法

There are many methods on ground water environmental quality assessment at present, such as single factor pollution index method, integrated index assessment, fuzzy mathematics method and gray system evaluation method, etc.

目前地下水环境质量评价的方法很多，主要有单因子法、综合指数法、层次分析法、模糊数学法、灰色系统评价法等。

Make a summary of geological bodies surface modeling methods,which including singular value surface compose method, inner bodies grid peel off surface method and the reconstruction method based on the outward curve of geological bodies,in addtion, the heuristic extend surface method.

将地质体表面建模方法总结归纳分为组合单值曲面法、体内剖分剥离表面法和基于外轮廓线的重构法，并提出有启发式的展铺法。

Therefore, this article intends to introduce through the first depreciation of fixed assets in the enterprise accounting and reporting role, combined with the current implementation of new accounting standards the premise of the analysis of existing accounting standards for business enterprises in a wide range of depreciation methods of accounting practices at the advantages and disadvantages of the application, sinking fund through the introduction of sources of law, the meaning and characteristics, as well as introduce the fair value of the time value of money and the role of the property, which raised at the fair value method under the sinking fund depreciation of fixed assets at the application of the necessity and feasibility, which analysis sinking fund method in different models under the conditions of the application came to the conclusion that sinking fund at fair value method under the category of highway bridges listed companies a positive impact on applications and recommendations.

所以，本文拟通过先介绍固定资产折旧在企业会计核算和报告中的作用，结合当前新会计准则实施的前提，分析现有企业会计准则中各种折旧方法在会计实务应用中的优缺点，通过介绍偿债基金法的来源、含义及特点，介绍公允价值以及货币时间价值的属性和作用，从而提出在公允价值下偿债基金法在固定资产折旧中应用的必要性和可行性，进而分析偿债基金法在不同模型条件下的应用，最后得出偿债基金法在公允价值下对公路桥梁类上市公司应用的积极影响和建议。

Through the assimilating and analyzing the construction materials and the design of reinforced concrete arch bridges with long span from both domestic and abroad, the thesis studies the effect of the arch axis geometry, rise-span ratio, arch ring section and spandrel structures, as well as the ultimate bearing capacity and stability of the entire bridge on the design of reinforced concrete arch bridge. In addition, in consideration of construction, the thesis also studies the applicability of different construction methods such as cable crane system, stiffened skeleton system, swing construction system and cantilever construction system and correspoindingly economica spans and their applications of the reinforced concrete arch bridges.

本论文通过对国内外大跨径钢筋混凝土拱桥的设计、施工资料的收集及其出现问题的分析，从设计角度研究了拱轴线形、矢跨比、拱圈截面及拱上构造、全桥极限承载能力及稳定性对钢筋混凝土拱桥设计的影响；从施工角度研究了缆索吊装法、劲性骨架法、转体施工法、悬臂施工法等不同施工方法的钢筋混凝土拱桥的经济适用跨径及其适用条件。

The major implementations of the developed model include: Pseudo-spectral and finite-difference schemes are employed to approximate the spatial-differential operators in the horizontal and vertical directions, respectively. A second-order Runge-Kutta method is adopted to integrate in time for the velocity field and the free-surface elevation. The solenoidal condition of the velocity field is satisfied by solving the transformed pressure Poisson equation. A modified secant method is used to accelerate the iterative solution of the non-separable Poisson equation.

模式的主要数值方法包括：分别以拟频谱法以及二阶有限差分法近似控制方程与边界条件中的水平与垂直导数；以二阶Runge-Kutta法进行非稳态的自由液面位移与流场速度的时间积分；利用改良式割线叠代法求解计算区间中不可分离的压力Poisson方程式，以满足不可压缩流条件。

In this paper, chemistry composition, fiber morphology and pulping property in Solidago canadensis were analyzed and determined preliminarily. The results showed that the content of holocellulose was 81.86%, the content of cellulose was 42.63%, the content of lignin was 18.86%, it is feasible for using Solidago canadensis pulping based on it's chemical composition. The ratio of fiber length to width in Solidago canadensis was 36.67, the average length of fiber was 440 μm, and the length of fiber was too short to pulping. The ratio of wall thickness of fiber cell to lumen diameter was 0.34, and it was smaller than that of other woody fiber. In this experiment, four different methods of pulping were as follows: kraft-AQ pulping Ⅰ, kraft-AQ pulping Ⅱ, alkaline pulping, alkaline sulfite adding AQ pulping, but it was difficult for lignin removal in Solidago canadensis.

