水压

After perform for the working people, the ballet dancers need to take a bath, using hydraulic pressure removes exhaustedly .

为劳动人民群众表演后，芭蕾舞蹈演员都需要洗澡，以水压去除疲累。

In order to analyze the influence and damage of the top and bottom of rock mass in floor water-resisting layers due to water pressure in water bearing layer and mining pressure, this paper applies the methods of similar material simulation test and mechanical analysis of floor water invasion in the near of faultage to further comprehend the mechanism of floor water invasion.

为了分析底板含水层水压及采动矿压对底板隔水层岩体上部与下部的影响与破坏，应用了相似材料模拟试验以及断层附近底板突水的力学分析方法，对底板突水机理有了进一步的认识；同时，由断层附近底板突水的力学分析方法所得到的理论计算结果，也可以作为判别类似条件下遇断层时承压水体上采煤是否安全的依据。

Shell products are subjected to by the technical specifications of 1.0 ~ 1.6MPa water pressure test and the 0.5 ~ 0.82MPa gastightness test, the majority of those casting shell-type is an A-type products, technical difficulty, high-tech .

壳体类产品按技术规范需承受1.0~1.6MPa的水压试验及0.5~0.82MPa的气密性试验，这些壳体类铸件大多数属A类产品，技术难度大，科技含量高。

The poor connection of all the NCU1 network controllers of your company's BA system has made it impossible to have an on-line control of the No.2 recycling pump of heat exchanger, the geothermic pump, the pump motor, the ventilation motor, the grill motor, and other equipment, and to read the feedback values of the on-spot breakdowns and conditions.

贵司BA系统NCU1网络控制器全部离线，造成热交换器2#循环泵、地热循环泵、水泵电机、通风电机、格栅电机等设备无法在线控制，不能读取现场故障、状态等反馈值。1#－5＃生活水泵、生活水泵运行时间统计、锅炉系统供回水压差、供水温度、回水温度、回水流量等数值无法显示运行状态及现场流量值数据。

His method is called the Hydrodynamic Pressure Process.

他的理论被称为水压处理。

Of water rising to the surface under internal hydrostatic pressure.

在内部的水压下喷出地面。

The hydrostatic bearing technology is an efficient way to solve the wear if the material is fixed.

摩擦副的工作状况是水压泵设计中的关键，对泵的性能和寿命有着重要的影响。

2 The hydrostatic test condition in the installed position shall be considered for design of all vessels.

所有容器的设计时应考虑安装后的水压试验条件。

This article introduced field assembly of large-scale tower s adopting jack,the welding of the shell,heat treating and hydrostatical test.

介绍了大型塔器现场采用千斤顶进行组对、焊接、热处理、水压试验，同时对如何解决塔段出现椭圆变形超标的问题进行阐述。

Once the line and valve have been hydrostatically tested, check all of the bolts on both flanges one final time to assure a minimum value as shown in the torque value shown in the Bolting Specification table.

在管线和阀门进行水压测试后，都要检查两个法兰的所有螺栓，确保螺栓扭矩尽量接近螺栓规格表所显示的扭矩值。

I can not make it blossom and suits me

我不能让树为我开花

When temperatures are above approximately 80 °C discolouration of the raceways or rolling elements is a frequent feature.

当温度高于 80 °C 左右时，滚道或滚动元件褪色是很常见的特征。