流动

Numerical calculation of the unsteady flow within turbomachinery The periodic unsteady flow within impeller/vaneless diffuser or impeller/vaned diffuser was numerical simulated in this thesis. The simulation was calculated on the CFX software flat.

离心风机内部非定常流动的数值模拟本文对叶轮/无叶扩压器和叶轮/有叶扩压器两种结构形式的离心风机内部流动进行了全流场非定常流动数值模拟。

By Ensemble-averaged Method, the mean field was got to show the 3D structure of flow. By Phase-locked Averaged Technique, the periodic mean field was got to reflect the periodic unsteady characteristic. The 3D structure and the periodic unsteady characteristic of the unsteady flow within the vaneless and vaned diffuser were discussed through analyzing the mean field and the periodic mean field.

离心风机扩压器内非定常流动的实验研究本文完成了离心风机两种结构条件下无叶扩压器、有叶扩压器内部的非定常流动瞬态全流场的实验测量，获得了不同运行工况下PIV的瞬态流谱，为研究扩压器内部非定常流动提供了基础实验资料。

However, the effect from impeller did not keep to the outlet of the vaneless diffuser. Through analyzing the periodic mean field, an unsteady effect region was found within the region whose biggest radius ratio was less than 1. 2 in the vaneless diffuser. The unsteady flow at three flow rate conditions had the similar unsteady characteristic.

无叶扩压器内近前盘r-6面上锁相平均流场的分析表明，当叶轮处于不同周向位置时，无叶扩压器内的流动表现出非定常流动特性，尤其是在人口区域非定常流动特性更为明显。

The geology research of carbonate reservoirs in Ordovician of Tahe oilfield showed that many large dissolved vugs and fractures were developed. The spread of the reservoir take on a very heterogeneous state. And the typical fractured-vuggy reservoirs was formed. According to the combination of the various spaces, the formation was divided into vuggy formation, fractured-vuggy formation and fractured formation. The research showed that development of the vug is relevant to the its position on the structure, the fractures, the water surface and the weathering surface. Multi-phase charge and recharge of the oil in the reservoirs resulted in the complexity of the fluid distribution. So the"Bottle Model"was brought forward to explain the movement of the water-oil contact. The special storage space and the complex fluid distribution lead to the unstability of the production and the complexity of the water cut. In order to explain the characteristic of the fracture-vug unit was brought forward and the basic principle and method of the partition of the fracture-vug unit was formed. The classification and evaluation of the units were performed according the reserve and energy. Based on the research of geology characteristic and the fluid flow in the reservoir the comprehensive numerical simulation plan of the fractured-vuggy reservoirs were established. Through the selection of the simulation unit, fluid flow type and parameter equivalent the triple media reservoir simulation model was established. Considering the practical application the model was resolved by the DKR decomposition conjugate grads method. Based on the fine reservoir description of Dsitrict IV of the Tahe oilfield the various space type were classified and combined together. The geology model of Unit S48 was constructed. Two typical single well model was established according to the geology and the dynamic phenomena. Finally the single well model and the Unit S48 were simulated by the triple media reservoir simulator. Via the local grid refinement and coarsening in the simulation good matchs were gained. Based on the results of the simulation the reserve distribution, percent of reserve produced in various space and the natural energy were analyzed. The fluid was storaged in the fractures and vugs mostly and more than 90% the produced oil came from the systems. The energy belonged to the active one. The results of simulation accorded with the fact and showed the validity and practicability the research and the simulator.

塔河油田奥陶系碳酸盐岩油藏的地质研究表明，其储层中发育着很多大型的溶蚀洞、缝，储层的平面展布呈现出极度的非均质性，形成了典型的缝洞型碳酸盐岩油藏，根据各种孔隙介质在储层中的组合，将储层分为了溶洞型、裂缝-溶洞型和裂缝型三类；研究表明溶洞储层的发育和构造位置、裂缝的发育、潜水面和风化面的位置等因素有关；多期充注的油气成藏模式导致了流体复杂的赋存状态，由此提出了所谓的&瓶子模型&，解释生产过程中油水界面的变化；特殊的储集空间类型和流体分布特征导致油田在开发过程中表现出很大的不确定性和含水变化的复杂性，为了合理的解释油气田开发过程中的动态特征，提出了&缝洞单元&的概念，并制定了&缝洞单元&纵横向划分的基本原则和依据及划分方法，并对&缝洞单元&进行了分类和评价；基于地质特征和流体在其中流动规律的研究，提出了缝洞型碳酸盐岩油藏的数值模拟综合解决方案，通过模拟单元的选择、流动类型和参数的等效，建立了三重介质油藏三维三相数值模拟模型，采用不完全LU分解预处理共轭梯度法进行了求解；在塔河油田4区精细油藏描述的基础上，将各种类型的孔隙空间进行了归类组合，建立了S48单元的地质模型；通过对油井生产动态进行分析研究，建立了两类和油井地质、生产动态相对应的单井模型；最后应用三重介质油藏数值模拟软件对单井模型和S48单元进行了数值模拟，通过局部加密和粗化等技术模拟流体流动规律，取得了很好的拟合效果；结合数值模拟结果，分析了各种介质中的储量分布、储量产出的百分比以及地层的能量，认为塔河油田缝洞型油藏中流体绝大多数储集于缝洞系统之中，所产出流体90%以上也来自于缝洞系统，其底水能量属于较充足的类型；模拟结果和油田实际情况符合较好，说明了地质研究和油藏数值模拟研究的正确性。