通过对一枝黄花的化学组成、纤维形态以及制浆性能进行初步探索，结果表明：(1)加拿大一枝黄花的综纤维素含量为81.86%，硝酸乙醇纤维素含量42.63%，木素含量18.86%，由化学组成看，加拿大一枝黄花是比较适宜制浆造纸的；(2)加拿大一枝黄花纤维的长宽比为36.67，纤维平均长度为44μm，从纤维长度来看，加拿大一枝黄花的纤维较短，不适宜制浆，其纤维壁腔比0.34，和其它速生材相比较小；(3)采用4种碱法制浆方案，硫酸盐蒽醌法Ⅰ，硫酸盐蒽醌法Ⅱ、烧碱法、碱性亚钠＋蒽醌法，结果显示，加拿大一枝黄花的木素非常难脱除。

By analyzingthe bifurcation of the solum "loid' application immediate", quasi "loid' applicationimmediate" and the "loid' application immediate" of the third party in the practiceapplication, the writer presents a rational resolution. And also considered thepractice of the "loid' application immediate" in legislation and judicature, the writeranalyzed the weak points and tabled some proposals.

通过分析法院地"直接适用的法"、准据法国"直接适用的法"以及第三国"直接适用的法"在实践应用中的分歧，笔者尝试给出了合理的解决方案，并结合我国"直接适用的法"在立法和司法上的实践，分析不足之处，提出建议。

In the experiment besides entire spermatophore transplantation and spermaduct transplantation, partial spermatophore transplantation and semen transplantation were firstly used in artificial insemination of Fenneropenaeus chinensis. Artificial insemination rate, fertilization rate and hatching rate were compared among the four methods. The results indicated that artificial insemination rate of four methods was high, the highest was 80.8% and the lowest was 53.3%.

在常规的精荚移植和输精管移植两种中国对虾人工授精方法的基础上，首次建立了精荚切块移植和精液移植两种新的人工授精方法，并对比了4种方法的授精成功率、受精率和幼体的孵化率。4种方法都取得了较好的授精成功率，其中完整精荚移植法最高，为80.8%；输精管移植法最低，为53.3%；其他两种方法依次为：精液移植法为73.9%，精荚切块移植法为66%。

According to the experimentation ,This article reviewed several algorithm("flood" and "snake","adaptive spherical image transform method","reference image","standard spherical gray level model method") for apple surface defect detection and gave an in-depth analysis of their ideas and experimen...

在实验的基础上，本文对几种缺陷检测算法("洪水法"和"蛇形法"、"自适应球形变换法"、"参考图像法"、"标准球体灰度模型法")的思路和实验结果进行了深入的分析和比较，并对缺陷检测中尚待解决的问题进行了阐述。

In the experiment, the TiO2 nanoporous films were made dy using multiple sprinkling technique in the home-made sprinkling box instead of the doctor blade method. The multiple sprinkling technique can quickly produce the TiO2 film and easily control its thickness, i.e. transmittance. The multiple sprinkling technique made TiO2 films receive the result that the higher heating temperature and the longer heating duration, the better photoelectric conversion efficiency . The experimental data show that the sprinkling technique is better than the doctor blade and the DSSC integrated with the photoelectrode ca.

实验中自行制作喷雾箱，以多次喷雾的方式制作TiO2多孔膜，取代传统的刮刀涂布法，达到快速制作及容易控制膜厚或膜之透光率的目的，当藉由喷雾法所制作的奈米TiO2多孔膜烧结温度越高时，其光电转换效率也越好，烧结时间越长，DSSC光电转换效率越佳，整体之效果，喷雾涂布法有较优於刮刀涂布法的效果。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。