涂剂

To improve the properties of coatings formed from those PUD, different chemical crossfinkers and additives were used.

最后，初步探索了提高TP系列涂膜性能的方法，对用交联剂提高涂膜抗水性做了探讨。

Wetter was found to be a key to coating preparation. It not only wetted and dispersed metal powder but also acted as reductor during the period of sintering.

得出润 湿剂是关键性的组份，在涂液配制和涂覆时润湿分散金属粉，而且在烧结过程中作为还原剂。

Sponge coating, this process for the stone surface, the more light can be more evenly coated with repellant.

海绵涂，这种工艺用于石材较光的表面，能较为均匀的涂上防护剂。

6 As for all machined surfaces without protective paint, metal protector or grease should be applied to avoid serious rustiness.

6对于所有机械加工的未涂防护漆的表面，应涂上金属防护剂或油脂，以防严重生锈。

In particular, be warned that the back-coating liquid required specialized modulation, do not add the waxiness class as smoothing for cigarette packaging can easily lead to failure in the poor, some cigarette packaging business card printing and membership card making businesses use diluted with water of a normal back-based UV-oil fluid posive this kind of quality issues.

不入格需给示意的是，不不背涂液需附带调制，不成补充蜡质类的滑爽剂，否则便当引起烟包包装黏分不牢，有些烟包制卡和会员卡制作企业搁置以火浓缩后的别致火性平油怠工不不背涂液，不离便当呈现此类质度题目。

Alkyl siloxane is good lubrication, water-resistance, anti-fouling, anti-tacking, printable, and strong affinity to organic materials, especially for its low wear-out, low friction coefficient and high susceptibility of additives that used as lubrication. Besides, it has the excellent properties in printing, impression and paint that used as mold-release agent. Therefore, alkyl siloxane is applied widely and researched thoroughly.

长链烷基硅油具有优良的润滑性、憎水性、防污性、防粘性、可涂印性及对有机材料的亲和性，尤其作为润滑油使用时，具有低磨损、低摩擦系数及对添加剂感受性好等优点；作为脱模剂使用时，不仅使用效果优异，而且不妨碍产品表面随后进行的印刷、压印及涂漆，因此得到广泛得开发和应用。

The results indicated that the UV coatings made from epoxy acrylate resin/TPGDA monomer by the weight ratio of 80/20, and 3% dosage of benzil dimethyl ketal photoinitiator had an excellent films properties such as hardness, tensile strength, gloss and weatherability, while it possessed a poor impact resistance and adhesion of films.

试验结果发现，以预聚合体/单体比例为80/20、单体种类为二丙烯酸三丙烯乙二醇酯、光引发剂Benzil dimethyl ketal添加量为3%调配而成之UV涂料，其涂膜硬度、拉伸强度、光泽度及耐候性等性质优良，但涂膜耐冲击性、附著性不佳。

Then membrane"s properties of polymer were studied via different dosage and adding ways of MATS. While the MATS" amount is 5% of polysiloxane, its hydrophile angle is bigger than 90?

其次研究了硅烷偶联剂MATS对乳液膜性能的影响，MATS用量为聚硅氧烷的5％，涂膜润湿角大于90°，涂膜的憎水性好。

In order to study the mechanism of macromolecule deterring propellant on changing burning law,the polymerizing conditions,mechanical and thermal decomposition performance of coating-layer is studied.

通过改变聚合方式、温度、时间、引发剂、聚合界面的方法，探讨了涂覆层的聚合工艺；通过材料试验机试验和热分解试验，研究了聚二甲基丙烯酸乙二醇酯涂覆层在不同温度下的力学性能及其热分解规律。

The basic component of film and the concept of critical pigment volume percent of of water finish were discussed.

本文介绍了水溶性涂饰剂涂膜的基本组成，以及临界颜料体积浓度的概念。

On the other hand, the more important thing is because the urban housing is a kind of heterogeneity products.

另一方面，更重要的是由于城市住房是一种异质性产品。

Climate histogram is the fall that collects place measure calm value, cent serves as cross axle for a few equal interval, the area that the frequency that the value appears according to place is accumulated and becomes will be determined inside each interval, discharge the graph that rise with post, also be called histogram.

气候直方图是将所收集的降水量测定值，分为几个相等的区间作为横轴，并将各区间内所测定值依所出现的次数累积而成的面积，用柱子排起来的图形，也叫做柱状图。