氧化铝

The membranes were transformed from amorphous phase toα-Al_2O_3 crystalline phase by 5 hours annealing at 800℃and 910℃. At the same time, aluminum and amorphous alumina were found by XRD patterns. The membrane had little change in front side after 5 hours annealing at 800℃, while the back side was transformed from ruleless distributing to cluster distributing.

膜在800℃及910℃下退火5h后，由非晶态的氧化铝转变成为晶态的α-Al_2O_3，但同时也有铝单质和无定形结构的氧化铝存在，膜在800℃下退火5h后的正面没有太大变化，背面由无规则的分布变为簇状分布。

However, the closure is more likely due to the running down of alumina inventory in China and the fact that alumina is no longer available at a reasonable price…again,this cut in production did not stop February 2006 aluminum production from reaching an annualized level of 8.8mtpa.

可是，由于中国市场氧化铝存货量的下降导致关停的数量可能进一步扩大。事实上氧化铝的这种不合理的价格不会延续很长时间，这项减产计划并没有停止，2006年二月铝产量达到 of 8.8mtpa 的年生产水平。

A wet chemical method was cidopted to introduce alumina sol to surface-modification of alumina bubble and in-situ decomposition characteristics, distribution of alumina sol, mi-crostructure and mechanical properties of surface-modified alumina bubble were studied by SEM, XRD, Coulter LS Particle Size Analyzer and self-preparation experimental device for measurement of compressive resistance.

采用湿化学的方式引入铝胶对氧化铝空心球进行表面修饰改性；采用SEM、XRD、激光粒度仪和自制耐压装置研究铝胶分解特性、分布状态、氧化铝空心球表面改性前后显微结构及力学强度变化。

It is formed of alternating layers of aluminium oxide and sodium ions. In 1967 researchers at the Ford Motor Company discovered that it conducts these ions as though it were a liquid.

钠β-氧化铝是由氧化铝和钠离子的交替层组成。1967年，福特汽车公司的研究人员发现，这些导电的离子好像是液体一样。

The regularization of pore structures, the unrough original aluminium flakes were use d and

列结构阳极氧化铝模板的工艺，并掌握控制理想有序氧化铝模板周期结构尺寸的方法

According to different assession theories, different experimental results can be given possible explanations

在较粗的晶粒范围内，大晶粒的氧化铝陶瓷具有较好的抗热震性，而在较细的晶粒范围内，小晶粒的氧化铝陶瓷具有较好的抗热震性

The main results are as follows: 1 Taking advantage of the porosity and being carrier of anodic alumina, we reported the luminescence of Eu , dye Ru L〓X〓 Ru (Ⅱ(4, 4'-dicarboxyl-2, 2'-bipyridyl)〓〓, and silica gel film anchored porous anodic alumina prepared by self-assembling and deposition.

主要内容如下： 1 利用多孔氧化铝非常高的孔隙率以及它作为载体的优点，采用自组装及沉积的方法将稀土Eu离子、凝胶和有机染料镶嵌于其中，研究了多孔氧化铝复合材料的光致发光。

In order to improve thermal efficiency of gaseous suspension calciner ,after calculating and analyzing the heat balance,the result shows that:the main factors of influence of output and energy utilization of furnace are air surplus coefficient,aluminium hydroxide moisture and temperature of the main furnace.

为进一步提高气体悬浮焙烧炉的热效率，对某厂氧化铝焙烧系统进行了热工测试和热平衡计算，分析结果发现，影响焙烧产量和能耗的主要因素为空气过剩系数、氢氧化铝水分和主炉温度。

In order to improve thermal efficiency of gaseous suspension calciner ,after calculating and analyzing the heat balance,the result shows that:the main factors of influence of output and energy utilization of furnace are air surplus coefficient,aluminium hydroxide moisture and temperature of the main furnace.

为进一步提高气体悬浮焙烧炉的热效率，对某厂氧化铝焙烧系统进行热工测试和热平衡计算，分析结果发现，影响焙烧产量和能耗的主要因素为空气过剩系数、氢氧化铝水分、主炉温度。

Template-confined growth is a very powerful method for obtaining aligned 1D nanomaterials with adjustable diameter, length and morphology. Porous anodic aluminum oxide templates with different channel structures have been synthesized in our lab, with which the aligned CNT arrays, Y-branching and novel dendriform CNTs have been obtained. Based on the structural characterization of the products, a space-limited and self-catalytic growth mechanism has been proposed accordingly. Roughly speaking, the catalyst particles at the bottom of template channels initiate the nucleation of carbon species, which acts as the seed for subsequent CNT growth.

本文采用近年发展起来的模板控制生长法，以多孔氧化铝模板控制CVD生长的方法调控了碳纳米管有序阵列、γ-分叉及树枝状分叉结构，在对产物进行详尽结构表征和分析的基础上阐述了氧化铝模板控制生长碳纳米管的生长机制：孔道内催化剂仅在生长初始阶段催化碳物种的成核，起&种子&作用，随后模板孔道自身的催化及限域作用使碳纳米管紧贴着孔道内壁生长。

Do you know, i need you to come back

你知道吗，我需要你回来

Yang yinshu、Wang xiangsheng、Li decang,The first discovery of haemaphysalis conicinna.

1〕 杨银书，王祥生，李德昌。安徽省首次发现嗜群血蜱。