻阴唇已经几乎完全的缝在一起了，排除多余淤血体液的管子和Foley导管从顶端冒出来。

To get the business done, I suggest we split the difference in price.

为了做成这笔生意，我建议我们在价格上大家各让一半。