求值

While calculating tensor Green's functions, the algorithm of secondary division is adopted to solve the singular problem. The Gaussian quadrature and continued fraction is adopted to calculate the integral with Bessel function. This method not only can ensure the right calculation of tensor Green's functions but also can get high precision.

求取张量格林函数积分时，采用二次剖分算法解决计算中奇异值问题，对于含有贝塞尔函数的积分项，利用结合连分式展开的高斯求积代替常规的快速汉克尔变换方法，确保了张量格林函数的正确计算并提高了计算精度。

The present paper applies the quadratic splines to the Chemical Engigeering calculations for integration, interpolation and differentiation with good precision.

在样条函数的研究和应用日益广泛的今天，作者将人们所忽视的二次多项式样条函数引用到化工计算中的插值，求积和求导等方面，取得良好的结果。

The optimization algorithms are commonly used to approach the minima of the roundness objective functions through iteration when a microcomputer is applied to assess roundness errors by minimum zone, minimum circumscribed circle, and maximum inscribed circle methods.

引言在用计算机求最小区域、最小外接圆和最大内切圆评定法求圆度误差时，广泛采用最优化算法，通过迭代去逼近目标函数的极小值。

At the first step, the predicted value is solved, which is a constant function on each triangular element.

第一步是求出单元常值近似的预估值，第二步是求Galerkin近似的修正值。

Terminal voltage is determined by a cut-and-try solution such that the summation of reactive volt-amperes equals zero. Slip is determined from the relation that the summation of the real powers equals zero, and then frequency is obtained.

根据虚功率总合为零的原则，可求出感应发电机之端电压值，以及有效功率总合等於零的原则，求出转差率及频率来。

The optimal set of discriminant vectors can be acquired througn singular value decomposition theorem.

利用奇异值分解定理，将求取鉴别矢量转化为对矩阵求奇异向量。

The values of Joule-Thomson coefficient derived from VDW and RK equations and the correction formula of state equation of ideal gas are compared with he measured values and the values obtained by conventional methods.

对采用VDW、RK方程直接求导法和理想气体状态方程的修正式求导法求得的焦耳－汤姆邀系数值与实测值、常规方法所得的值进行了对比。

It offers the idea according to problem faced, considering the good character of the ends,the ajusted cubic B-spline curve is used to fit ship lines.it finds out the control vertexs according to a sequence of given points,and then, through particular formula,each point in the curve could be worked out.

针对面临的问题，提出了自己的思路，在数学计算方法上，由于三次准均匀B样条曲线良好的端部性质，这里用它来拟合船舶型线，首先根据所给的初步型值求出其控制顶点，然后根据相关公式进行插值便能得到曲线上的所有插值点。

Normal vectors, Gaussian and mean curvatures estimation are obtained by different curvatures estimation methods, and the error is computed by comparing estimation results with real ones on the sphere of unit radius and toms.

在单位球面和环面上，利用不同的曲率估计方法得到法向量以及高斯曲率，平均曲率的估算值，再将估算值与实际值做比较求误差。

That means that we take maximum settlement value as an objective value, that is, to control surface settlement is to control pipeline deformation. Its research paths are to make decision of computational method of maximum surface settlement and settlement pattern firstly; then to establish the relationship between maximum surface settlement and ground pipeline deformation and strain, to get maximum surface settlement in term of th

研究思路是：首先要搞清楚地表沉降的规律以及地表最大沉降值的计算方法：然后研究地表最大沉降值W.x与地下管线的变形及应变的关系，从而可以根据管线与隧道的相对位置、地层条件、管线的允许变形情况求出w皿厂这样通过控制地表最大沉降值w删x就可以间接控制隧道工程对地下管线的影响。

I can not make it blossom and suits me

我不能让树为我开花

When temperatures are above approximately 80 °C discolouration of the raceways or rolling elements is a frequent feature.

当温度高于 80 °C 左右时，滚道或滚动元件褪色是很常见的特征。