浇注

The experimental results indicated that the longer the po uring intervallic time of the two kinds of molten metal and the higher the heigh t of the molten iron to pour into the tip of dipper teeth , the narrower its tran sitional zone will be, on the contrary, the wider its transitional zone will be.

用不同粘度的流体通过水力模拟的方法近似地描述了双金属斗齿过渡区的混合状态。试验结果表明：两种液体浇注的间隔时间越长，先浇入的铁液液面越高，过渡区越窄；反之，过渡区越宽。生产中为了保证过渡区双金属的结合质量，应控制较高的铁液液面高度及一定的双液间隔时间

Isocyanurate based on TDI was synthesized and the heat-resistance property of casting polyurethane elastomer which synthesized using isocyanurate based on TDI and PEPA was obviously enhanced compared to polyurethane elastomer which did not introduce the isocyanurate by the TGA under the different temperature and the mechanics performance maintenance rate at high temperature.

在催化剂作用下，合成了TDI-100型异氰脲酸酯，并与己二酸乙二醇丙二醇酯合成了浇注型聚氨酯弹性体，通过不同温度下的热失重分析和弹性体的力学性能高温保持率对比分析表明，在TDI型聚氨酯弹性体中引入异氰脲酸酯基团，可明显提高弹性体的耐热性能。

Result shows that the pouring techniques of concrete have little influences on workability, slump, spread, surface crack and temperature control, but more on laitance.

结果表明，混凝土浇注工艺对和易性、坍落度、扩展度、表面裂缝、温度控制影响较小，对浮浆的影响较大；均匀振捣与超振剪力墙的浮浆厚度较大，抽芯试样强度合格，未振捣的剪力墙的浮浆厚度较小，但抽芯试样强度不合格；每层浇筑厚度宜控制在0.8～1m，且均匀布料振捣，该值能为现行规程的修订与完善提供试验数据参考。

Five full-scale reinforced shear wall models are tested to study the influence of five different thicknesses of pouring layers and vibrating modes on laitance thickness, shrinkage crack and control of strength and temperature of C70 high strength concrete shear walls.

摘要］对5片大型配筋剪力墙进行足尺模型试验，研究5种不同分层浇注厚度及振捣方式对C70高强混凝土剪力墙浮浆厚度、收缩裂缝及强度、温度控制的影响。

In the last , we prepared clay-modified composites of fiber glass build - lipping thermo hardening resin matrix.The experiment result demonstrated that the organic clay can shorten the Gel-time of pure epoxy resin in a little scale, but have little infection to its viscosity at the same temperature.

最后，用已确定的、制备出浇注体性能最佳的有机粘土用量及工艺组合，制备出粘土改性的热固性树脂基玻璃纤维增强复合材料，并对其性能作以考察。

The case is not much better in regard to the parabolical interpretation, which would discern in the pouring out of the wine a mere parable of the shedding of the Blood on the Cross.

案件并非好得多至於以parabolical解释，这将看出，在浇注出来的葡萄酒只占寓言卸下的血在十字架上。

The case is not much better in regard to the parabolical interpretation, which would discern in the pouring out of the wine a mere parable of the shedding of the Blood on the Cross.

案件并非好得多至于以parabolical解释，这将看出，在浇注出来的葡萄酒只占寓言卸下的血在十字架上。

The main products are: series and high aluminum phosphate, clay, acid-resistant, wear-resistant series, periclase, spinel series; magnesium branded series, lightweight insulation series, and a variety of on line monolithic castables, ramming play materials and the production and supply of raw materials.

主要产品有：磷酸盐系列及高铝，粘土，耐酸，耐磨系列，方镁石，尖晶石系列；镁烙系列，轻质保温系列，及多种上不定形系耐火浇注料，捣打料及各原材料的生产和供应。

By two steps, the material is obtained by the method that polyhydric alcohol, diisocyanate and a diatomic alcohol chain extender with 8-18 C-structural branch chains are mixed and poured into a polyurethane elastomer that achieves a damping effect through the combination and dissociation of a hydrogen bond between the branch chain and the main chain for consuming energy.

该类材料是通过两步法将多元醇、二异氰酸酯和带有8～18个C结构支链的二元醇扩链剂混合浇注成聚氨酯弹性体，通过支链与主链之间氢键的结合与解离消耗能量，起到阻尼效果。

Do type transformer pouringly for thin insulation colophony only compulsive wind is cold use, can make transformer refrigeration adds a look, overweighted 40 ％ move, also can supply other equipment ventilated deserve to use.

专供薄绝缘树脂浇注的干式变压器强行风冷应用，可使变压器冷去增容，超载40％运行，亦可供另外配置透风配用。

I can not make it blossom and suits me

我不能让树为我开花

When temperatures are above approximately 80 °C discolouration of the raceways or rolling elements is a frequent feature.

当温度高于 80 °C 左右时，滚道或滚动元件褪色是很常见的特征。