氮化

The effects of substituents on the nucleophilic reaction of benzyl halide and sodium azide were studied.

合成了叠氮苄、对氰基叠氮苄，对氟叠氮苄，对甲基叠氮苄和联苯二叠氮苄，研究了苯环上不同取代基对苄基卤代物与叠氮化钠经亲核取代反应生成苄基叠氮化物的反应的影响。

The appropriate temperature of diazotization was-10～-5℃,and the diazotizating fluoborate was decomposed in petroleum ether to get 2-chloro-3-fluoropyridine with 64% yield.

以2-氯-3-氨基吡啶为原料，在40%的氟硼酸溶液中，采用饱和的亚硝酸钠为重氮化剂，在-10~-5℃下进行重氮化反应制得重氮盐，在石油醚中热分解得到2-氯-3-氟吡啶，收率为64%。

To promote development of low alloy steel bearing vanadium and mitrogen,the process,conditions and products of preparing nitrided ferrovanadium and vanadium nitride are introduced on the basis of main documents.

为推动含钒氮低合金钢的发展，在查阅主要文献的基础上，重点介绍了氮化钒铁及氮化钒制备的工艺方法、条件及产品情况。

It was revealed that content of water among nitriding agent, space velocity, final nitriding temperature, temperature rate, the ratio of N2 and H2 all have impacts on the formulation of high surface area γ-Mo2N and the significance reduces in turn.

研究发现氮化剂中水含量、空速、氮化终温、升温速率、氢氮体积比对高比表面积γ-Mo2N/SiO2的形成均有影响，且影响显著性依次降低。

With trimethyl,4-dodecylbenezyl ammonium chloride and 18-crown-6 as pase-transfer catalysts, the azidation of polyepichlorohydrin in poly and H2O were studied. The reaction discipline and mechanism were discussed. The results show that the system with trimethyl, 4-dodecylbenezyl ammonium chloride as phase transfer catalyst and PEG as medium is a safe and effective approach to glycidyl azide polymer preparation, and azidational ratio of PECH can reach 97% above within 15 h.

研究了氯化十二烷基苄基三甲基铵和18-冠－6为相转移催化剂时端羟基聚环氧氯丙烷在聚环氧乙烷和水为介质中的叠氮化反应，探讨了反应规律和反应机理，结果表明：以PECH为介质，十二烷基苄基三甲基氯化铵(TMDA-1)为相转移催化剂的反应体系，可在15h内使PECH叠氮化转化率达到97%以上，无主链断裂等副反应，是一条较为安全快速的制备叠氮粘合剂的方法。

In addition, scratch test and measurement of microhardness were carried out to investigate variation of adhesion and microhardness of post-implanted c-BN films

此外，还利用划痕试验测量了氮离子注入前后立方氮化硼膜临界载荷，用超轻载荷显微硬度试验机测量了立方氮化硼膜的显微维氏硬度。

The effect of technical parameters on nitrogen content in vanadium carbonitride is investigated.

研究了一步法合成碳氮化钒的生产工艺及工艺参数对碳氮化钒氮含量的影响。

Using pentaerythritol as initiator, boron trifluoride diethyl etherate as catalyst.dichloroethane as dispersion agent, the chloride polyether polyol is synthesized based on the mechanism of cationic ring-opening polymerization of epiclilnrohyclrin.The azide polyether polyol is synthesized, in DMF through A and sodium azide, and the non-reported azide energetic curing agent is synthesized through the adduction of B and IIDI.

以季戊四醇为起始剂，三氟化硼乙醚为催化剂，1，2—二氯乙烷为分散剂，环氧氯丙烷经阳离子开环聚合反应制成氯化聚醚多元醇，A在N，N—二甲基甲酰胺中与叠氮化钠反应制得叠氮聚醚多元醇，B与六亚甲基二异氰酸酯加成反应制得未见文献报道的叠氮固化剂。

The process of preparing NCAGE included the following steps: alkalization of the treated cellulose; etherification of the alkali cellulose; nitration of the water-soluble cellulose ether; and azidation of nitrocellulose glycidol ether.

利用高压蒸汽闪爆处理后的Novel纤维素为原料，经过碱化、醚化、硝化和叠氮化反应，得到了一种新型高能粘合剂——硝化纤维素叠氮甘油醚，并采用元素分析、DSC、FIT红外光谱和X-射线等对其含氮量、结构和性能进行了分析表征。

The formation mechanism of titanium nitride powders by reduction of carbon and nitridation was researched by method of continuous weighing.

用连续称重法研究了钛白粉被活性碳还原氮化合成氮化钛粉末的还原氮化反应机理，并进行了反应的热力学、反应产物的显微结构以及X-ray衍射分析。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。