流电的

The current for pantograph shall be increased especially for the metro vehicle equipped with the third rail current collector.

需要增加受电弓受流，特别是对采用第三轨受流器的地铁列车。

It is characterized by anodic without a cotton package to store plating fiuid, plating anodes and the workpiece maintaining a certain space, and plating fluid circularly pumped to flow plating working area.

本文研究了电刷镀流镀的阳极材料，设计了流镀界面，并通过正交试验优化了流镀工艺参数，进行了产业化应用。

First,we perfuse puerarin to the brain slice which electricity activity is better,one concentration per one brain slice,the result shows that the puerarin has conspicuous depressant effect to the hippocampal,s spontaneous discharge act,the mian abaissement modality is to cut down the frequency,but the effect to the amplitude is very little.

首先，在电活性较好的脑薄片上进行单一的葛根素灌流实验，结果表明，葛根素对海马神经元的自发放电活动有很明显的抑制作用，其抑制方式主要是降低了了海马神经元生理电的发放频率，而对发放的幅度影响则很小。

The article analyses angle distribution of radiant energy flow density and angle distribution of radiant power when an electric dipole is oscillating along polar axis in magnetic anisotropic medium,also compares them with the expression of that in isotropic medium;thereby,a theoretical basis for more effectly using electric isotropic and magnetic anisotropic medium is obtained.

分析振荡电偶极子在各向异性磁媒质中沿极轴振荡时其辐射能流密度的角分布和辐射功率的角分布情况，并与各向同性媒质中振荡电偶极子沿极轴振荡时辐射能流密度的角分布和辐射功率的角分布情况进行对比，得出更有效地利用电各向同性磁各向异性媒质的理论依据。y

Galvanic pile...电堆 voltaic pile ...伏打电堆 a collection of objects laid on top of each other

他在1800年前已成功發展出以穩定電流製造、稱為伏打堆的早期電池。。。。

Methods From March 1992 to January 2005, there were 395 cases undergoing LCDET, involving choledochotomy, electrohydralic lithothipsy, dilation stenosis, stent placement and T-tube drainage.

从1992年3月～2005年1月，运用腹腔镜胆总管探查T管引流术的手术方式，包括胆总管切开，胆管镜取石，液电碎石，扩张狭窄，放置支架，T管引流，对395例病人进行治疗。

The model is used to count several engineering example.Comparing the 2D numerical results with electrical simulations,it is proved that the seepage model can count the seepage surface and the location of search results in dam well and truly.Comparing 3D results with 2D results at close section,the results are tally well except the difference of meshes and the interceptive position of section.So the model is credible and has upper practicality value.In the projects,the spending of account is increasing because of the bigger account field.

将饱和—非饱和渗流模型用于几个工程实例，其二维模拟结果同渗流电模拟实验结果进行了对比，证明本文的渗流模型完全能够准确计算坝内的渗流浸润线以及逸出面位置；三维数值模拟的结果在相近剖面处与二维结果作了比较，考虑三维网格剖分及剖面截取位置的差异，三维结果与二维结果吻合的较好，证明本文的饱和—非饱和渗流模型在三维计算中是可靠的且具有较高的实用价值。

There are three platinum catalyst micro channels which have different width ,such as 1000 m , 400m and 40m. The platinum catalyst micro channel reactor is fabricated by MEMS technology. The reactor uses the exothermic reaction of hydrogen and oxygen on the platinum catalyst plate as the heat source and the platinum thin film resistance deposited on a glass chip by face micro machining process as catalyst and temperature sensor. The channel is bonded with a cover plate etched by bulk micromachining technology to become a mico- channel reactor.

实验主要以微机电加工技术制作白金触媒微管道反应系统，利用微机电面型加工技术将白金薄膜电阻制作於基材为玻璃的晶片上，以此为反应所需的触媒及温度量测元件，并用体型加工技术蚀刻出微流道的上盖板相结合成微管道反应系统，本研究以1000μm、400μm及40μm的白金触媒微管进行测试，并利用微管道管壁上触媒表面降低反应活化能的特性来维持反应，此微反应系统利用氢气与氧气在白金触媒平板上的放热反应作为能量的来源。

Combination with the practice of domestic aluminium production industry, the 3—D current distribution, magnetic flux density, electro—magnetic force, melt flow velocity field of three diffrent cells, that is, 80KA Soderberg cell with vertical stub, 155KA prebake cell, 160KA prebake cell were computed and the related computer—simulated pictures were drawn by use of the softwares we made.

本文利用电流分布、磁场、电磁力场和流场的计算软件，结合我国生产实际计算了80KA上插自焙槽，155KA预焙槽，160KA预焙槽三种不同槽子的三维电流分布，槽内磁感应强度，熔体中电磁力场，熔体流速场，绘制了相应的计算机仿真图，为了增加计算软件的可靠性、用铁棒法测定了80KA上插自焙槽，155KA预焙槽的铝液流速，测定值与计算值符合较好。

According to the Panasonic NiMH charging Manual, permanent trickle charging can cause battery deterioration and the trickle charge rate should be limited to between 0.033×C per hour and 0.05×C per hour for a maximum of 20 hours to avoid damaging the batteries.

根据松下公司的《镍氢电池充电指南》，长期使用涓流方式（以很小的电流长时间充电）充电有可能导致电池损坏；为了防止损伤电池，涓流充电的电流应限制在 0.033×C每小时到 0.05×C每小时之间，最长充电时间为20小时。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。