气鼓的

According to these experimental results quantitative models for foam drayage and relationship among superficial gas velocity, gas hold-up in bubble zone and surfactant concentration were obtained.

并在此基础上，由实验结果得到了关于泡沫排液的定量模型，以及鼓泡区内气含率、空塔气速、溶液表面活性剂浓度等参数之间的定量关系。

With his/her application a summary of his/her past experience. This should include the locations, types of gasholder, the

申请获认可为储气鼓内部检验「胜任人士」的申请人，必须随申请书附上有关其过往经验的简介，内容应包括

Due to AACs unique cell structure and absorbing water propriety, However, There are still many problems, when we adopt ordinary mortar to construct and plasterer ash, such as wall crack, big area of layer of plasterer ash crack and partially hollow drum, even according to present AAC technical specifications, for the actual operation craft is so complicated that It is very to guarantee each preface quality.

然而，由于加气混凝土本身特有的多孔结构和吸水特性，采用普通砂浆砌筑与抹灰，即使按现行加气混凝土砌块施工规定的方法施工，由于实际操作工艺复杂，各工序质量难以保证，依然有墙体开裂，抹灰层大面积龟裂和局部起鼓、空壳、脱落等现象。

In the present paper,the nonlinear behaviors of the chaotic bubbling from a 4-pipr gas sparger in a shallow bubble column s with three different high diameter ratios of one to three was studied.

鼓泡塔不同区域的奇怪吸引子结果表明：对于H/D≤3的气相多管分布的浅层鼓泡塔，沿轴向可区分为下部气泡分裂区、中部分裂与凝并过渡区和上部分裂凝并平衡区。

According to this investigation based on absorption of CO〓 with dilute Na〓CO〓 solution in tubes with K-type and H-type static mixing elements, an external loop ALR with K-type static mixing elements was constructed and tested in the pilot scale as the reactor for replacing the traditional carbonating tower of chemical plant.

在实验室对K型、H型和O型反应器进行了稀纯碱溶液吸收混合气中的二氧化碳的研究基础上，又在工厂进行了K型气升式外环流反应器用于氨水吸收混合气中的二氧化碳生产碳酸氢铵的实验，以取代现在普遍使用的鼓泡式碳化塔。

Solvents are normally degassed before pumping by sparging with helium, sonication or using on-line membrane/vacuum modules to avoid the creation of gas bubbles in the detector cell.

溶剂被抽之前，通常用氦气鼓泡，超声波或使用再线膜/真空组件来去除气体，以避免检测池中气泡的产生。

Key introduces the CT-121 bubble type spraying tower haze desulphurization craftCT-121 uses the limestone - gypsum (it is in the present world is maturest, most economical, applies broadest desulphurization craft) the aqueous method desulphurization craftIt the sulphur dioxide absorption, the oxidation, neutral, technological processes and so on crystallization as well as dust removal merges to an independent gas - fluid - solid phase reactor in carries onIt the sulphur dioxide absorption, the oxidation, neutral, technological processes and so on crystallization as well as dust removal merges to an independent gas - fluid - solid phase reactor in carries on

与传统的石灰石-石膏湿法烟气脱硫工艺相比，CT-121最大的特点在于鼓泡式吸收塔。它将二氧化硫的吸收、氧化、中和、结晶以及除尘等工艺过程合并到一个单独的气-液-固相反应器中进行。气体进入喷射管，喷射成无数小气泡，形成鼓泡区，从而大大增加了传质面积，提高了脱硫效率。CT-121脱硫工艺能够达到95%以上稳定连续的脱硫率，最低10 以下的粉尘排放率以及优异的可靠性和实用性。问题补充：谁再帮忙给篇，石灰石-石膏湿法烟气脱硫方面的论文文献，谢谢了中英文版的，谢谢了555

Compare the data structures of pressure fluctuation signals and AE signals both sampled in gas-solid fluidized bed, and the difference of data structures among AE signals sampled in gas-solid fluidized bed, pneumatic transport tube, slurry bubble column, liquid-solid loop reactor, and liquid-solid stirred tank. Based on the compare, the corresponding relation between signal structure and physical multi-scales was established.

通过对气固流化床的声发射信号与压力脉动信号的结构比较，以及气固流化床、气力输送、气液固淤浆鼓泡床、液固环管及液固搅拌釜中声发射信号多尺度结构差异比较，建立了多相流体系随机信号多尺度结构与物理多尺度的对应关系，认为在有固体颗粒存在的多相流体系，微尺度信号代表了颗粒相对于主体流动的运动状态；介尺度代表主体流相对于系统的运动或者不同主体流之间的相互运动；宏尺度则反映整个系统状态随时间的变化。3。

By analyzing, the author regards that work liquid characteristic is the main factor that impacts the aeration performance of the jet aerators.

为了全面的对两种工艺进行对比分析，还以一处生活污水处理厂为场地，测定了鼓风曝气系统的充氧性能。

The flow characteristic of gas-solid bubbling fluidized-bed was simulated based on two-fluid model by using Fluent.

在双流体模型的基础上利用计算流体力学软件对气固鼓泡流化床的流动特性进行了模拟，得到了鼓泡流化床的一种流动形式。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。