The results show that some flow characteristics of the microfluid are the same as the micro fluid,but some other flow characteristics are different from the micro fluid.

分析了不同因素如压差、工作流体类型、温度等因素对流体流动特性的影响，既得到了一些和宏观流体相同的流动特性，也得到了微流体所特有的流动特性。

On the basis of Bowering Model about ONB of flow boiling using n.

讨论了影响矩形窄缝流道内过冷流动沸腾起始点的各因素，在Bowering关系式的基础上，考虑质量流速和压力对过冷流动沸腾起始点的影响，使用多元线性回归的方法，得到了关于矩形窄缝流道过冷流动沸腾起始点的修正关系式，与实验数据进行比较，误差范围为± 30 %。

The results show that the mechanical properties of this PMMA depend strongly on the testing temperature. The Young's modulus and flow stress were found to decrease with increasing temperature at low strain rate. At the strain rate of 10^(-1) 1/s, strain soften was observed under all experiment temperatures. At high strain rate, with the temperature increase, the flow stress deceases remarkably while the failure strain increases, and the strain softening was also observed at the temperature above 333K.

试验结果表明：在准静态载荷下，随着温度的升高，材料的弹性模量和流动应力减小，在应变率为10^(-1) 1/s时表现出明显的应变软化行为；在高应变率(550 1/s)下，随着温度的升高，材料的流动应力逐渐减小而破坏应变增大，当温度超过333K时也有应变软化现象发生；在相同温度下，随着应变率的升高，材料的流动应力增大，但破坏应变减小。

It can be seen from the results that: water potential in quartz sand layer decreases with increasing thickness of the quartz sand layer under fixed sprinkling rate and increases with increasing sprinkling rate under fixed thickness of quartz sand layer; some of water above quartz sand layer flows down through the quartz sand layer and some flows down along edges of the quartz sand layer; some of water detoured the quartz sand layer flows into the region below the quartz sand layer closely along lower surface of the quartz sand layer.

实验结果表明：在喷水强度一定情况下，石英砂层中的水势随石英砂层厚度的增加而减小；在石英砂层厚度一定情况下，石英砂层中的水势随喷水强度的增加而增大；石英砂层上方的水部分通过石英砂层向下流动，部分绕过石英砂层向下流动；绕过石英砂层的水部分地紧贴石英砂层下表面向石英砂层下方的黄土中流动。

The Riscos Bayos consists of three lithicbearing flow units: a grey basal flow, a tan middle flow and a bright-white, highly indurated uppermost flow.

该里斯科斯Bayos三个lithicbearing流动单元：灰色基底流组成，晒黑中流动和明亮的白色，高度硬结至上流动。

First, a full three-dimensional numerical model is developed, which considering not only the rib resistance to the species, but both the single- and two-phase flow and transport in the gas channels and diffusers at both the anode and cathode sides of PEM fuel cell. Two sets of boundary conditions, one for a conventional flow field and the other for an interdigitated one, are presented. A detailed discussion of the numerical techniques for the PEM fuel cell model is given with a flow diagram to provide an overview of the solution procedure using FORTRAN language.

该模型考虑了双极板上流道间的筋部对于反应气体传递阻力以及电流密度分布的影响，从而使模型具有三维特性；建模过程中进一步考虑了流道和扩散层中可能存在的液态水，从而将现有的单相流动模型拓展成为两相流动模型，因此，该模型可以同时模拟电池内部阴极、阳极侧流道和扩散层中两相流动的发生和分布情况；分别给出了平行流场燃料电池和交指型燃料电池的边界条件；详细讨论的三维模型的耦合求解算法和技巧；用实验数据验证的该模型的准确性。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。