注入的

Means of majority carriers, small numbers of minority carriers are also injected into

少量少子也被注入到结半导体的每一边。靠肖特基二极管D1，少子被注入到

Integrating C-type of traveling wave location method with AC signal injection method, a compositive location method for single-phase earth fault in 35kV distribution network is proposed, in which firstly the fault is presumedly located by C-type of traveling wave location method to preliminarily determine the position where fault occurs; then the fault is accurately located by AC signal injection method.

基于C型行波法和交流信号注入法提出35 kV配电网单相接地故障的综合定位方法：首先采用C型行波法进行初步定位，确定故障距离和故障所在区段，然后用交流信号注入法进行精确定位。

According to the sand filling tube model , research the blank off efficiency、enduring erosion ability and profile control efficiency; The single core flow experiment purports that: at the conditions of 20meter/D injection velocity and 0.5PV injection amount, the blank off efficiency keep above 40% after flushing 20PV.

采用填砂管模型研究了盐沉析体系的封堵效率、耐冲刷性和调剖效率；单岩心实验结果表明：当诱导剂注入速度为20m/天、注入量为0.5PV时，封堵率为66.67%，地层水冲刷20PV后封堵率保持在40%以上。

Contract:This article disausses the principal of main steam temperature control system according the problems in running,including the unreasonable main steam pressure set point volue,hot air injection flow is not acciurate,Charge of steam temperature has the big delay and the common PID can′t satisfy the regulate′s demandthen take the according measures,adopt smith predictor,change to ABB intelligent positioner,add the hot air injection antiblock device,test the main steam temperature automation and optimization the specificator.

中国国电集团公司菏泽发电厂热工，山东摘要：本文论述汽温控制系统组成原理，针对运行中发现的问题，包括一次风母管压力自动设定值设计不合理，导致主汽温度和再热汽温度变化幅度加大，底部注入风量和汽温参数测量不准确，汽温变化迟延大，常规PID满足不了调节要求，采取了相应措施，改用史密斯预测器，更换为ABB定位器，增加底部注入风量等测点防堵装置，并对主汽温自动进行试验和参数优化。

OECs were cultured in the olfactory bulb of newborn Wistar rat. OECs suspension was infused into the lateral cerebral ventriculus of EAE rats, and the saline with the same quantity was infused in pseudo-operation group. Afterwards, motor-function grade, histo-pathological change and expression of apoptosis of neuron were observed.

培养、纯化OECs后，移植组将OECs悬液注入EAE大鼠的侧脑室；假手术组按以上方法注入等量生理盐水；观察二组大鼠运动功能评分、组织病理学变化以及神经元细胞凋亡表达情况。

Virus was also cultured in allantoic cavity of chicken embryo with statistically significant HA titer at 1:6.8 as compared with virus control group (P.01) incubated 24 hours after injected with MEK first then injected with IBV.

在鸡胚尿囊腔中，先注入MEK孵育24 h后，再注入B型流感病毒的鸡胚也培养出病毒，HA滴度为1：6.8，与病毒对照组比较P.01，有统计学意义。

It showed a dosage dependent degrease of blood glucose level. The effect after intestinal administration is better than it after oral administration.

比较口服经胃给药和肠道注入给药，发现胰岛素油溶液肠道注入后的降血糖效果更佳。

Methods: For 56 cases of arterial bleeding, performed angiography in the artery which was suspected to be the bleeding one, and then infused the embolus into the bleeding after super-selection to embolize it. For 17 cases of esophageal veins and fundic veins bleeding caused by the higher blood pressure in portal vein, we performed angiography in portal vein stem through puncturing the liver, found the bleeding spot, then infuse the embolus into the bleeding veins through super-selection to stop bleeding.

56例动脉性出血采用Seldinger氏法，经股动脉穿刺将导管选择插入可疑出血的动脉内先行DSA检查，明确诊断，再超选择插入出血动脉内注入栓塞材料，栓塞出血动脉。17例门静脉高压致食管胃底静脉曲张破裂出血，则采用经皮穿肝至门静脉主干行门静脉造影，明确出血部位，再超选择插管至出血静脉注入栓塞材料进行栓塞治疗。

Results: Anterior to the coronal suture and posterior to the lambdoid suture were two segments of SSS void of bridging vein draining into. The number of bridging veins observed by microanatomy, DSA and CTV was 11.2, 8.9 and 7.0 respectively.

结果：上矢状窦前部和后部分别有一缺乏桥静脉注入段，显微解剖、DSA和CTV观察上矢状窦旁桥静脉的数量分别为11.2支、8.9支和7.0支，DSA和CTV观察发现桥静脉注入上矢状窦处常显示不清。

Methods 4 Minipigs had been used in our study, 5% Sodium morrhuate was injected in pig's upper and lower lips of one side, and Pingyangmycin was injected in the other side. Every two animals were killed after 7 days and 14 days, and routinely historical observation had been made.

共4只微型猪，分别将5％鱼肝油酸钠注入每只猪的一侧上下唇组织中，平阳霉素注入另一侧上下唇，7天及14天后各处死两只动物，常规组织学处理标本，光镜观察。

It has been put forward that there exists single Ball point and double Ball points on the symmetrical connecting-rod curves of equilateral mechanisms.

从鲍尔点的形成原理出发，分析对称连杆曲线上鲍尔点的产生条件，提出等边机构的对称连杆曲线上有单鲍尔点和双鲍尔点。

The factory affiliated to the Group primarily manufactures multiple-purpose pincers, baking kits, knives, scissors, kitchenware, gardening tools and beauty care kits as well as other hardware tools, the annual production value of which reaches US$ 30 million dollars.

集团所属工厂主要生产多用钳、烤具、刀具、剪刀、厨具、花园工具、美容套等五金产品，年生产总值3000万美元，产品价廉物美、选料上乘、质量保证，深受国内外客户的青睐