浸渍

Their HERITAGE Collection is made entirely of Selvage Denim only , produced on 30 looms and dyed by LOOP Dyeing method. With a minimum of 16 dips, they go upto 30 dips .

它们的 HERITAGE 系列完全采用赤耳牛仔布，用30寸宽的织布机，采用循环染色的方法，最少进行16道浸渍，多的经过了30道浸渍。

A new method to evaluate on site the waterproofing effect of silicane immersed concrete by way of measurement of surface soakage is proposed,which has been tested and studied to assess its evaluation results of the water—proofing performance of different types of silicane immersed concrete.

摘 要：提出了一种新的硅烷浸渍混凝土防水效果的混凝土表面吸水量现场评价方法，并试验研究了这种方法对不同的硅烷浸渍混凝土防水性能的评价效果。

A new method to evaluate on site the waterproofing effect of silicane immersed concrete by way of meas urement of surface soakage is proposed,which has been tested and studied to assess its evaluation results of the water proofing performance of different types of silicane immersed concrete.

提出了一种新的硅烷浸渍混凝土防水效果的混凝土表面吸水量现场评价方法，并试验研究了这种方法对不同的硅烷浸渍混凝土防水性能的评价效果。

The results show that the optimum preparation conditions of CuO/AC catalyst are as follows:the concentration of Cu（NO3）2 is 3%,soakage temperature 30 ℃,soaking time 6 h,calcinating temperature 300 ℃,and calcinating time 3 h.

研究结果表明，硝酸铜-AC制备CuO/AC催化剂的最佳条件为：硝酸铜质量分数为3%，浸渍温度为30 ℃，浸渍时间为6 h，焙烧温度为300 ℃，焙烧时间为3 h。

The anti-oxidation effect is not remarkable when the composite is alone pre-impregnated in HBO2 or TESO soaker. The anti-oxidation property is good for the composite pre-impregnated in H3PO4 or H3PO4+HBO2 mixed solution soaker. The mass loss rate oxidated at 900℃ for 2h are 0.40% and 0.33% respectively.

单独预浸涂以硼酸或TEOS为主的浸渍剂后，试样抗氧化效果不明显，而预浸涂以磷酸或磷酸+硼酸混合液为主的浸渍剂效果较好，900℃，2h静态氧化质量损失率分别为0.40%和0.33%。

The method for manufacturing the filter includes the steps of immersing a supporter in a suspension in which the powder of the fraipontite mineral and the powder of an inorganic substance as a binder are dispersed as the suspensoid, and drying the supporter impregnated with the suspensoid, thereby forming an inorganic material layer fixed to the surface of the supporter.

制造该过滤器的方法，包括将载体浸渍在悬浮液中的步骤，在该悬浮液中将丝锌铝石矿物粉末和作为粘结剂的无机物质粉末分散成悬浮肢体，和干燥用该悬浮胶体浸渍过的载体的步骤，从而制成固定到载体表面上的无机材料层。

The results show that the dissoluble tungstate can be impregnated into the pores of C/C composite materials....

研究结果表明，用浸渍法可将可溶性钨酸盐浸渍到炭/炭复合材料的孔隙中，将浸入炭/炭复合材料中的钨酸盐还原成金属钨可以在一定程度上改善炭/炭复合材料在X射线下的可视性。

While in the experiments of impregnated raw materials, the main factors are sieve of wood flour, impregnated ratio and time.

在主要工艺参数对成板性能的影响关系中，研究结果表明，主要影响因素为木粉目数、原料含水率和热压温度；在浸渍处理模压实验中，主要影响因素为木粉目数、浸渍时间和液料比。

The method comprises the steps of dipping and mixing the mipor asphaltic base globular active carbon prepared by the traditional method with an inorganic metal salt solution by a certain ration; heating under an inert atmosphere to 600 to 1200 DEG C at a temperature increasing rate of 1 to 20 DEG C/min for the secondary carbonization; using acid to wash off the remaining metal inside the carbonized material, so as to obtain the asphaltic base globular active carbon with a high mesoporous rate and narrow distribution of mesoporous spertures.

