水冷的

Design method of water-cooling radiator is given with the theory of fluid dynamics and heat transfer.

解释了双腔并联压电泵的结构及工作原理，应用流体动力学、传热学等理论阐明了水冷散热器的设计方法，并用有限元分析软件对散热器进行热量分布仿真。

The cleaning of water-cooling tubes in power plants is always anonerous,complex and dangerous job for human beings.

火力发电站大型排管锅炉的水冷壁排管壁面清扫和检测一直是一项繁重、复杂和危险的体力劳动。

With respect to the above-cited issues an experimental study was conducted of the gas-solid dual-phase flow characteristics of the Tangential firing system and the reverse tangenfial firing system with the help of PDA system.

针对切向燃烧锅炉燃用劣质煤时的稳燃及水冷壁高温腐蚀问题，采用PDA测量系统，对四角切圆锅炉中一、二次风同心反切和同心同向燃烧方式进行了气固两相流动特性的实验研究。

Their directional solidification is carried out by either Czochralski technology in the water-cooled copper crucibles or floating zone method without crucible, but the temperature gradient is not high with these two methods.

其定向凝固或者是在水冷铜坩埚内采用Czochralski技术进行，或者是采用不需要坩埚的悬浮区熔法实现，但这两种方法都不能得到较高的温度梯度。

The pump rotor shaft and motor are installed vertically, pump inlet at the top of the lower part of the exhaust port at the pump, pump casing with a water-cooled units, to reduce the pump bearings and seal at the temperature.

泵的转子轴及电机均为竖直安装，泵进气口在上面，排气口在泵下部，泵壳带有水冷套，以降低泵轴承及轴封处的温度。

Q235 and 20MnSi billets are tested to produce BS 460MPa grade reinforced bar with postrolling residual heat treatment process. Influences of water-cooling stage, water pressure, the temperature at the entrance of cooling bed, compositions, steel grade and ageing on reinforced bar properties are studied.

以Q235、20MnSi钢坯为原料进行了用余热处理工艺生产英标460MPa级钢筋的试验，研究了水冷段数、水压、上冷床温度以及成分、钢种和时效对钢筋性能的影响。

Just remember, the water is cold, so slow your roll if you're looking for a lunker.

只记得，水是冷的，所以如果你慢滚你要找的是lunker。

For manufacture of low/medium/high and higher pressure boilers,water cooling panels,coal-saving devices,reheaters,superheaters and steam pipelines

用于低中压、高压及其以上压力锅炉的水冷壁、省煤器、再热器、过滤器及蒸气管道的制造。

The b oilers adopt horizontal square duct with membrane tube walls laid around and hea t transfer surface of bare tubes, welded-fin tubes and spiral fin tubes.

两台 锅炉均采用直通卧式方烟道结构，烟道的四周为膜式水冷壁，受热面为38mm× 4mm的光管、双翅片管和螺旋鳍片管。

By employing a certain kind of rapid-fire-gun barrel adopting outside liquid cooling method to act as the research object, the fluid-structure coupling heat-transfer model of barrel, cooling fluid and water-jacket was established, and then such a model was calculated with finite element method.

以某采用外液冷方式的速射火炮身管为研究对象，建立了包括身管、冷却液和水套的流固耦合传热模型，使用有限元方法进行研究。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。