水压

The calculation results show that runner frequency of the turbine is reduced in certain degree under the effect of water pressure and viscous force, and the mode is changed too.

通过计算表明在水压载荷和黏性载荷的作用下，水轮机的转轮频率存在一定程度的下降，模态发生了变化。

To reset the reducing valve for higher pressure when the pressure is not sufficient to lift the water to highest radiation

如果需要更高的压力（当水压不足于将水提升到最高的用水设备时），则需要重新设置减压阀

However, the timeliness of this effect is very short, will be with the loss of the surface of an active ingredient quickly faded and eventually play a role or repellant of water resistance and anti-pressure ability to size.

但这种效果的时效性很短，会随着表面有效成份的流失而很快消退，最终起作用的还是防护剂的耐水性能和抗水压能力的大小。

The water storage function of condenser is the must not only for gathering and storing condensed water, various water repellence of thermal system, exhaust steam and chemical feedwater, but also for cushioning dramatically changing turboset flow during the operation, improving the stability of system regulation and ensuring the essential water-absorption pressure head of condensation pump.

凝汽器的蓄水作用既是汇集和贮存凝结水、热力系统中的各种疏水、排汽和化学补给水的需要，也是缓冲运行中机组流量急剧变化、提高系统调节稳定性的需要，并且是确保凝结水泵必要的吸水压头的需要。

In order to find the post-buckling path for ring-stiffened shells under hydrostatic pressure and consider the practical shapes of ring sections, the Compound Strip Method is applied to the post-buckling analysis of ring-stiffened cylindrical shells.

为了研究水压作用下的加肋柱壳的后屈曲状况，并且能考虑到肋骨的实际截面形状和分布情况，本文将复合有限条方法应用于环加肋圆柱壳的后屈曲分析。

Aiming at solving the difficulties of prototype manufacturing of conical ring for the steam generator shell of 600MW Nuclear Reactor,this paper developed a new techniques for the prototype manu-facturing of the great conical ring utilizing ring rolling technology based on RAW200/160-5 ring rolling.

1引言600MW蒸汽发生器壳体是核电站的关键设备，由封头、锥形环件和筒体组焊而成。以往制造这种锥形环件所采用的办法是，先锻制环形筒件再采用机械加工方法成形或者采用自由锻造方法直接在水压机上锻制出大型锥形环件，但这些工艺既费工时又大量浪费材料，而且产品精度不高[1]。

The Jet Snake Rooter combines Cable and head cutting strength with high pressure cleaning at 1100 PSI and 1.9 GPM wash away efficiency.

蛇形挖掘水枪钻头结合缆索和切割钻头，具有高达1100 PSI的水压压强和每小时431公升的喷射量，能够有效清除堵塞物。

Automatic sprinkler system of water by pipeline leakage country "heating and sanitary engineering construction and acceptance norms" section 3.15 states: water pressure test, 10min with the pressure drop of not more than 0.05Mpa.

自动喷水系统管道的泄漏水量按国家《采暖与卫生工程施工及验收规范》第3.15条规定：水压试验时，10min内压力降不大于0.05Mpa。

However, these researches were mainly focused on configuration and mechanical character of the coal seam scaleboard during the development of water inrush coefficient.

但是，从突水系数演化过程来看，其研究工作主要集中于对煤层底板隔水层本身结构和力学性质上，而对底板水压力作用机理研究较少。

The experimental simulated the principle of operation of hydraulic pressure methane tank, proceeded from effective demand, through the medium of self-command methane fermentation plant, we looked into know clearly that ...

本试验模拟农村水压式沼气池的工作原理，通过自制沼气发酵装置，从实际需要出发，研究了换料时间间隔、接种物的种类、接种物的接种量这3个影响沼气发酵的重要因素对产气效果的影响。

Do you know, i need you to come back

你知道吗，我需要你回来

Yang yinshu、Wang xiangsheng、Li decang,The first discovery of haemaphysalis conicinna.

1〕 杨银书，王祥生，李德昌。安徽省首次发现嗜群血蜱。