本发明提供了一种浸渍金属盐二次炭化制备中孔沥青基球形活性炭的方法，该方法是将传统方法制备得到的微孔沥青基球形活性炭按一定比例与无机金属盐溶液浸渍混合，然后在惰性气氛下以1～20℃/min的升温速率加热到600～1200℃下进行二次炭化，炭化料经酸洗除去内部残留的金属后，可制得中孔率较高、中孔孔径分布窄的沥青基球形活性炭。

The structural and photocatalytic properties of TiO〓 as well as surface acidity were greatly improved by sulfation. SO〓〓/TiO〓 solid superacid with Hammett constant Ho less than -12.14 was prepared by treating the TiO〓 with 1.0mol. L〓 sulfuric acid solution and then calcining at 450℃ for 3h. When compared to unmodified TiO〓, the SO〓〓/TiO〓 superacid catalyst exhibited higher anatase content, smaller crystal size, higher specific surface area, centralized pore size distribution, and the blue-shifted band edge of uv-vis adsorption spectra. Furthermore, the SO〓〓/TiO〓 superacid also showed excellent reaction activity and stability for CH〓Br photocatalytic decomposition even under the moist reaction conditions. The apparent quantum efficiency of SO〓〓/TiO〓 was 10 times of that of TiO〓 catalyst for the photocatalytic degradation of bromomethane. Therefore, the SO〓〓/TiO〓 superacid catalyst is promising for practical application in environmental remediation.It was found that both L and B acid sites exist on SO〓〓/TiO〓 photocatalyst while only L acid sites on TiO〓 photocatalyst. On the basis of experimental results, the synergistic model of superacidic centers was proposed for SO〓〓/TiO〓 photocatalyst to explain the photocatalytic behavior and the mechanism of superacidifing effects, assuming that the adjacent L and B acid sites induced by SO〓〓 comprise cooperatively the superacidic center on superacid photocatalyst. The group cooperation of the superacidic center could strengthen the surface acidity, increase surface acid sites and the adsorbtion of O〓, promote separation of photogenerated electron-hole pair, enhance the interfacial transfer of charges and reversibility of water adsorption. Consequently the excellent photocatalytic activity, reaction stability and resistibility to humidity of SO〓〓/TiO〓 superacid photocatalyst may attributed to the group cooperated effect of the superacidic center on the photocatalyst.

研究结果表明：SO〓〓与TiO〓表面的结合为螯合式双配位结构；TiO〓光催化剂表面经H〓SO〓浸渍处理后，提高了表面酸性，改善了催化剂结构和光催化性能，当H〓SO〓浸渍浓度为1.0mol.L〓、烧结温度为450℃时，可制得SO〓〓/TiO〓超强酸催化剂(H〓＜-12.14)，其结构和光催化活性得到明显改善，与TiO〓相比，SO〓〓/TiO〓光催化剂的锐钛矿含量高、晶粒小、BET比表面积大、孔径分布集中、光谱吸收边蓝移，具有优异的光催化氧化活性、稳定性及抗湿性能，光催化降解溴代甲烷的表观量子效率比TiO〓催化剂提高了一个数量级，是一种有实际应用前景的高效光催化剂；由此提出了SO〓〓/TiO〓超强酸催化剂表面集团协同作用的超强酸中心模型，认为在SO〓〓/TiO〓超强酸催化剂表面，由SO〓〓诱导的相邻L酸中心和B酸中心组成了集团协同作用的超强酸中心，其集团协同作用显著地增强了催化剂表面酸性、增大了表面酸量及O〓吸附量、促进了光生电子和空穴的分离及界面电荷转移，具有可逆吸附水的性能，是SO〓〓/TiO〓超强酸催化剂具有优异的光催化氧化活性、很好的活性稳定性及抗湿性能的重要原因。

The absorption and distribution of chromium were studied in ryeusing nutrient culture technique and pot experiment.

采用不同浓度K2CrO4(0，0.4，0.8和1.2 mmol/L)的Hoagland营养液处理黑麦幼苗，测定铬在黑麦体内的亚细胞分布、铬化学形态及不同部位的积累。

By analyzing theory foundation of mathematical morphology in the digital image processing, researching morphology arithmetic of the binary Image, discussing two basic forms for the least structure element: dilation and erosion.

通过分析数学形态学在图像中的理论基础，研究二值图像的形态分析算法，探讨最小结构元素的两种基本形态：膨胀和腐蚀；分析了数学形态学复杂算法的基本原理，把数学形态学的部分并行处理理念引入到家实际应用中。