水泵

Press the "Start" button, the pump running, then open the suction valve of the pump.

按下水泵&开&按钮，泵即运转；然后打开泵的吸入阀。

Pump suction valve off the bottom also belongs to valve type.

水泵吸水关的底阀也属于止回阀类。

1 Be familiar with the location of the suction valve and the pump to be used for the Emergency Bilge Line.

应熟悉应急舱底水泵和应急舱底水吸入阀的位置。

Submersible pump works Open-pump before the suction pipe and pump to be filled with fluid.

一、潜水泵的工作原理开泵前，吸入管和泵内必须充满液体。

At the end of valve should be installed in the pump suction pipe at the Bellow Seal Valve bottom.

底阀应安装在水泵吸水管路的底端。

B. water-filled Pump start before the pump casing and suction pipe must be full of water that is because of the presence of air vacuum pumping the population can not be formed and maintained.

b。陈籍水泵在启动以前，泵壳和吸水管内必须先布满水，这是因为有空气存在的情况下，泵吸人口真空无法形成和保持。

The pump mounting height should be allowed to smoke on a high vacuum suction pipe loss deduction after the head, the rest of that part of the value, it is highly absorbent to overcome the actual terrain.

而水泵安装高度应该是允许吸上真空高度扣除了吸水管道损失扬程以后，所剩下的那部分数值，它要克服实际地形吸水高度。

And the pump mounting height should be allowed to deduct a high vacuum suction on the suction pipe head loss, the remaining portion of the value, it is to overcome the actual water height of the terrain.

而水泵安装高度应该是允许吸上真空高度扣除了吸水管道损失扬程以后，所剩下的那部分数值，它要克服实际地形吸水高度。

Raw water suction and straining: This is done by a submersible pump complete with the suction hose and inlet strainer of approximately 2 mm openings.

原水抽取和过滤：设备包括：潜水泵及其吸水软管和进水过滤网，筛孔尺寸为2mm

Double entry sealing ring is used to reduce the water leakage from pump pressure chamber back to the suction chamber.

双吸密封环用以减少水泵压力室的水漏回吸水室。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。