氧化铝

Metal industry: treatment equipment of Pell mina, deviling and pickling in wire stretching and steel rolling; deviling and pickling treatment before vehicle painting; the production of titanium oxide and rare earth elements and etc

金属工业：氧化铝膜处理设备；线材拉伸、钢铁轧制中除油及酸洗；车辆喷漆前除油及酸洗处理；氧化钛、稀土元素的生产等。

In addition, we also discussed the effect of the granularities of the powders and the added phases on the mechanical properties of the alumina-based diphase ceramics.

另外本文还讨论了原料粉末的起始粒度和添加相对氧化铝基复相陶瓷的影响。

There were many researches on Al2O3-based diphase ceramics, but few of them focused on the methods of the fracture toughness measurement of alumina-based diphase ceramics.

见于报道的Al_2O_3基复相陶瓷的研究虽多，但是关注于氧化铝基复相陶瓷断裂韧性测试方法上的研究却并不多见。

A highly ordered copper phthalocyanine-3,4',4",4"'-tetrasulfonic acid, tetrasodium salt/4,4'-dipyridyl dihydrochloride nanotube array was successfully fabricated by the layer-by-layer self-assembly technique using micropore anodic aluminum oxide as templates. The assembly process of the nanotube array was investigated by UV-Vis spectrometry, XRD and FT-IR, and the morphology of the nanotubes was analyzed by scanning electron microscopy and transmission electron microscopy, respectively.

在阳极多孔氧化铝模板中利用层层自组装技术制备出了高度有序的聚电解质磺化酞菁铜/4，4′-联吡啶盐酸盐纳米管，并对其组装过程用UV-Vis， XRD和FT-IR进行了分析，纳米管的微观形貌通过SEM和TEM进行表征。

The main radiation cavity of the furnace consists of a high-purity alumina tube 25cm long x7cmi.d., heated by molybdenum disilicide elements.

加热炉里的主要辐射腔是一条内直径7公分，长25公分的高纯度氧化铝管，由二硅化钼元素加热。

The main radiation cavity of the furnace consists of a high-purity alumina tube 25cm long x7cmi.d., heated by Molybdenum rod disilicide elements.

加热炉里的主要辐射腔是一条内直径7公分，长25公分的高纯度氧化铝管，由二硅化钼元素加热。

The simple and available sch eme for AH wash liquor process change was also proposed.

并提出了简单可行的氢氧化铝洗液流程改造的具体方案。

In the highheating rates, Al nanopowders were heated above 560℃rapidly, and then the oxidize shellcracked and combusted due to the fusion of the core part Al. This oxidation process wasacute, and had only one phenomenon of exothermal and mass gain.

在高加热速率下，纳米铝粉温度迅速被加热到560℃以上，芯部的铝熔化造成氧化铝壳层的破裂燃烧，氧化反应剧烈，仅有一次放热和质量增重现象。

The size of ·nm,·nm,·0nm, 0· nm or 0·00nm spheric or fibrillar α-or γ-AlO can be obtained by the thermal treatment of 70℃/ h、 800℃/h、 900℃/h、 90℃/h and 000℃/h , respectively.

在70℃／ h、800℃／h、900℃／h、 90℃／h和000℃／h随炉冷却工艺条件下，分别得到粒径为-nm、-0nm、0-nm和0-00nm的纤维状或球状、α相或γ相的纳米氧化铝粒子。

Two different approaches are adopted to prepare electrocatalyst supports, which are anodic aluminum oxide templated nanostructured materials and nanoporous graphitic carbon.

制备触媒载体采用两个不同的方法，分别为奈米结构材料阳极氧化铝模板以及奈米孔洞的石墨化碳。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。