流动

The Froude number of flow is the factor of flow status: supercritical flow or subcritical flow.

由流体流动的福劳德数可以确定流动的缓急程度。

From the view of coactions of both component of flow momentum and flow resistance in the direction of corrugations, the essential mechanism of the flow pattern in the channel between two chevron-type corrugation plates affected by corrugation geometric parameters was discussed.

从流体沿波纹方向的流体动量分量和流动阻力共同作用的角度，探讨了波纹几何参数对人字形波纹板片间流体流动形态的影响机理。

China needs to reduce the incentive for destabilising capital inflows, rather than block the channels.

中国需要的是减少引起资金流动不稳定的动因，而不是堵住流动的渠道。

This article pays attention to the protecting system of the flowing electorates suffrage, including four parts besides preface and epilogue, which consists of 38 thousand words.

引言部分阐释了我国人口流动的原因、现状、特点和意义，分析了对流动选民选举权保障制度进行研究的重要性。

The principle of measuring the wetness of flowing wet steam by means of the resonant cavity perturbation technique is presented.

介绍了谐振腔材料微扰技术连续测量流动湿蒸汽湿度的原理，设计了适用于流动湿蒸汽湿度连续测量的谐振器及测量系统。

It was the first time that experimental studies of the flow characteristics and convective heat transfer in platelet regenerative cooling channels with high aspect ratio were conducted in China.

大高宽比再生冷却套在宽度上已属于微小通道，为考察其流动传热是否与常规尺度管道不同，本文理论分析采用经典N-S方程而未考虑微小尺度效应是否合理，研究流道高宽比等几何参数对其水力和对流换热特性的影响，分别搭建了挤压式水力实验台和泵压式对流换热实验台，设计了d〓=1.0~1.2mm，宽度为0.6~0.8mm，AR=3~15的5个不同高宽比矩形通道层板试验件，采用线切割加工槽道和扩散焊接盖板的制造工艺，得到了质量可靠的试验件，以水为工质，在国内首次对大高宽比层板再生冷却通道的流动和对流换热特性进行了实验研究。

By the fullscale test of unsteady-flow fire in tunnel, applying aerodynamics of one-dimensional compressible unsteady-flow the relation between thermal power and thermal resistance in burning zone was analyzed, and its calculational methods were discussed. It is shown that besides heating swell, resistance and...

无论平巷或斜巷的燃烧，燃烧区的热动力势是最强的，其变化梯度为3～6Pa/m，压力最低点位于燃烧区的出口；热动力的概念把巷道一般流动损失、火区流动损失和火风压完全统一起来了，解决了实际巷道火灾燃烧区热力计算的困难，使火灾时期的风网解算更符合实际。

The purpose of this thesis is focused on the solution of unsteady rotor/stator interaction in turbomachinery with arbitrary pitch ratio.

因此叶轮机械设计水平的提高将很大程度依赖于对其内部非定常流动的深入认识，本论文的研究工作主要针对转子和静子栅距不等时叶轮机械内部非定常流动的数值分析。

The comparison of the computational results of real gas model with that of perfect gas model shows that it is very important to apply the real gas model in the numerical simulations, and also the real gas model presented shows itself more profitable and applicable in numerical applications.

对单列叶栅和透平级内复杂三维凝结流动的数值计算方法进行了研究，结合欧拉/欧拉型自发凝结数值模型，以FLUENT软件N-S求解器为平台，建立了适合工程实际应用和复杂条件下非平衡凝结流动的数值计算系统。

On the basis of this review it is shown that, in the past two decades, plenty of investigations on flow regimes, phase holdups, mass transfer coefficient and bubble behaviors etc.

第一章较全面地综述了有关三相流化床流动域、相含率、质量传递、混合、热量传递、气泡行为和流动模型等方面前人的研究结果。

And Pharaoh spoke to Joseph, saying, Your father and your brothers have come to you.

47：5 法老对约瑟说，你父亲和你弟兄们到你这里来了。

Additionally, the approximate flattening of surface strip using lines linking midpoints on perpendicular lines between geodesic curves and the unconditional extreme value method are discussed.

提出了用测地线方程、曲面上两点间短程线来计算膜结构曲面测地线的方法，同时，采用测地线间垂线的中点连线和用无约束极值法进行空间条状曲面近似展开的分析。