水压

This water is forced into the boiler by the feed pump.

用水泵将水压入锅炉。

This water is forced into the boiler by the feed pump.

给水泵将水压入锅炉。

The water is forced into the boiler by the feed pump.

用水泵将水压入锅炉。

The ape of the fin keel and how it fits on to the hull has been particularly thought out to reduce strain in case of impact against a rock.

水舱是模压入船身的结构部分，同时发挥水压舱物的作用，达到更加舒适和优良的运输性能。

A new concept to determine the delivery head of the pump and to set up the pressure of the system is proposed in this paper, based on the precondition to ensure the water head demand of any fire appliance at the most unfavorable point.

从保证最不利处灭火设施水压要求这一基本前提出发，提出确定稳压泵扬程和设定压力的新思路，并按3种情况分别作出说明。

Based on the compressibility, viscosity resistance and the working house system's deformation etc, flow equations of distribution spool, hydraulic tube and fluid cylinder for 300 MN die forging hydraulic press were established, and dynamics equations of moving beam and upper beam were established based on analysis. The dynamics mechanical-hydraulic coupling model of driving system was established.

考虑流体的可压缩性、粘性阻力及工作框架系统变形等因素，采用解析法建立300 MN模锻水压机动梁驱动系统分配阀口、液压管道、液压缸的流量方程以及动梁和上横梁的动力学方程，得到驱动系统的动态机液耦合模型。

Based on the compressibility, viscosity resistance and the working house system's deformation etc, flow equations of distribution spool, hydraulic tube and fluid cylinder for 300 MN die forging hydraulic press were established, and dynamics equations of moving beam and upper beam were established based on analysis. The dynamics mechanical-hydraulic coupling model of driving system was established.

摘 要：考虑流体的可压缩性、粘性阻力及工作框架系统变形等因素，采用解析法建立300 MN模锻水压机动梁驱动系统分配阀口、液压管道、液压缸的流量方程以及动梁和上横梁的动力学方程，得到驱动系统的动态机液耦合模型。

Q235 and 20MnSi billets are tested to produce BS 460MPa grade reinforced bar with postrolling residual heat treatment process. Influences of water-cooling stage, water pressure, the temperature at the entrance of cooling bed, compositions, steel grade and ageing on reinforced bar properties are studied.

以Q235、20MnSi钢坯为原料进行了用余热处理工艺生产英标460MPa级钢筋的试验，研究了水冷段数、水压、上冷床温度以及成分、钢种和时效对钢筋性能的影响。

The system's design is based on its gas-injection unit but delivers water pressure up to 5804 psi (400 bar) and has a temperature regulator that can heat water up to 194 F.

此系统是在他们的气辅注射系统改造而来的，提供高达每英寸5804磅（400巴）（即400大气压）的水压，温控组件可将水加热到194华氏度（90摄氏度）。

It was concluded that the degradation of lube oil was caused by the leakage of K2CO3 caustic liquid resulted from the damaged mechanical seal, low sealing water pressure, high liquid level of dripping sum, poor heat radiation of the shaft seal of lean liquid pump and large space of shaft protection ring etc.

分析了中原大化集团合成氨装置贫液泵润滑油系统滤油器压差迅速升高的原因，指出主要是机械密封损坏或密封水压过低、滴水槽液位过高、贫液泵轴封散热不好、轴承护圈间隙过大等，从而使K2 CO3漏入碱液润滑油系统，导致润滑油变质。

I'm gonna go pack my regular, long bathing suit.

我要去打包我那不起眼的超长泳裤

Random number generators are used in many areas, with the improvement of the computational ability of the computer.

随着计算机计算能力的不断提高，随机数发生器在许多领域有了更加广泛的应用。