水溶液
- 与 水溶液 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
Experimental results showed that the hydrogenation degree can be enhanced significantly by the addition of triphenylphosphine. When the molar ratio of TPP, TPPTS and Ru is 2:5:1, 89% hydrogenation degree can be achieved after 12 h under reaction conditions of 5.0 MPa and 150~C.
考察了溶剂种类、水溶液的pH值、添加助剂三乙胺、水/有机两相体积、底物浓度等对对-氯硝基苯转化率和生成对-氯苯胺选择性的影响,并在90℃、4.0MPa、反应时间为6h的条件下,进行了催化剂的循环实验。
-
Firstly, the homopolymerization of acrylamide was carried out in aqueous phase by reversible addition-fragmentation chain transfer radical polymerization using a trithiocarbonate as a chain transfer agent.
整个过程分为两步,首先在水溶液中,通过RAFT控制得到亲水性单体丙烯酰胺的均聚物;然后以得到的均聚物作为水溶性的大分子链转移剂,在水相中条件下参与亲油性单体苯乙烯无皂乳液聚合。
-
Monodispersed tungstic acid nanoparticles with an average diameter of 20 nm were prepared by a ultra-violet light irradiation of oxotungsten-citrate complex aqueous solution.
通过紫外光照射柠檬酸钨氧配合物水溶液,制备了平均粒径约为20nm的单分散钨酸纳米颗粒。
-
The thermally cured Etch-resist ink (2) was then removed from the unetched areas of copper by immersing the film in an aqueous solution of 5% by weight caustic at a temperature of 50° C.
的热固化刻蚀抵抗油墨(2)然后从铜的未腐蚀× 100区除名的沉浸在了5%水溶液的电影,由重量烧碱为50 ° C的温度由此产生的FR4电路板蚀刻水冲洗和干燥的空气在25 ° C
-
It is concluded that the oxidative unhairing method using chlorine dioxide solution is feasible and it has a lot of advantages which cannot be replaced by other unhairing methods.
研究及实践结果表明:二氧化氯水溶液氧化脱毛法可行,并且具备其它脱毛方法不可替代的优点。
-
The method includes the following steps: getting specific amount of knitted or unknitted natural fiber and dipping the natural fiber in the aqueous solution of silane coupling agent for 1-100min, taking out and drying the natural fiber, thus producing natural fiber with modified surface; then pressing the polylactic acid into sheet in a plate vulcanization machine; disposing 2-10 polylactic acid sheets into a die and arranging one modified natural fiber sheet between every two polylactic acid sheets; pressing and molding the sheets; in this way totally biologically degradable polylactic acid composite material can be made.
该方法为:先取一定量的经过编织或未编织天然纤维,将其浸渍在偶联剂水溶液中1~100分钟后取出,经干燥后得到表面改性的天然纤维。然后,将聚乳酸在平板硫化机中压制成薄板;将2~10片聚乳酸薄板放在模具中,且每2片之间放置1片改性的天然纤维,然后模压成型,得到可完全生物降解聚乳酸复合材料。
-
At 25℃,in 30w/o KOH aqueous,when current density is 2000A/m 2,the evolution oxygen overpotential of the oxidized Ni anode decreases 260mV relative to unoxidized Ni anode.
常温下,电流密度2000A/m2电解30%KOH水溶液时,脉冲电流氧化的Ni阳极析O2超电势比普通Ni阳极下降260mV。
-
Objective To detect the virucidal efficacy of cross linked starch iodine and its influence factors in solution and to observe the morphological changes of CSI after disinfection.
目的 检测交联淀粉碘对水溶液中病毒的灭活效果及影响因素,并观察消毒前后CSI的形态变化。
-
Amounts of hydroxyl groups and specific surface areas of silica xerogel are higher, therefore it has more adsorption activated positions.
第四,通过锆在水溶液中的存在特性和SiO〓干凝胶表面特性的分析,研究了SiO〓干凝胶对锆的吸附机理。
-
The micro-morphology of the initiation zone of SCC of Ti-5A1-2.5Sn alloy in 3.5% NaCl solution has been inspected by OM and SEM.A study of the SCC crack's details by OM,TEM,X-ray diffractometer and ion microanaly- zer has also been made.
本文用金相显微镜和扫描电镜对 Ti-5Al-2.5Sn 合金在近中性3.5%NaCl 水溶液中 SCC 裂纹形核带的微观形貌进行了观察。
- 推荐网络例句
-
This paper demonstrated the impact on the environment today, an important factor is Education.
本文主要展示了当今影响环境的一个重要因素——教育。
-
Article 16 The power to interpret these Procedures shall remain with the Ministry of Agriculture and CAA.
第十六条本程序由农业部、国家认证认可监督管理委员会负责解释。
-
I am not quite sure if you can overcome the inertia.
我不确定你能否克服自己的惰性。