氧化过程

Aluminum oxide is grown out of the surface during anodizing and then becomes aluminum hydrate that is extremely hard.

铝的氧化过程是在从其表面开始逐步向内深入，然后形成极其坚硬的氢氧化铝。

Anoxia resulting from defective oxygenation of the blood in the lungs.

由于血液中的氧化过程有缺陷而导致的缺氧。

The molecular structure of ascorbic acid is actually easily oxidized during digestion.

的分子结构抗坏血酸实际上是氧化过程中容易消化。

A two-scale k-ε turbulence model was adopted to calculate turbulent velocity field, and the probability density function method was combined with the Lagrangian flamelet model to predict the turbulent scalar fields.Detailed chemical reaction mechanism GRI-Mech 3.0 was incorporated to describe methane oxidation and nitrogen oxides formation.

采用一个双尺度的 k-ε湍流模型计算速度场，将概率密度函数方法和Lagrangian火焰面模型相结合求解标量场，燃料甲烷的氧化过程和氮氧化物的生成过程采用详细的GRI-Mech 3.0机理描述。

The temperature of oxidation process is controlled at about 90 degree centigrade while its about 50℃in the process of hydrolytic polymerization.

氧化过程温度控制在90℃左右，水解聚合过程温度控制在50℃左右。

The microstructure and thermal physical properties of the surface reactional layer determine the range of strength improvement.Stress relaxation was benifical for strength,but the oxidation-induced bubbles and crack weaken the specimens.

热处理引起的应力松弛也有利于材料强度的提高，但氧化过程中产生的表面气孔及冷却过程中产生的表面微裂纹会引起材料强度的下降。

The NaIO4 oxidation has been employed in the process of changing the adjacent hydroxyl to aldehyde group. It was showed that through repeat cross-link, the lipase density on the carrier surface was enhanced about 30%.

通过醛基被交联程度来评价交联过程的优劣：首先对纤维的氧化过程进行了简单优化，进而通过反复交联法与酶蛋白交联。

The crystallinity of wet-spinning PAN precursor fibers gradually reduces during preoxidation process, while it gradually increases during carbonization process.

湿纺PAN原丝的结晶度在预氧化过程中逐渐降低，在碳化过程中随着碳化温度的升高逐渐增加。

The results show that α-Al2O3 in the two kind s of coatings decreases while the γ-Al2O3 increases after spraying. Rutile-TiO2 transforms to brookite-TiO2 and the inners tress of coating was increased so as to aggravate the expansion of cracking. The pores are small but dense in the conventional coating while bigger but loose in the nano-structured coating. The pores in the nano-structured coating exist almost inside the partially melted region. The pores generated during spraying and the cracks generated during the course of thermal oxidization because of thermal stress are the direct reasons why coatings fail.

结果表明：2种粉末在喷涂之后，涂层中的α-A12O3均有所减少，生成了γ-Al2O3，金红石TiO2相转变成了板钛矿型TiO2相，增加了涂层的内应力，加剧了裂纹的扩展；常规微米涂层中的孔洞细小但密集，纳米涂层中的孔洞较大但不密集，且大部分的气孔都存在于部分熔化区的内部；涂层在喷涂过程中所生成的气孔以及热氧化过程中由于热应力而产生的裂纹是造成涂层失效的直接原因。

It prepared with pure leaves and undergone little oxidisation during processing.

绿茶在生产过程中是纯叶质并且基本不经历氧化过程。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。