氧化钛

The effects of synthesis temperature on the lattice parameter,the crystallite size and the content of CO2-3 of the prepared samples,the effects of the concentration of reactants on the particle size and morphology,and the effects of the molar ratio of barium hydroxide to tetrabutyl titanate on the molar ratio of bar...

研究了合成温度对样品的晶胞参数、晶粒大小和CO32-含量的影响；反应物浓度对样品的颗粒大小和形貌的影响；氢氧化钡与钛酸四丁酯的摩尔比对样品中钡钛摩尔比的影响。

The barium titanate power with size 60~90 nm was prepared at 200~280℃×4h, using barium hydroxide and titanium tetrarchloride as the resources of Ba and Ti, ammonia as mineralization reagent.

采用氢氧化钡和四氯化钛作为钡源和钛源，氨水作矿化剂，在200~280℃保温4h条件T合成粒径为60~90nm钛酸钡粉体。

Barium strontium titanate nanoparticles were successfully prepared by the low temperature (300-500℃) calcination method, using barium hydroxide, strontium hydroxide, and tetrabutyl titanate as starting materials.

以氢氧化钡、氢氧化锶和钛酸丁酯为原料，采用低温煅烧(300~500℃)法合成了钛酸锶钡纳米粒子。

Recent developments in the synthesis,modification and catalytic properties of titanium silicalite molecular sieve are reviewed,including the developments in the synthesis of TS-1 with hydrothermal and isomorphous replacement methods,the modification of TS-1,as well as applications in catalytic oxidation and acid catalysis systems.

本文重点综述了近年来钛硅分子筛催化材料的合成、改性及其催化应用的研究进展，包括钛硅分子筛（TS-1）的水热合成方法和同晶取代合成法、改性、成型与负载以及钛硅分子筛催化氧化功能和酸催化功能的研究。

Through lots of tests, the new technology of preparing the polymeric ferric aluminum silicate sulfate by using the waste-acid of Ti02-industriy and the coal fly ash has been designed. The highest Al-acid stripping rate can be achieved by the waste sulfate acid under boiling degree for 1. 5h when the mass ratio between NaCl and Coal Fly ash is 0. 05:1, as well as that between Coal Fly ash and Waste Acid ratio is 1:10. By means of the oxidation-polymerized reaction under 40-50*C and normal pressure, using NaNCkas catalyst and air as oxidation, the polymeric ferric aluminum sulfate can be obtained. The poly-silicic acid is polymerized with soluble glass in the optimum conditions of pH=5-6 and the concentration of Si02 is about 3%. The inorganic high molecule coagulant of PFASS is synthesized with the poly-silicic acid into the solution of polymeric ferric aluminum sulfate.

本论文通过大量的试验，研究开发出了用粉煤灰及钛白废酸制取聚合硫酸硅酸铁铝的新工艺，其最佳工艺条件为：于沸点温度，以NaCl为助溶剂(NaCl与粉煤灰质量比为0.05：1)，以钛白废酸浸取粉煤灰(固液比为1：10)中的铝1.5小时，最大浸取率可达40％；经过滤洗涤后，调节滤液pH至2.0左右，以NANO_2为催化剂(NaNO_2用量为滤液中FeSO_4·7H_2O量的3％)，空气为氧化剂，于40-50℃进行常压催化氧化反应，制取聚合硫酸铁铝，催化氧化时间为2小时；将工业水玻璃稀释至3％左右，调节其pH于5-6，室温下制备活性聚硅酸；将活性聚硅酸与聚合硫酸铁铝按照一定比例复合，经熟化，即制得新型无机高分子混凝剂PFASS。

Results The average thickness of MAO film was 32.7μm and the films presented alveolate pores with diameter from several micrometers to a hundred micrometers, under SEM.

结果纯钛表面微弧氧化膜的平均厚度为32.7μm，表面存在大量直径3-20μm的蜂窝状孔隙，纯钛微弧氧化膜中富含钙、磷成分，并且出现羟基磷灰石结晶。

The coatings, which had gradient structure of porously outer layer and densely inner layer, were mainly composed of rutile and anatase, and the elements of calcium and phosphorus existed in the form of perovskite, calcium phosphate and amorphous phosphates.

氧化膜与基体结合紧密(64.5±2.2)MPa，表层氧化膜明显可见许多胞状孔穴凹陷，疏松多孔，靠近钛基体的较表层致密，而且表面主要有晶红石，锐钛矿存在，具有较高的表面能。

The influences of conditions, such as the different elements in A site, reaction temperature and the reoxidation time etc.on partial catalytic oxidation of AFeO 3 catalyst are reviewed. The results show that the lattice oxygen from AFeO 3 pervoskite catalyst in A site occupied ...

结果表明，稀土金属(La ，Nd ，Sm ，Eu)占据A位的AFeO3钙钛矿型催化剂中的晶格氧适于甲烷选择性氧化制合成气，在完全氧化的LaFeO3催化剂上存在少量的强氧化性氧物种，通过控制再氧化条件，可使CH4 在LaFeO3催化剂的作用下，高转化率(～ 92 %)、高选择性(96 %)地生成合成气。

A method of increasing the lifetime of a hydro-oxidation catalyst comprising, preferably, gold, silver, or mixtures thereof, and optionally one or more promoters, on a titanium-containing support, such as a titanosilicate or titanium dispersed on silica.

一种延长加氢-氧化催化剂寿命期的方法，该催化剂在比如硅钛酸盐或分散在氧化硅上的钛的上面优选含有金、银或它们的混合物，以及任选的一种或几种促进剂。

When used in superabrasive grits synthesizing, especially in the case of cubic boron nitride, the consumption of anvils can be decreased effectively; and the quality and yield of CBN can he improved.

在超硬材料合成中，尤其是立方氮化硼合成中，能有效降低锤耗，同时可提高立方氮化硼的合成品质及产量；超硬材料表面镀钛及钛合金后，能实现镀层和结合剂的冶金结合，工具寿命提高30%以上；钛对许多氧化物质和还原物质具有极好的耐腐蚀性，适用于人造金刚石的批量电解提纯工序。

It has been put forward that there exists single Ball point and double Ball points on the symmetrical connecting-rod curves of equilateral mechanisms.

从鲍尔点的形成原理出发，分析对称连杆曲线上鲍尔点的产生条件，提出等边机构的对称连杆曲线上有单鲍尔点和双鲍尔点。

The factory affiliated to the Group primarily manufactures multiple-purpose pincers, baking kits, knives, scissors, kitchenware, gardening tools and beauty care kits as well as other hardware tools, the annual production value of which reaches US$ 30 million dollars.

集团所属工厂主要生产多用钳、烤具、刀具、剪刀、厨具、花园工具、美容套等五金产品，年生产总值3000万美元，产品价廉物美、选料上乘、质量保证，深受国内外客户的青睐