测量误差

In this paper, according to the characteristics of central projection, aerial photograph s were analyzed to discuss displacement of images under tilt conditin or caused by ground undulation, based on which the principles of tilt error and projection error were summarized.

本文以航空摄影测量像片为分析对象。根据中心投影的特性，论述了像片在倾斜条件下所引起的像点位移和像片因地面起伏而引起的像点位移，在对其进行分析的基础上总结出倾斜误差和投影误差的规律，从而说明了不能把像片当作地形图使用。这是使用航空像片时必须注意的基本问

The influence vectors F〓(the column vector of reliability matrix) and the residual vector V are regarded as the analysis factors instead of γ〓 and ν〓, the correspondence coefficient of F〓 and V is as the parameter to snooping the outliers.

提出了观测量随机模型的误差分析方法和理论，研究了随机模型系统误差和粗差的消除方法，同时研究了高精度GPS平差处理中随机模型的建立方法。

Based on this theory and method, this paper presents a new method and model for the SREM in-process measurement, which satisfies the need of real-time error compensation.

本文在此基础上，提出了机床主轴回转误差实时测量的方法和模型，满足了实时误差补偿的需要。

The experimental results show that a good linear relation between TCD response to the partial pressure of deuterium is obtained.

实验结果表明，TCD对氘的响应与氘的压力呈良好的线性关系；对已知氘丰度为1%~90%的氕氘混合物样品进行了测定，测量结果的误差与气氛混合气体中的HD丰度成正比，绝对误差范围在

In the thesis, the error analysis of the instruments and error correction curve is presented, so the measurement accuracy is relatively high.

论文中分析了仪器的误差，并画出了误差校正曲线，以达到提高了测量精度的目的。

And a kind of pulse equivalence method used to measure dividing error was offered, which can be used as a way to get the error curve and self-diagnosis in case of lack high precision measuring instruments.

提出了一种脉冲当量法用于检测分度误差，在缺乏高精度测量设备的情况下，可以作为得到误差曲线的一种手段，也可以作为产品检定以前的自检。

It is shown that the measurement uncertainty is mainly from the fitting error of calibration regression curve and the error of element concentration in the standard films.

计算结果表明，XRF测定中无机元素薄膜标样示值误差和工作曲线拟合误差是测量结果不确定度的主要来源。

First of all, according to the length of Hole and equipment configuration to specifications through bad error limit based on the design of the tunnel control point measurement, the number of target and observational accuracy requirements, and plans to link up on the design and error estimation.

首先根据洞子长度和仪器配置情况，以规范要求的贯通误差限差为依据，设计隧道控制测量的点位、数量、精度指标和观测要求，并且要进行图上设计和贯通误差估算。

Combining with the optimization method for the first time, error estimation of the traditional five-sample phase shifting algorithm is studied.

针对移相法相位测量过程中的移相误差，结合优化的方法研究了传统五步移相算法的误差估计。

Combining with the optimization method for the first time, error estimation of the traditional fivesample phase shifting algorithm is studied.

针对移相法相位测量过程中的移相误差，结合优化的方法研究了传统五步移相算法的误差估计。

We have no common name for a mime of Sophron or Xenarchus and a Socratic Conversation; and we should still be without one even if the imitation in the two instances were in trimeters or elegiacs or some other kind of verse--though it is the way with people to tack on 'poet' to the name of a metre, and talk of elegiac-poets and epic-poets, thinking that they call them poets not by reason of the imitative nature of their work, but indiscriminately by reason of the metre they write in.

索夫农 、森那库斯和苏格拉底式的对话采用的模仿没有一个公共的名称；三音步诗、挽歌体或其他类型的诗的模仿也没有——人们把&诗人&这一名词和格律名称结合到一起，称之为挽歌体诗人或者史诗诗人，他们被称为诗人，似乎只是因为遵守格律写作，而非他们作品的模仿本质。

The relationship between communicative competence and grammar teaching should be that of the ends and the means.

交际能力和语法的关系应该是目标与途径的关系。